SN65MLVD206DG4 ,Half-Duplex M-LVDS Transceiver 8-SOIC -40 to 85ELECTRICAL CHARACTERISTICSover recommended operating conditions (unless otherwise noted)(1) (2)PARA ..
SN65MLVD206DR ,Half-Duplex M-LVDS TransceiverFEATURES APPLICATIONS• Low-Power High-Speed Short-Reach• Low-Voltage Differential 30-Ω to 55-Ω Line ..
SN65MLVD207D ,Full-Duplex M-LVDS Transceivermaximum ratings may cause permanent damage to the device. These are stress ratingsonly, and functio ..
SN65MLVD207DG4 ,Full-Duplex M-LVDS Transceiver 14-SOIC -40 to 85FEATURES APPLICATIONS• Low-Power High-Speed Short-Reach• Low-Voltage Differential 30-Ω to 55-Ω Line ..
SN65MLVD207DR ,Full-Duplex M-LVDS TransceiverELECTRICAL CHARACTERISTICSover recommended operating conditions (unless otherwise noted)(1) (2)PARA ..
SN65MLVD207DRG4 ,Full-Duplex M-LVDS Transceiver 14-SOIC -40 to 85features to addressV≤ 1.5 VCCmultipoint applications. The driver output has been• 100-Mbps Devices ..
SN74HCT257D ,Quadruple 2-Line To 1-Line Data Selectors/Multiplexers With 3-State Outputs SCLS072D ..
SN74HCT257DR ,Quadruple 2-Line To 1-Line Data Selectors/Multiplexers With 3-State Outputsmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SN74HCT273DBLE ,Octal D-Type Flip-Flops With Clearlogic diagram, each flip-flop (positive logic)CCDTGTGQCCCCTGCLK(I)TGCC CCR2POST OFFICE BOX 655303 • ..
SN74HCT273DBR ,Octal D-Type Flip-Flops With Clearlogic diagram (positive logic)1D 2D 3D 4D 5D 6D 7D 8D3 4 7 8 13 14 17 1811CLK1D 1D 1D 1D 1D 1D 1D 1 ..
SN74HCT273DW ,Octal D-Type Flip-Flops With Clearmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
SN74HCT273DWG4 ,Octal D-Type Flip-Flops With Clear 20-SOIC -40 to 85logic diagram (positive logic)1D 2D 3D 4D 5D 6D 7D 8D3 4 7 8 13 14 17 1811CLK1D 1D 1D 1D 1D 1D 1D 1 ..
SN65MLVD206DG4-SN65MLVD206DR
Half-Duplex M-LVDS Transceiver
1FEATURES APPLICATIONS
DESCRIPTION
LOGIC DIAGRAM (POSITIVE LOGIC) Y
SN65MLVD203, SN65MLVD207SN65MLVD201, SN65MLVD206
SN65MLVD201, SN65MLVD203
SN65MLVD206, SN65MLVD207SLLS558C–DECEMBER 2002–REVISED JANUARY 2007
www.ti.com
MULTIPOINT-LVDS LINE DRIVER AND RECEIVER Low-Power High-Speed Short-Reach•
Low-Voltage Differential 30-Ωto 55-Ω Line
Alternativeto TIA/EIA-485Drivers and Receivers for Signaling Rates(1) Backplaneor Cabled Multipoint Data andUpto 200 Mbps
Clock Transmission•
Type-1 Receivers Incorporate25 mVof •
Cellular Base StationsHysteresis Central-Office Switches•
Type-2 Receivers Providean Offset (100 mV) •
Network Switches and RoutersThresholdto Detect Open-Circuit and Idle-Bus
Conditions Meetsor Exceeds the M-LVDS Standard
TIA/EIA-899 for Multipoint Data Interchange The SN65MLVD201, 203, 206, and 207 are
multipoint-low-voltage differential (M-LVDS) line•
Controlled Driver Output Voltage Transition drivers and receivers, which are optimizedto operate
Times for Improved Signal Quality at signaling rates upto 200 Mbps. All parts comply•
-1Vto 3.4V Common-Mode Voltage Range with the multipoint low-voltage differential signaling
Allows Data Transfer With2Vof Ground Noise (M-LVDS) standard TIA/EIA-899. These circuits are
similarto their TIA/EIA-644 standard compliant LVDS•
Bus Pins High Impedance When Disabledorcounterparts, with added features to address
VCC≤ 1.5Vmultipoint applications. The driver output has been•
100-Mbps Devices Available (SN65MLVD200A, designed to support multipoint buses presenting
202A, 204A, 205A) loads as low as 30 Ω, and incorporates controlled•
M-LVDS Bus Power Up/Down Glitch Free transition timesto allow for stubs offof the backbone
transmission line.The signaling rateofa line,isthe numberof voltage transitions
thatare madeper second expressedinthe units bps (bitsper These devices have Type-1 and Type-2 receiverssecond). that detect the bus state with as little as 50 mVof
differential input voltage over a common-mode
voltage rangeof-1Vto 3.4V. The Type-1 receivers
exhibit 25 mVof differential input voltage hysteresis prevent output oscillations with slowly changing
signalsor lossof input. Type-2 receivers include an
offset threshold to
under open-circuit,
conditions. The devices
operation from –40°C
