MC14510BCL ,BCD Up/Down Counter**SEMICONDUCTOR TECHNICAL DATA** * *The MC14510B synchronous up/down BCD counter is constructed wit ..
MC14510BCL ,BCD Up/Down CounterMAXIMUM RATINGS* (Voltages Referenced to V ) 9 R Q2 11SS10 UP/DOWNSymbol Parameter Value Unit15 CLO ..
MC14510BCL ,BCD Up/Down CounterMaximum Ratings are those values beyond which damage to the may occur.†Temperature Derating: This d ..
MC14510BCP ,BCD Up/Down CounterMaximum Ratings are those values beyond which damage to the may occur.†Temperature Derating: This d ..
MC14511B ,BCD/7 Segment LAT/Decoder/DriverMAXIMUM RATINGS (Voltages Referenced to V ) (Note 2)SSYY, Y = YearSymbol Parameter Value Unit WW, W ..
MC14511BCL ,BCD-To-Seven Segment Latch/Decoder/DriverELECTRICAL CHARACTERISTICS (Voltages Referenced to V )SSÎÎÎÎÎΖ 55* C 25* C 125* CV VD DD DVdc VdcC ..
MC68HC711E9CFN3 ,Microcontroller, 3 MHz, RAM=512, ROM=0, EPROM=12K, EEPROM=512M68HC11E FamilyTechnical DataM68HC11MicrocontrollersM68HC11E/DRev. 4, 7/2002WWW.MOTOROLA.COM/SEMICO ..
MC68HC711E9CFN3 ,Microcontroller, 3 MHz, RAM=512, ROM=0, EPROM=12K, EEPROM=512M68HC11E FamilyTechnical DataM68HC11MicrocontrollersM68HC11E/DRev. 4, 7/2002WWW.MOTOROLA.COM/SEMICO ..
MC68HC711E9CFN3 ,Microcontroller, 3 MHz, RAM=512, ROM=0, EPROM=12K, EEPROM=512M68HC11E FamilyTechnical DataM68HC11MicrocontrollersM68HC11E/DRev. 4, 7/2002WWW.MOTOROLA.COM/SEMICO ..
MC68HC711E9CFN3 ,Microcontroller, 3 MHz, RAM=512, ROM=0, EPROM=12K, EEPROM=512M68HC11E FamilyTechnical DataM68HC11MicrocontrollersM68HC11E/DRev. 4, 7/2002WWW.MOTOROLA.COM/SEMICO ..
MC68HC711E9CFS2 ,Microcontroller, 2 MHz, RAM=512, ROM=0, EPROM=12K, EEPROM=512M68HC11E FamilyTechnical DataM68HC11MicrocontrollersM68HC11E/DRev. 4, 7/2002WWW.MOTOROLA.COM/SEMICO ..
MC68HC711E9CFS2 ,Microcontroller, 2 MHz, RAM=512, ROM=0, EPROM=12K, EEPROM=512M68HC11E FamilyTechnical DataM68HC11MicrocontrollersM68HC11E/DRev. 4, 7/2002WWW.MOTOROLA.COM/SEMICO ..
MC145106P
PLL Frequency Synthesizer
-
CMOSThe MC145106 is a phase–locked loop (PLL) frequency synthesizer
constructed in CMOS on a single monolithic structure. This synthesizer finds
applications in such areas as CB and FM transceivers. The device contains an
oscillator/amplifier, a 210 or 211 divider chain for the oscillator signal, a
programmable divider chain for the input signal, and a phase detector. The
MC145106 has circuitry for a 10.24 MHz oscillator or may operate with an
external signal. The circuit provides a 5.12 MHz output signal, which can be
used for frequency tripling. A 29 programmable divider divides the input signal
frequency for channel selection. The inputs to the programmable divider are
standard ground–to–supply binary signals. Pull–down resistors on these inputs
normally set these inputs to ground enabling these programmable inputs to be
controlled from a mechanical switch or electronic circuitry.
The phase detector may control a VCO and yields a high level signal when
input frequency is low, and a low level signal when input frequency is high. An
out–of–lock signal is provided from the on–chip lock detector with a “0” level for
the out–of–lock condition. Single Power Supply Wide Supply Range: 4.5 to 12 V Provision for 10.24 MHz Crystal Oscillator 5.12 MHz Output Programmable Division Binary Input Selects up to 29 On–Chip Pull–Down Resistors on Programmable Divider Inputs Selectable Reference Divider, 210 or 211 (Including ÷ 2) Three–State Phase Detector See Application Note AN535 and Article Reprint AR254 Chip Complexity: 880 FETs or 220 Equivalent Gates See the MC145151–2 and MC145152–2 for Higher Performance and
Added Flexibility
BLOCK DIAGRAMfin
OSCin
OSCout
÷ 2out FS
φDetoutP1 P2 P3 P4 P5 P6 P7 P8
Order this document
by MC145106/D-
SEMICONDUCTOR TECHNICAL DATA
