SN75LVDS31 ,HIGH-SPEED DIFFERENTIAL LINE DRIVERSelectrical characteristics of low-voltage differential2A 3 6 2Ysignaling (LVDS). This signaling tec ..
SN75LVDS31 ,HIGH-SPEED DIFFERENTIAL LINE DRIVERSlogic diagram (positive logic)SN75LVDS963882 1Y81A2 1Y 71Z1A 71Z6 62Y33 2Y2A2A 552Z2Z†This symbol i ..
SN75LVDS31DR ,Quad High-Speed Differential Drivers 16-SOIC 0 to 70maximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SN75LVDS32 ,HIGH-SPEED DIFFERENTIAL LINE RECEIVERSelectrical characteristics of low-voltage differential1Y2 7 1Bsignaling (LVDS). This signaling tech ..
SN75LVDS32D ,Quad High-Speed Differential Receivers 16-SOIC 0 to 70logic diagram (positive logic)(positive logic)8421AG1Y12 7G 1B623 31A2A2Y1Y511B 2B652A2Y72B103A 113 ..
SN75LVDS32DR ,Quad High-Speed Differential Receivers 16-SOIC 0 to 70maximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SPN02N60C3 ,for lowest Conduction Losses & fastest SwitchingFeaturesV @ T 650 VDS j,max• New revolutionary high voltage technologyR 2.5ΩDS(on),max• Ultra low g ..
SPN1423S32RG , N-Channel Enhancement Mode MOSFET
SPN2302AS23RG , N-Channel Enhancement Mode MOSFET
SPN2302AS23RG , N-Channel Enhancement Mode MOSFET
SPN2308S23RG , N-Channel Enhancement Mode MOSFET
SPN3402S23RG , N-Channel Enhancement Mode MOSFET
SN75LVDS31-SN75LVDS31DR
HIGH-SPEED DIFFERENTIAL LINE DRIVERS
Signaling Rates up to 155 Mbps Operates From a Single 3.3-V Supply Driver at High Impedance When Disabled orWith VCC = 0 Low-Voltage TTL (LVTTL) Logic Input
Levels Characterized For Operation From
0°C to 70°C
descriptionThe SN75LVDS31 and SN75LVDS9638 are
differential line drivers that implement the
electrical characteristics of low-voltage differential
signaling (LVDS). This signaling technique lowers
the output voltage levels of 5-V differential
standard levels (such as TIA/EIA-422B) to reduce
the power, increase the switching speeds, and allow operation with a 3.3-V supply rail. Any of the four
current-mode drivers will deliver a minimum differential output voltage magnitude of 247 mV into a 100-W load
when enabled.
The intended application of these devices and signaling technique is for point-to-point baseband data
transmission over controlled impedance media of approximately 100 W . The transmission media may be
printed-circuit board traces, backplanes, or cables. The ultimate rate and distance of data transfer is dependent
upon the attenuation characteristics of the media and the noise coupling to the environment.
The SN75LVDS31 and SN75LVDS9638 are characterized for operation from 0°C to 70°C.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
GND
VCC
GND
SN75LVDS9638D (Marked as DF638 or 7L9638)
SN75LVDS9638DGK (Marked as AXK)
(TOP VIEW)
