TL032ACDR ,Enhanced-JFET Low-Power Low-Offset Dual Operational Amplifier
TL032AIDR ,Enhanced-JFET Low-Power Low-Offset Dual Operational Amplifier
TL032CD ,Dual Enhanced JFET Low-Power Precision Operational Amplifier
TL032CPSR ,Dual Enhanced JFET Low-Power Precision Operational Amplifier
TL032CPSR ,Dual Enhanced JFET Low-Power Precision Operational Amplifier
TL032CPSRG4 , ENHANCED-JFET LOW-POWER LOW-OFFSET OPERATIONAL AMPLIFIERS
TLS251 , TLG251, TLY251, TLO251, TLS251
TLS336T ,LED DISPLAY
TLS337T ,LED DISPLAY
TLS346T ,LED DISPLAY
TLS347T ,LED DISPLAY
TLS362S ,LED DISPLAY
TL032ACDR-TL032AIDR
Enhanced-JFET Low-Power Low-Offset Dual Operational Amplifier
TL03x, TL03xA
ENHANCED-JFET LOW-POWER LOW-OFFSET
OPERATIONAL AMPLIFIERS
SLOS180C − FEBRUARY 1997 − REVISED DECEMBER 2001
Direct Upgrades for the TL06x Low-Power
BiFETs Low Power Consumption...
6.5 mW/Channel Typ On-Chip Offset-Voltage Trimming for
Improved DC Performance
(1.5 mV, TL031A) Higher Slew Rate and Bandwidth Without
Increased Power Consumption Available in TSSOP for Small Form-Factor
Designs
descriptionThe TL03x series of JFET-input operational amplifiers offer improved dc and ac characteristics over the TL06x
family of low-power BiFET operational amplifiers. On-chip zener trimming of offset voltage yields precision
grades as low as 1.5 mV (TL031A) for greater accuracy in dc-coupled applications. The Texas Instruments
improved BiFET process and optimized designs also yield improved bandwidths and slew rates without
increased power consumption. The TL03x devices are pin-compatible with the TL06x and can be used to
upgrade existing circuits or for optimal performance in new designs.
BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors without
sacrificing the output drive associated with bipolar amplifiers. This higher input impedance makes the TL3x
amplifiers better suited for interfacing with high-impedance sensors or very low-level ac signals. These devices
also feature inherently better ac response than bipolar or CMOS devices having comparable power
consumption.
The TL03x family has been optimized for micropower operation, while improving on the performance of the
TL06x series. Designers requiring significantly faster ac response should consider the Excalibur™ TLE206x
family of low-power BiFET operational amplifiers.
Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to
observe common-mode input-voltage limits and output swing when operating from a single supply. DC biasing
of the input signal is required, and loads should be terminated to a virtual-ground node at midsupply. The TI
TLE2426 integrated virtual-ground generator is useful when operating BiFET amplifiers from single supplies.
The TL03x devices are fully specified at ±15 V and ±5 V. For operation in low-voltage and/or single-supply
systems, the TI LinCMOS families of operational amplifiers (TLC prefix) are recommended. When moving from
BiFET to CMOS amplifiers, particular attention should be paid to slew rate, bandwidth requirements, and output
loading.
The C-suffix devices are characterized for operation from 0°C to 70°C. The I-suffix devices are characterized
for operation from −40°C to 85°C. The M-suffix devices are characterized for operation over the full military
temperature range of −55°C to 125°C.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
