TD62S352AFM ,1-Channel Darlington Source-Current DriverFeatures Ultra-small HSON6 package with heat sink on rear Large output voltage: V = −50 V (m ..
TD6308AP ,Auto Reverse & Auto Eject Plunger DriverFeatures Plunger driving output transistor is built in. No.6 pin output I = 200mA (V = 0.7V (m ..
TD6308AP ,Auto Reverse & Auto Eject Plunger DriverBlock Diagram Pin Description Pin No. Symbol Designation Function Program Terminal u ..
TD6337P ,10BIT SERIAL-INPUT/PARALLEL OUTPUT DRIVERTD6337PTD6227PThe TD6337P is an IC built using a Bi -CMOS processcharacterized by high output withs ..
TD6337P ,10BIT SERIAL-INPUT/PARALLEL OUTPUT DRIVERTD6337PTD6227PThe TD6337P is an IC built using a Bi -CMOS processcharacterized by high output withs ..
TD6347 ,CONVENTIONAL TIMERTD6347FvThe TD6347F is an automotive PL monolithic timer. It is a I IIong-term timer superior in vo ..
TE28F016B3B-120 , SMART 3 ADVANCED BOOT BLOCK BYTE-WIDE
TE28F016B3B90 , SMART 3 ADVANCED BOOT BLOCK 4-, 8-, 16-, 32-MBIT FLASH MEMORY FAMILY
TE28F016B3BA110 , SMART 3 ADVANCED BOOT BLOCK 4-, 8-, 16-, 32-MBIT FLASH MEMORY FAMILY
TE28F016B3BA-110 , SMART 3 ADVANCED BOOT BLOCK 4-, 8-, 16-, 32-MBIT FLASH MEMORY FAMILY
TE28F016B3BA90 , SMART 3 ADVANCED BOOT BLOCK 4-, 8-, 16-, 32-MBIT FLASH MEMORY FAMILY
TE28F016B3BA90 , SMART 3 ADVANCED BOOT BLOCK 4-, 8-, 16-, 32-MBIT FLASH MEMORY FAMILY
TD62S352AFM
1-Channel Darlington Source-Current Driver
TD62S352AFM
TOSHIBA Bipolar Digital Integrated Circuit Silicon Monolithic
TD62S352AFM 1-Channel Darlington Source-Current Driver
The TD62S352AFM is a 1-channel noninverting source-current
driver. The driver incorporates output clamp diodes used to clamp
the counter electromotive force which is generated when driving
an inductive load, and an input resistor which limits base current.
The driver is optimal for driving relays and LEDs. When using
the driver pay attention to the thermal conditions.
Features Ultra-small HSON6 package with heat sink on rear Large output voltage: VOUT = −50 V (min) Large output current: IOUT = −500 mA (max) Built-in input resistor: RIN = 10 kΩ Input signal: High Level Active Built-in output clamp diodes
Pin Connection (top view) Basic Circuit Diagram Note 1: Diodes shown using dotted lines are parasitic. Do not use them.
Note 2: When using the driver, connect the OUTPUT pin to the TEST pin.
Note 3: When using the driver, connect the P-GND pin to the heat sink on the rear of the package.
Weight: 0.017 g (typ.)
10 k�
VCC
TEST
OUTPUT
P-GND
INPUT
INPUT
P-GND
NC
OUTPUT
TEST
VCC
