MTB50N06V ,TMOS POWER FET 42 AMPERES 60 VOLTSELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
MTB50N06V ,TMOS POWER FET 42 AMPERES 60 VOLTSELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
MTB50P03HDL ,Power MOSFET 50 Amps, 30 Volts, Logic LevelMAXIMUM RATINGS (T = 25°C unless otherwise noted)CRating Symbol Value Unit4Drain–Source Voltage V 3 ..
MTB50P03HDL ,Power MOSFET 50 Amps, 30 Volts, Logic Level3R , DRAIN-TO-SOURCE RESISTANCE (OHMS)DS(on), DRAIN-TO-SOURCE RESISTANCERDS(on)(NORMALIZED) I , DRA ..
MTB50P03HDL ,Power MOSFET 50 Amps, 30 Volts, Logic Level
MTB50P03HDLT4 ,Power MOSFET 50 Amps, 30 Volts, Logic LevelELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
N82HS195BN , PHILIPS COMPONENTS-SIGNETICS
N82HS195BN , PHILIPS COMPONENTS-SIGNETICS
N82S23N ,256-bit TTL bipolar PROM 32 x 8
N8344AH , SDLC Communications Controller
N83C196KB , COMMERCIAL/EXPRESS CHMOS MICROCONTROLLER
N83C198 , COMMERCIAL/EXPRESS CHMOS MICROCONTROLLER
MTB50N06V
TMOS POWER FET 42 AMPERES 60 VOLTS
-- - ! !
N–Channel Enhancement–Mode Silicon GateTMOS V is a new technology designed to achieve an on–resistance
area product about one–half that of standard MOSFETs. This new
technology more than doubles the present cell density of our 50
and 60 volt TMOS devices. Just as with our TMOS E–FET designs,
TMOS V is designed to withstand high energy in the avalanche and
commutation modes. Designed for low voltage, high speed
switching applications in power supplies, converters and power
motor controls, these devices are particularly well suited for bridge
circuits where diode speed and commutating safe operating areas
are critical and offer additional safety margin against unexpected
voltage transients.
New Features of TMOS V On–resistance Area Product about One–half that of Standard
MOSFETs with New Low Voltage, Low RDS(on) Technology Faster Switching than E–FET Predecessors
Features Common to TMOS V and TMOS E–FETs Avalanche Energy Specified IDSS and VDS(on) Specified at Elevated Temperature Static Parameters are the Same for both TMOS V and TMOS E–FET Surface Mount Package Available in 16 mm 13–inch/2500 Unit
Tape & Reel, Add T4 Suffix to Part Number
MAXIMUM RATINGS (TC = 25°C unless otherwise noted)(1) When surface mounted to an FR4 board using the minimum recommended pad size.
Designer’s Data for “Worst Case” Conditions— The Designer’s Data Sheet permits the design of most circuits entirely from the information presented. SOA Limit
curves— representing boundaries on device characteristics— are given to facilitate “worst case” design.
Designer’s is a trademark of Motorola, Inc. TMOS is a registered trademark of Motorola, Inc.
Thermal Clad is a trademark of the Bergquist Company.
Preferred devices are Motorola recommended choices for future use and best overall value.
