IC Phoenix
 
Home ›  MM107 > MC14LC5003-MC14LC5004,128 Segment LCD Drivers
MC14LC5003-MC14LC5004 Fast Delivery,Good Price
Part Number:
If you need More Quantity or Better Price,Welcom Any inquiry.
We available via phone +865332716050 Email
Partno Mfg Dc Qty AvailableDescript
MC14LC5003MOTN/a6402avai128 Segment LCD Drivers
MC14LC5004MOTN/a3200avai128 Segment LCD Drivers


MC14LC5003 ,128 Segment LCD DriversMOTOROLASEMICONDUCTOR TECHNICAL DATAMC14LC5003MC14LC5004128 Segment LCD DriversCMOSThe MC14LC5003/5 ..
MC14LC5004 ,128 Segment LCD DriversELECTRICAL CHARACTERISTICS (Voltages Referenced to V , T = 25¡C)SS AV VDD LCDCharacteristic V V Min ..
MC14LC5447 ,CALLING LINE ID RECEIVER WITH RING DETECTORMAXIMUM RATINGS(Voltages referenced to GND, except where noted)This device contains circuitry to pr ..
MC14LC5447DW ,Calling Line Identification(CLID) Receiver with Ring DetectorMAXIMUM RATINGS(Voltages referenced to GND, except where noted)This device contains circuitry to pr ..
MC14LC5447P ,Calling Line Identification(CLID) Receiver with Ring Detectorfeatures.• Ring Detector On–Chip• Ring Detect Output for MCU Interrupt• Power–Down Mode, Less than ..
MC14LC5447P ,Calling Line Identification(CLID) Receiver with Ring Detector**Order this documentby MC14LC5447/DSEMICONDUCTOR TECHNICAL DATA*Product Preview* * ** P SUFFIXPLAS ..
MC74F08D ,QUAD 2-INPUT AND GATE FAST SCHOTTKY TTL
MC74F10D ,TRIPLE 3-INPUT NAND GATE FAST SCHOTTKY TTL
MC74F112N ,DUAL JK NEGATIVE EDGE-TRIGGERED FLIP-FLOP
MC74F112N ,DUAL JK NEGATIVE EDGE-TRIGGERED FLIP-FLOP
MC74F11D ,TRIPLE 3-INPUT AND GATE FAST SCHOTTKY TTL
MC74F1245N ,OCTAL BIDIRECTIONAL TRANSCEIVER WITH 3-STATE INPUTS/OUTPUTS


MC14LC5003-MC14LC5004
128 Segment LCD Drivers
128 Segment LCD Drivers
CMOS

The MC14LC5003/5004 are 128-segment, multiplexed-by-four LCD Driv-
ers. The two devices are functionally the same except for their data input
protocols. The MC14LC5003 uses a serial interface data input protocol. The
device may be interfaced to the MC68HCXX product families using a minimal
amount of software (see example). The MC14LC5004 has a IIC interface and
has essentially the same protocol, except that the device sends an acknowl-
edge bit back to the transmitter after each eight-bit byte is received.
MC14LC5004 also has a “read mode”, whereby data sent to the device may
be retrieved via the IIC bus.
The MC14LC5003/MC14LC5004 drives the liquid-crystal displays in a mul-
tiplexed-by-four configuration. The device accepts data from a microproces-
sor or other serial data source to drive one segment per bit. The chip does
not have a decoder, allowing for the flexibility of formatting the segment data
externally.
Devices are independently addressable via a two-wire (or three-wire) com-
munication link which can be common with other peripheral devices.
The MC14LC5003/MC14LC5004 are low cost version of MC145003 and
MC145004 without cascading function. Drives 128 Segments Per Package May Be Used with the Following LCDs: Segmented Alphanumeric,
Bar Graph, Dot Matrix, Custom Quiescent Supply Current: 30 A @ 2.7 V VDD Operating Voltage Range: 2.7 to 5.5 V Operating Temperature Range: -40 to 85¡C Separate Access to LCD Drive Section’s Supply Voltage to Allow for Tem-
perature Compensation See Application Notes AN1066 and AN442
BLOCK DIAGRAM

OSC2
OSC1A2
ENB
DCLK
Din
VLCD BP1-BP4 FP1-FP32
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
ic,good price


TEL:86-533-2716050      FAX:86-533-2716790
   

©2020 IC PHOENIX CO.,LIMITED