IC Phoenix
 
Home ›  MM142 > ML4827CP-1-ML4827IP-2,Fault-Protected PFC and PWM Controller Combo
ML4827CP-1-ML4827IP-2 Fast Delivery,Good Price
Part Number:
If you need More Quantity or Better Price,Welcom Any inquiry.
We available via phone +865332716050 Email
Partno Mfg Dc Qty AvailableDescript
ML4827CP-1 |ML4827CP1MLN/a27avaiFault-Protected PFC and PWM Controller Combo
ML4827IP-2 |ML4827IP2MLN/a27avaiFault-Protected PFC and PWM Controller Combo


ML4827CP-1 ,Fault-Protected PFC and PWM Controller ComboFeaturesUL1950. A direct descendent of the industry-standard • Pin-compatible with industry-standar ..
ML4827IP-2 ,Fault-Protected PFC and PWM Controller ComboBlock Diagram16 1 132µ APOWER FACTOR CORRECTOR VVEAO IEAO CCVV CCZREFVOVP REFBROKEN WIRE 7.5VVVEAFB ..
ML4828IS , BiCMOS Phase Modulation/Soft Switching Controller
ML4828IS , BiCMOS Phase Modulation/Soft Switching Controller
ML4830CP , Electronic Ballast Controller
ML4833CP , Electronic Dimming Ballast Controller
MMBF4393L ,Small Signal JFEThttp://onsemi.com3t , TURN-OFF DELAY TIME (ns)t , TURN-ON DELAY TIME (ns)d(off)d(on)t , FALL TIME ( ..
MMBF4393LT1 ,Small Signal JFETELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)ACharacteristic Symbol Min Max UnitOFF ..
MMBF4393LT1G , JFET Switching Transistors N-Channel
MMBF4416 ,N-Channel RF Amplifiers
MMBF4416 ,N-Channel RF AmplifiersELECTRICAL CHARACTERISTICS (TA = 25°C unless otherwise noted.)f Characteristlc Symbol Mln Typ Max U ..
MMBF4416 ,N-Channel RF Amplifiers


ML4827CP-1-ML4827IP-2
Fault-Protected PFC and PWM Controller Combo

Features
Pin-compatible with industry-standard ML4824-1 TriFault Detect™ to conform to UL1950™ requirements Available in 50% or 74% max duty cycle versions Low total harmonic distortion Reduces ripple current in the storage capacitor between
the PFC and PWM sections Average current, continuous boost leading edge PFC High efficiency trailing-edge PWM can be configured for
current mode or voltage mode operation Average line voltage compensation with brown-out
control PFC overvoltage comparator eliminates output
“runaway” due to load removal Current fed gain modulator for improved noise immunity Overvoltage protection, UVLO, and soft start
General Description

The ML4827 is a controller for power factor corrected,
switched mode power supplies, that includes circuitry
necessary for conformance to the safety requirements of
UL1950. A direct descendent of the industry-standard
ML4824-1, the ML4827 adds a TriFault Detect™ function to
guarantee that no unsafe conditions may result from single
component failure in the PFC. Power Factor Correction
(PFC) allows the use of smaller, lower cost bulk capacitors,
reduces power line loading and stress on the switching FETs,
and results in a power supply that fully complies with
IEC1000-3-2 specification. The ML4827 includes circuits
for the implementation of a leading edge, average current,
“boost” type power factor correction and a trailing edge,
pulse width modulator (PWM). The device is available in
two versions; the ML4827-1 (Duty CycleMAX = 50%) and
the ML4827-2 (Duty CycleMAX = 74%). The higher
maximum duty cycle of the -2 allows enhanced utilization of
a given transformer core’s power handling capacity. An over-
voltage comparator shuts down the PFC section in the event
of a sudden decrease in load. The PFC section also includes
peak current limiting and input voltage brown-out
protection. The PWM section can be operated in current or
voltage mode, and includes a duty cycle limit to prevent
transformer saturation.
ic,good price


TEL:86-533-2716050      FAX:86-533-2716790
   

©2020 IC PHOENIX CO.,LIMITED