TLV2254ID ,Quad Rail-To-Rail Low-Voltage Low Power Operational Amplifier
TLV2262A ,Advanced LinCMOS(TM) Rail-To-Rail Dual Operational Amplifier SLOS186C − FEBRUARY 1997 − REV ..
TLV2262AIDR ,Advanced LinCMOS(TM) Rail-To-Rail Dual Operational Amplifier SLOS186C − FEBRUARY 1997 − REV ..
TLV2262AIP ,Advanced LinCMOS(TM) Rail-To-Rail Dual Operational Amplifier.TLV2264 AVAILABLE OPTIONSPACKAGED DEVICESV maxSMALL CHIP CERAMIC PLASTIC CERAMICIOTTSSOPAAT 25°C O ..
TLV2262AIPW ,Advanced LinCMOS(TM) Rail-To-Rail Dual Operational Amplifier.TLV2264 AVAILABLE OPTIONSPACKAGED DEVICESV maxSMALL CHIP CERAMIC PLASTIC CERAMICIOTTSSOPAAT 25°C O ..
TLV2262AIPWR ,Advanced LinCMOS(TM) Rail-To-Rail Dual Operational Amplifier SLOS186C − FEBRUARY 1997 − REV ..
TMS34020AGBL-32 ,Graphics Processors 145-CPGA 0 to 70
TMS34020AGBL-40 ,Graphics Processors 145-CPGA 0 to 70
TMS3637P ,Remote Control Transmitter/Receiver
TMS3705 ,LF Reader IC 16-SOIC -40 to 85Features1• Base Station IC for TI-RFid™ RF Identification • Short-Circuit ProtectionSystems• Diagno ..
TMS3705A , RADIO FREQUENCY I DENTIFICATION SYSTEMS
TMS3705A1DRG4 ,LF Reader IC 16-SOIC -40 to 85block diagram.VDDSCIDigital DemodulatorEncoderLimiter DiagnosisTransponderA_TSTResonance-FrequencyS ..
TLV2254ID
Quad Rail-To-Rail Low-Voltage Low Power Operational Amplifier
Split-Supply Operation Very Low Power ...34 µA Per Channel Typ Common-Mode Input Voltage Range
Includes Negative Rail Available in Q-Temp Automotive
HighRel Automotive Applications
Configuration Control / Print Support
Qualification to Automotive Standards
descriptionThe TLV2252 and TLV2254 are dual and
quadruple low-voltage operational amplifiers from
Texas Instruments. Both devices exhibit rail-to-rail
output performance for increased dynamic range
in single- or split-supply applications. The
TLV225x family consumes only 34 µA of supply
current per channel. This micropower operation
makes them good choices for battery-powered
applications. This family is fully characterized at
3 V and 5 V and is optimized for low-voltage
applications. The noise performance has been
dramatically improved over previous generations
of CMOS amplifiers. The TLV225x has a noise
level of 19 nV/√Hz at 1kHz, four times lower than
competitive micropower solutions.
The TLV225x, exhibiting high input impedance
and low noise, are excellent for small-signal
conditioning for high-impedance sources, such as
piezoelectric transducers. Because of the micro-
power dissipation levels combined with 3-V
operation, these devices work well in hand-held
monitoring and remote-sensing applications. In
addition, the rail-to-rail output feature with single or split supplies makes this family a great choice when
interfacing with analog-to-digital converters (ADCs). For precision applications, the TLV225xA family is
available and has a maximum input offset voltage of 850 µV.
The TLV2252/4 also make great upgrades to the TLV2322/4 in standard designs. They offer increased output
dynamic range, lower noise voltage, and lower input offset voltage. This enhanced feature set allows them to
be used in a wider range of applications. For applications that require higher output drive and wider input voltage
range, see the TLV2432 and TLV2442 devices. If your design requires single amplifiers, please see the
TLV2211/21/31 family. These devices are single rail-to-rail operational amplifiers in the SOT-23 package. Their
small size and low power consumption, make them ideal for high density, battery-powered equipment.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Figure 1
− High-Level Output V
ltage − V
HIGH-LEVEL OUTPUT VOLTAGE
HIGH-LEVEL OUTPUT CURRENT
| IOH | − High-Level Output Current − µA
1.5 200 400
600 800
0.5
