SNJ54ACT245J ,Octal Bus Transceivers With 3-State Outputs SN54ACT245, SN74ACT245 OCTAL BUS TRANSCEIVERSWITH 3-STATE OUTPUTSSCAS452E – SEPTEMBER 1994 – REVIS ..
SNJ54ACT373J ,Octal D-type Transparent Latches With 3-State Outputs SN54ACT373, SN74ACT373 OCTAL D-TYPE TRANSPARENT LATCHESWITH 3-STATE OUTPUTSSCAS544E – OCTOBER 1995 ..
SNJ54ACT374FK ,Octal D-type Edge-Triggered Flip-Flops With 3-State OutputsSN54ACT374, SN74ACT374OCTAL D-TYPE EDGE-TRIGGERED FLIP-FLOPSWITH 3-STATE OUTPUTSSCAS539F − OCTOBER ..
SNJ54AHC02J ,Quadruple 2-Input Positive-NOR GatesELECTRICAL CHARACTERISTICSover operating free-air temperature range (unless otherwise noted)T = –55 ..
SNJ54AHC138FK ,3-Line To 8-Line Decoders/DemultiplexersSN54AHC138, SN74AHC1383-LINE TO 8-LINE DECODERS/DEMULTIPLEXERSSCLS258L − DECEMBER 1995 − REVISED JU ..
SNJ54AHC373W ,Octal-Transparent D-type Latches With 3-State Outputs SN54AHC373, SN74AHC373 OCTAL TRANSPARENT D-TYPE LATCHESWITH 3-STATE OUTPUTSSCLS235I – OCTOBER 1995 ..
SPX2920U-5.0 , 400mA Low Drop Out Voltage Regulator with Shutdown
SPX29302T5-L , 3A Guaranteed Output Current
SPX2940T-2.5 , 1A Low Dropout Voltage Regulator Fixed Output, Fast Response
SPX2940T-5.0 , 1A Low Dropout Voltage Regulator Fixed Output, Fast Response
SPX2941U5 , 1A Low Dropout Voltage Regulator, Adjustable Output, Fast Response
SPX29500U-3.3 , 5A Low Dropout Voltage Regulator Adjustable & Fixed Output, Fast Response Time
SNJ54ACT245J
Octal Bidirectional Transceiver with TRI-STATE Inputs/ Outputs
description/ordering informationThese octal bus transceivers are designed for asynchronous two-way communication between data buses. The
control-function implementation minimizes external timing requirements.
When the output-enable (OE) is low, the device passes noninverted data from the A bus to the B bus or from
the B bus to the A bus, depending upon the logic level at the direction-control (DIR) input. A high on OE disables
the device so that the buses are effectively isolated.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
ORDERING INFORMATION†Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are
available at www.ti.com/sc/package.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
