TL082BC-TL082C-TL082CP-TL082I Fast Delivery |IC PHOENIX CO.,LIMITED

TL082C ,Amplifiers and ComparatorsTL082TL082A - TL082BGENERAL PURPOSE J-FETDUAL OPERATIONAL AMPLIFIERS+n WIDE COMMON-MODE (UP TO V ) ..
TL082CD ,JFET INPUT OPERATIONAL AMPLIFIERSTL082TL082A - TL082BGENERAL PURPOSE J-FET DUAL OPERATIONAL AMPLIFIERS+ ■ WIDE COMMON-MODE (UP TO V ..
TL082CDG4 ,JFET-Input Operational Amplifier 8-SOIC 0 to 70Maximum Ratings . 510 Power Supply Recommendations... 186.2 ESD Ratings........ 511 Layout.... 186. ..
TL082CDR ,Dual JFET-Input General-Purpose Operational AmplifierMaximum Ratings . 510 Power Supply Recommendations... 186.2 ESD Ratings........ 511 Layout.... 186. ..
TL082CDR2 ,JFET Input Operational AmplifierOrder this document by TL081C/D* ** These low–cost JFET input operational amplifiers combine two st ..
TL082CDRG4 ,JFET-Input Operational Amplifier 8-SOIC 0 to 70Table of Contents8.2 Functional
TLV2401CD ,Single MicroPower, RRIO Operational Amplifier with wide supply voltage range and high CMRRelectrical characteristics specified at 2.7 V, 5 V and 15 V. The 2.5-V operation makes it compatibl ..
TLV2401CDBVR ,Single MicroPower, RRIO Operational Amplifier with wide supply voltage range and high CMRRmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
TLV2401CDBVRG4 ,Single MicroPower, RRIO Operational Amplifier with wide supply voltage range and high CMRRmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
TLV2401CDBVTG4 ,Single MicroPower, RRIO Operational Amplifier with wide supply voltage range and high CMRR 5-SOT-23 0 to 70TLV2401, TLV2402, TLV2404FAMILY OF 880-nA/Ch RAIL-TO-RAIL INPUT/OUTPUTOPERATIONAL AMPLIFIERS WITH R ..
TLV2401ID ,Single MicroPower, RRIO Operational Amplifier with wide supply voltage range and high CMRRelectrical characteristics specified at 2.7 V, 5 V and 15 V. The 2.5-V operation makes it compatibl ..
TLV2401IDBVRG4 ,Single MicroPower, RRIO Operational Amplifier with wide supply voltage range and high CMRRmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..

TL082BC-TL082C-TL082CP-TL082I
GENERAL PURPOSE J-FET DUAL OPERATIONAL AMPLIFIERS
WIDE COMMON-MODE (UP TO VCC+) ANDDIFFERENTIAL VOLTAGE RANGE LOW INPUT BIAS AND OFFSET CURRENT OUTPUT SHORT-CIRCUIT PROTECTION HIGH INPUT IMPEDANCE J–FET INPUT
STAGE INTERNAL FREQUENCY COMPENSATION LATCH UP FREE OPERATION HIGH SLEW RATE: 16V/μs (typ)
DESCRIPTION
The TL082, TL082A and TL082B are high speed
J–FET input dual operational amplifiers incorpo-
rating well matched, high voltage J–FET and bipo-
lar transistorsina monolithic integrated circuit.
The devices feature high slew rates, low input bias
and offset current, and low offset voltage temper-
ature coefficient.
ORDER CODE Dualin Line Package (DIP)D= Small Outline Package (SO)-also availablein Tape& Reel (DT) Thin Shrink Small Outline Package (TSSOP)-only availablein Tape& Reel (PT)
PIN CONNECTIONS (top view)
Part Number Temperature
Range
Package P
TL082M/AM/BM -55°C, +125°C •• •
TL082I/AI/BI -40°C, +105°C •• •
TL082C/AC/BC 0°C, +70°C •• •
Example: TL082CD, TL082IN
DIP8
(Plastic Package)
SO8
(Plastic Micropackage)
TSSOP8
(Thin Shrink Small Outline Package) -- Offset null1- Inverting input1- Non-inverting input1VCC-- Non-inverting input2- Inverting input2- Output2 VCC+
TL082
TL082A- TL082B
GENERAL PURPOSE J-FET
DUAL OPERATIONAL AMPLIFIERS
TL082- TL082A- TL082B
SCHEMATIC DIAGRAM
ABSOLUTE MAXIMUM RATINGS
Symbol Parameter TL082M, AM, BM TL082I,AI,BI TL082C, AC,BC UnitCC Supply voltage- note1) All voltage values, except differential voltage,arewith respecttothe zero reference level (ground)ofthe supply voltages wherethe zero referencelevelisthe midpoint betweenVCC+andVCC-.
±18 V Input Voltage- note2) The magnitudeofthe input voltage must never exceedthe magnitudeofthe supply voltageor15 volts, whichever isless.
±15 V
Vid Differential Input Voltage- note3) Differential voltagesarethe non-inverting input terminal with respecttothe inverting input terminal.
±30 V
Ptot Power Dissipation 680 mW
Output Short-circuit Duration- note4) The output maybe shortedto groundorto either supply. Temperature and/or supply voltages mustbe limitedto ensurethatthe dissipation ratingisnot exceeded
Infinite
Toper Operating Free-air Temperature Range -55to +125 -40to +105 0to +70 °C
Tstg Storage Temperature Range -65to +150 °C
Output
Non-inverting
input
Inverting
input
VCC
VCC
200ΩΩ100100
1.3k
1/2 TL08230k
35k 35k Ω1001.3k
8.2k
TL082- TL082A- TL082B
ELECTRICAL CHARACTERISTICS
VCC= ±15V, Tamb= +25°C (unless otherwise specified)
Symbol Parameter
TL082I,M,AC,AI,AM,
BC,BI,BM TL082C
Unit
Min. Typ. Max. Min. Typ. Max.
Vio
Input Offset Voltage (Rs= 50Ω)
Tamb= +25°C TL082
TL082A
TL082B
Tmin≤ Tamb≤ Tmax TL082
TL082A
TL082B
310io Input Offset Voltage Drift 10 10 μV/°Cio
Input Offset Current- note1)
Tamb= +25°C
Tmin≤ Tamb≤ Tmax
5100 100ib
Input Bias Current -note1
Tamb= +25°C
Tmin≤ Tamb≤ Tmax 200 400
Avd
Large Signal VoltageGain (RL =2kΩ,Vo= ±10V)
Tamb= +25°C
Tmin≤ Tamb≤ Tmax
200 25
V/mV
SVR
Supply Voltage Rejection Ratio (RS= 50Ω)
Tamb= +25°C
Tmin≤ Tamb≤ Tmax 70
ICC
Supply Current,no load
Tamb= +25°Cmin≤Tamb≤Tmax
1.4 2.5
1.4 2.5
Vicm Input Common Mode Voltage Range ±11 +15
±11 +15
CMR
Common ModeRejection Ratio (RS= 50Ω)
Tamb= +25°C
Tmin≤ Tamb≤ Tmax 70
Ios
Output Short-circuit Currentamb= +25°C
Tmin≤ Tamb≤ Tmax 60 60
±Vopp
Output Voltage Swing
Tamb= +25°CRL= 2kΩ= 10kΩmin≤Tamb≤Tmax RL= 2kΩ= 10kΩ
13.5 Slew Rate (Tamb= +25°C)
Vin= 10V,RL =2kΩ,CL= 100pF, unity gain 8 16 8 16
V/μs Rise Time (Tamb= +25°C)
Vin= 20mV,RL =2kΩ,CL= 100pF,unity gain 0.1 0.1
Kov Overshoot (Tamb= +25°C)
Vin= 20mV,RL =2kΩ,CL= 100pF,unity gain 10 10
GBP Gain Bandwidth Product (Tamb= +25°C)
Vin= 10mV,RL =2kΩ,CL= 100pF,f= 100kHz 2.5 4 2.5 4
MHz Input Resistance 1012 1012 Ω
TL082- TL082A- TL082B
THD
Total Harmonic Distortion (Tamb= +25°C), 1kHz,RL =2kΩ,CL= 100pF,Av= 20dB, =2Vpp 0.01 0.01 Equivalent Input Noise Voltage= 100Ω,f= 1KHz 15 15 Phase Margin 45 45 degrees
Vo1/Vo2 Channel Separation= 100 120 120 dB The input bias currentsare junction leakage currents which approximately doublefor every 10°C increaseinthe junction temperature.
Symbol Parameter
TL082I,M,AC,AI,AM,
BC,BI,BM TL082C
Unit
Min. Typ. Max. Min. Typ. Max.----------
TL082- TL082A- TL082B
MAXIMUM PEAK-TO-PEAK OUTPUT
VOLTAGE versus FREQUENCY
MAXIMUM PEAK-TO-PEAK OUTPUT
VOLTAGE versus FREQUENCY
MAXIMUM PEAK-TO-PEAK OUTPUT
VOLTAGE versus LOAD RESISTANCE
MAXIMUM PEAK-TO-PEAK OUTPUT
VOLTAGE versus FREQUENCY
MAXIMUM PEAK-TO-PEAK OUTPUT
VOLTAGE versus FREE AIR TEMP.
MAXIMUM PEAK-TO-PEAK OUTPUT
VOLTAGE versus SUPPLY VOLTAGE 4 68 10 12 14 16
MAXIMUM
PEAK-TO-PEAK
OUTPUT
VOLTAGE
(V)=10kΩamb= +25°C
SUPPLY VOLTAGE( V)
TL082- TL082A- TL082B
INPUT BIAS CURRENT versus FREE AIR
TEMPERATURE
LARGE SIGNAL DIFFERENTIAL VOLTAGE
AMPLIFICATION AND PHASE SHIFT versus
FREQUENCY
SUPPLY CURRENT PER AMPLIFIER versus
FREE AIR TEMPERATURE
LARGE SIGNAL DIFFERENTIAL VOLT AGE
AMPLIFICATION versus FREE AIR TEMP.
TOTALPOWER DISSIPATION versus FREE AIR
TEMPERATURE
SUPPLY CURRENT PER AMPLIFIER versus
SUPPLY VOLTAGE
INPUT
BIAS
CURRENT
(nA)
-50 -25 0 25 50 75 100 125
TEMPERATURE(°C)CC= 15V
FREQUENCY (Hz)
DIFFERENTIAL
VOLTAGE
AMPLIFICATION
(V/V)
100 1K 10K 100K 10M1M
DIFFERENTIAL
VOLTAGEAMPLIFICATION
(leftscale)
180 2kΩ = 100pF 15V = +125 C
amb
PHASE SHIFT
(rightscale)
SUPPLY
CURRENT
(mA)
-75 -50 -25 0 25 50 75 100 125
TEMPERATURE(°C)
VCC= 15V signalload
DIF
FERE
NTIA
VOL
TAG
MPLIFICAT
ION
(V/V)
-75 -50 -25 0 25 50 75 100 125
TEMPERATURE(°C)L=2kΩ= 10VCC= 15V
TOTAL
POWER
DISSIPATION
(mW)
-75 -50 -25 0 25 50 75 100 125
TEMPERATURE(°C)CC= 15V
Nosignal
Noload
SUPPLY
CURRENT
(mA) 6 8 10 12 14 16 signal
Noload +25°CTamb
SUPPLYVOLTAGE( V)

Partno	Mfg	Dc	Qty	Available	Descript
TL082BC	MOTO	N/a	20	avai	General purpose J-fet dual operational amplifier
TL082C	ST/TI	N/a	4233	avai	Amplifiers and Comparators
TL082CP	ST	N/a	940	avai	Wide Bandwidth Dual JFET Input Operational Amplifier
TL082I	TI	N/a	171	avai	General purpose J-fet dual operational amplifier