STP2NC60 ,N-CHANNEL 600V 7 OHM 1.9A TO-220/TO-220FP POWERMESH II MOSFETABSOLUTE MAXIMUM RATINGSSymbol Parameter Value UnitSTP2NC60 STP2NC60FPV Drain-source Voltage (V = 0 ..
STP2NK100Z ,N-channel 1000 V, 6.25 Ohm, 1.85 A, TO-220 Zener-protected SuperMESH(TM) Power MOSFET
STP2NK60Z ,N-CHANNEL 600VFeatures Figure 1: PackageTYPE V R I PwDSS DS(on) DSTF2NK60Z 600 V < 8 Ω 1.4 A 20STQ2NK60ZR-AP 600 ..
STP2NK90Z ,N-CHANNEL 900VAbsolute Maximum ratingsSymbol Parameter Value UnitSTD2NK90ZSTP2NK90ZSTD2NK90Z-1V Drain-source Volt ..
STP3015L ,N-CHANNEL 30VELECTRICAL CHARACTERISTICS (T = 25 °C unless otherwise specified)caseOFFSymbol Parameter Test Condi ..
STP3020L , N - CHANNEL 30V - 0.019ohm - 40A - TO-220 STripFET POWER MOSFET
SZF2002HL ,Low voltage 8-bit microcontroller with 6-kbyte embedded RAM
T0-220 , Fit Rate / Equivalent Device Hours
T0-220 , Fit Rate / Equivalent Device Hours
T0790 ,700 MHz to 2700 MHz Direct Quadrature ModulatorBlock Diagram 16BBQ-1BBQ+4 13LO+ RF+0°12590°LO- RF-8BBI+9BBI-Rev. 4555C–SIGE–11/03Pin Configuration ..
T0800-PJQ ,5-CHANNEL LASER DRIVER WITH RF OSCILLATOR AND 2 OUTPUTSFeatures• Current-controlled Output Current Source with 5 Input Channels 2 Selectable Outputs for ..
T0806 ,3-channel laser driver with RF oscillator and 2 outputsApplications DVD-ROM with CD-RW Capability (Combo Drives)and 2 Outputs Combo Drives with CD and D ..
STP2NC60
N-CHANNEL 600V 7 OHM 1.9A TO-220/TO-220FP POWERMESH II MOSFET
1/9April 2001
STP2NC60
STP2NC60FPN-CHANNEL 600V - 7Ω - 1.9A - TO-220/TO-220FP
PowerMesh™II MOSFET TYPICAL RDS(on) = 7 Ω EXTREMELY HIGH dv/dt CAPABILITY 100% AVALANCHE TESTED NEW HIGH VOLTAGE BENCHMARK GATE CHARGE MINIMIZED
DESCRIPTIONThe PowerMESH™II is the evolution of the first
generation of MESH OVERLAY™. The layout re-
finements introduced greatly improve the Ron*area
figure of merit while keeping the device at the lead-
ing edge for what concerns swithing speed, gate
charge and ruggedness.
APPLICATIONS HIGH CURRENT, HIGH SPEED SWITCHING SWITH MODE POWER SUPPLIES (SMPS) DC-AC CONVERTERS FOR WELDING
EQUIPMENT AND UNINTERRUPTIBLE
POWER SUPPLIES AND MOTOR DRIVER
ABSOLUTE MAXIMUM RATINGS(•)Pulse width limited by safe operating area
(1)ISD ≤1.9A, di/dt ≤100A/μs, VDD ≤ V(BR)DSS, Tj ≤ TJMAX
(*) Limited only by Maximum Temperature Allowed
STP2NC60/STP2NC60FP
THERMAL DATA
AVALANCHE CHARACTERISTICS
ELECTRICAL CHARACTERISTICS (TCASE = 25 °C UNLESS OTHERWISE SPECIFIED)OFF (1)
DYNAMIC
3/9
STP2NC60/STP2NC60FP
Safe Operating Area for TO-220
ELECTRICAL CHARACTERISTICS (CONTINUED)SWITCHING ON
SWITCHING OFF
SOURCE DRAIN DIODE
Note:1. Pulsed: Pulse duration = 300 μs, duty cycle 1.5 %. Pulse width limited by safe operating area.
Safe Operating Area for TO-220FP
STP2NC60/STP2NC60FP
Thermal Impedance for TO-220FP
Transconductance Static Drain-source On Resistance
Output Characteristics Transfer Characteristics
Thermal Impedance for TO-220
5/9
STP2NC60/STP2NC60FP
Source-drain Diode Forward Characteristics
Normalized On Resistance vs TemperatureNormalized Gate Thereshold Voltage vs Temp.
Gate Charge vs Gate-source Voltage Capacitance Variations
STP2NC60/STP2NC60FP
Fig. 5: Test Circuit For Inductive Load Switching
Fig. 4: Gate Charge test Circuit
Fig. 3: Switching Times Test Circuit For Resistive Load
