MC10H159L ,Quad 2-Input MultiplexerELECTRICAL CHARACTERISTICS (V = –5.2 V ±5%) (See Note)EELH H X L0° 25° 75°HX X X LCharacteristic Sy ..
MC10H159M ,Quad 2-Input Multiplexer (Inverting)3MC10H159PACKAGE DIMENSIONSPLCC–20FN SUFFIXPLASTIC PLCC PACKAGECASE 775–02ISSUE CM S S0.007 (0.180) ..
MC10H159M ,Quad 2-Input Multiplexer (Inverting)Prepared by: Paul ShockmanON SemiconductorAPPLICATION NOTEObjectiveGeneral BackgroundThis applicati ..
MC10H159MEL ,Quad 2-Input Multiplexer (Inverting)
MC10H159MEL ,Quad 2-Input Multiplexer (Inverting)APPLICATION NOTEDifferential Characteristics (continued)APPLICATION NOTE USAGEThis application note ..
MC10H159MEL ,Quad 2-Input Multiplexer (Inverting)
MC3476P1 ,LOW COST PROGRAMMABLE OPERATIONAL AMPLIFIERfeatures low power consumption and high inputimpedance. In addition, the quiescent currents within ..
MC3479P ,Stepper Motor Driver
MC3479P ,Stepper Motor Driver
MC3479PG , Stepper Motor Driver
MC3481L ,962mW; V(cc): 7.0V; quad single-ended line driverMOTOROLA SC (TELECOM) LEE 1) " 5357353 DDGBHSB 505 "tlooMOTOROLA- SEMICONDUCTOR -llil-l1l+ MC348tTE ..
MC3481L ,962mW; V(cc): 7.0V; quad single-ended line driverMAXIMUM RATINGS (TA = 25"C unless otherwise noted)Rating Symbol Value Unit-rPower Supply Voltage VC ..
MC10H159L
Quad 2-Input Multiplexer
SEMICONDUCTOR TECHNICAL DATA The MC10H159 is a quad 2–input multiplexer with enable. This MECL 10H
part is a functional/pinout duplication of the standard MECL 10K family part,
with 100% improvement in propagation delay and no increase in power–supply
current. Propagation Delay, 1.5 ns Typical Power Dissipation, 218 mW Typical Improved Noise Margin 150 mV (Over Operating Voltage and
Temperature Range) Voltage Compensated MECL 10K–Compatible
MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS (VEE = –5.2 V ±5%) (See Note)
AC PARAMETERS
NOTE:Each MECL 10H series circuit has been designed to meet the dc specifications shown in the test table,
after thermal equilibrium has been established. The circuit is in a test socket or mounted on a printed circuit
board and transverse air flow greater than 500 Iinear fpm is maintained. Outputs are terminated through
a 50–ohm resistor to –2.0 volts.
TRUTH TABLE
DIP
PIN ASSIGNMENTD11
D10
D01
D00
ENABLE
VEE
VCC
D20
D21
D30
D31
SELECT
Pin assignment is for Dual–in–Line Package.
For PLCC pin assignment, see the Pin Conversion
Tables on page 6–11 of the Motorola MECL Data
Book (DL122/D).
