MAX3059ASA+ ,5V, 1Mbps, Low Supply Current CAN TransceiversApplicationsTOP VIEWTXD 1 8 RS TXD 1 8 RSGND 2 7 CANH GND 2 7 CANHMAX3058 MAX3059V 3 6 CANL V 3 6 C ..
MAX305CPE ,Precision, Dual, High-Speed Analog SwitchesGeneral Description ____________
MAX305CSE ,Precision, Dual, High-Speed Analog SwitchesBlock Diagrams/Truth TablesTOP VIEWCOM1 COM1 COM1 NO11 NO1 1 NO1 1 16 16 16N.C. N.C. IN1N.C. 2 IN1 ..
MAX305ESE ,Precision, Dual, High-Speed Analog SwitchesFeaturesThe MAX301/MAX303/MAX305 are precision, dual, high-' Low On Resistance <22Ω Typical (35Ω Ma ..
MAX3061EEKA#TG16 ,±15kV ESD-Protected, Fail-Safe, 20Mbps, Slew-Rate-Limited RS-485/RS-422 Transceivers in a SOTApplicationsDATA SLEW-Industrial-Control Local-Area NetworksTRANSCEIVERSPART RATE RATEON BUS(Mbps) ..
MAX306CPI ,Precision, 16-Channel/Dual 8-Channel, High-Performance, CMOS Analog MultiplexersGeneral Description ________
MAX628ESA+ ,Dual-Power MOSFET DriversDual Power MOSFET Drivers
ABSOLUTE MAXIMUM RATINGS
Supply Voltage VDD to GND .................. ..
MAX628ESA+T ,Dual-Power MOSFET DriversDual Power MOSFET Drivers
ABSOLUTE MAXIMUM RATINGS
Supply Voltage VDD to GND .................. ..
MAX628ESA+T ,Dual-Power MOSFET DriversDual Power MOSFET Drivers
ABSOLUTE MAXIMUM RATINGS
Supply Voltage VDD to GND .................. ..
MAX629ESA ,28V, Low-Power, High-Voltage, Boost or Inverting DC-DC Converterfeatures an' Internal, 500mA, 28V N-Channel Switch internal N-channel MOSFET switch and programmabl ..
MAX629ESA ,28V, Low-Power, High-Voltage, Boost or Inverting DC-DC ConverterApplications___________Typical Operating CircuitV VIN IN+2.7V +2.7VTO +5.5V TO +5.5VV OUTV VCC CC28 ..
MAX629ESA ,28V, Low-Power, High-Voltage, Boost or Inverting DC-DC ConverterELECTRICAL CHARACTERISTICS(V = +5V, C = 0.1µF, T = -40°C to +85°C, unless otherwise noted. Typical ..
MAX3058ASA+-MAX3059ASA+
5V, 1Mbps, Low Supply Current CAN Transceivers
General DescriptionThe MAX3058/MAX3059 interface between the con-
troller area network (CAN) protocol controller and the
physical wires of the bus lines in a CAN. They are pri-
marily intended for printer and telecom backplane appli-
cations requiring data rates up to 1Mbps. These
devices provide differential transmit capability to the bus
and differential receive capability to the CAN controller.
The MAX3058 output common-mode range is from -7V
to +12V. The MAX3059 output common-mode range is
from 0V to VCC. The MAX3059 contains an internal
switch termination resistor that makes it ideal for JetLink
applications.
The MAX3058 features four different modes of opera-
tion: high speed, slope control, standby, and shutdown.
The MAX3059 features three different modes of opera-
tion: high speed, slope control, and shutdown. High-
speed mode allows data rates up to 1Mbps. In
slope-control mode, the slew rate may be optimized for
data rates up to 500kbps, so the effects of EMI are
reduced, and unshielded twisted or parallel cable can
be used. In standby mode, the transmitters are shut off
and the receivers are put into low-current mode. In
shutdown mode, the transmitter and receiver are
switched off.
The MAX3058/MAX3059 are available in an 8-pin SO
package and are specified over the -40°C to +125°C
temperature range.
ApplicationsPrinters JetLink
Industrial Control Networks
Telecom Backplane
Consumer Applications
FeaturesFour Operating Modes
High-Speed Operation Up to 1Mbps
Slope-Control Mode to Reduce EMI (40kbps to
500kbps)
Low-Current Shutdown Mode
Standby Mode (MAX3058 Only)Thermal ShutdownCurrent LimitingESD Protection±12kV Human Body Model
MAX3058/MAX3059, 1Mbps, Low Supply Current
CAN Transceivers
Ordering Information19-2939; Rev 1; 9/03
Pin Configurations
Selector Guide
Typical Operating Circuit appears at end of data sheet.
MAX3058/MAX3059, 1Mbps, Low Supply Current
CAN Transceivers
ABSOLUTE MAXIMUM RATINGS
DC ELECTRICAL CHARACTERISTICSStresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
VCCto GND..............................................................-0.3V to +6V
TXD, RS, SHDN, TERM to GND................................-0.3V to +6V
RXD to GND.............................................................-0.3V to +6V
CANH, CANL to GND (MAX3058).......................-7.5V to +12.5V
CANH, CANL to GND (MAX3059)..............-0.3V to (VCC+ 0.3V)
Continuous Power Dissipation (TA= +70°C)
8-Pin SO (derate 5.9mW/°C above +70°C)..................470mW
Operating Temperature Range.........................-40°C to +125°C
Maximum Junction Temperature.....................................+150°C
Storage Temperature Range.............................-65°C to +150°C
Lead Temperature (soldering, 10s).................................+300°C
MAX3058/MAX3059, 1Mbps, Low Supply Current
CAN Transceivers
DC ELECTRICAL CHARACTERISTICS (continued)
MAX3058/MAX3059, 1Mbps, Low Supply Current
CAN Transceiversunless otherwise noted.
Note 2:(VTXD= VCC; CANH and CANL externally driven; -7V < VCANH, VCANL< 12V for MAX3058; 0V < VCANH, VCANL< VCCfor
MAX3059, unless otherwise specified).
Note 3:Specification guaranteed by design, not production tested.
Note 4:No other devices on the BUS.
Note 5:BUS externally driven.
TIMING CHARACTERISTICS(VCC= +5V ±10%, RL= 60Ω, CL= 100pF, TA= TMINto TMAX. Typical values are at VCC= +5V and TA= +25°C.)
MAX3058/MAX3059, 1Mbps, Low Supply Current
CAN TransceiversFigure1. Timing Diagram
Figure2. Timing Diagram for Standby Signal (MAX3058)
Figure3. Timing Diagram for Shutdown Signal
Figure4. Test Circuit and Diagram for TERM Timing (MAX3059)
Timing Diagrams
MAX3058/MAX3059, 1Mbps, Low Supply Current
CAN Transceivers
Typical Operating Characteristics(VCC= +5V, RL= 60Ω, CL= 100pF, TA= +25°C, unless otherwise specified.)
