IC Phoenix
 
Home ›  LL32 > LM2904WH-LM2904WHD-LM2904WHDT,LOW POWER DUAL OPERATIONAL AMPLIFIERS
LM2904WH-LM2904WHD-LM2904WHDT Fast Delivery,Good Price
Part Number:
If you need More Quantity or Better Price,Welcom Any inquiry.
We available via phone +865332716050 Email
Partno Mfg Dc Qty AvailableDescript
LM2904WHSTN/a1280avaiLOW POWER DUAL OPERATIONAL AMPLIFIERS
LM2904WHDSTN/a485avaiLOW POWER DUAL OPERATIONAL AMPLIFIERS
LM2904WHDTSTN/a5200avaiLOW POWER DUAL OPERATIONAL AMPLIFIERS


LM2904WHDT ,LOW POWER DUAL OPERATIONAL AMPLIFIERSLM2904WHLOW POWER DUAL OPERATIONAL AMPLIFIERS ■ INTERNALLY FREQUENCY COMPENSATED ■ LARGE DC VO ..
LM2904WHYD ,Dual general purpose operational amplifierAbsolute maximum ratingsSymbol Parameter Value Unit+V Supply voltage +32 VCCV Differential input vo ..
LM2904WHYDT ,Dual general purpose operational amplifierFeatures■ Internally frequency compensated■ Large DC voltage gain: 100 dB■ Wide bandwidth (unity ga ..
LM2904WYDT ,Low Power Dual Operational AmplifierAbsolute maximum ratings (AMR)Symbol Parameter Value Unit(1)V Supply voltage +32CC(2)V Differential ..
LM2904YDT ,Low power, bipolar op-ampapplications . . . . . . 125 Macromodel . . . . . . . 146 Package information 156.1 S ..
LM2907 ,Frequency to Voltage ConverterFeatures YClutch controlYGround referenced tachometer input interfaces directlyYHorn controlwith va ..
LM78L ,N-Channel FET Synchronous Buck Regulator Controller for Low Output VoltagesGeneral Descriptionpower dissipation. If internal power dissipation becomes tooThe LM78LXX series o ..
LM78L05 ,3-Terminal Positive RegulatorsLM78LXXSeries3-TerminalPositiveRegulatorsFebruary1995LM78LXXSeries3-TerminalPositiveRegulatorsGener ..
LM78L05A ,Terminal 0.1A Positive Voltage RegulatorFeaturesally results in an effective output impedance improvement ofn LM78L05 in micro SMD packaget ..
LM78L05A ,Terminal 0.1A Positive Voltage RegulatorElectrical Characteristics(MC78L05A/LM78L05A) (V = 10V, I = 40mA, 0°C ≤ T ≤ 125°C, C = 0.33µ F, C ..
LM78L05A ,Terminal 0.1A Positive Voltage RegulatorFeatures Description• Maximum Output Current of 100mA The MC78LXXA/LM78LXXA/MC78L05AA series of• Ou ..
LM78L05ACM ,3-Terminal Positive RegulatorsLM78LXX Series 3-Terminal Positive RegulatorsFebruary 2005LM78LXX Series3-Terminal Positive Regulat ..


LM2904WH-LM2904WHD-LM2904WHDT
LOW POWER DUAL OPERATIONAL AMPLIFIERS
1/7 INTERNALLY FREQUENCY COMPENSATED LARGE DC VOLTAGE GAIN: 100dB WIDE BANDWIDTH (unity gain: 1.1MHz
(temperature compensated) VERY LOW SUPPLY CURRENT/OP (500μA) LOW INPUT BIAS CURRENT: 20nA
(temperature compensated) LOW INPUT OFFSET CURRENT: 2nA INPUT COMMON-MODE VOLTAGE RANGEINCLUDES GROUND DIFFERENTIAL INPUT VOLTAGE RANGE
EQUAL TO THE POWER SUPPLY VOLTAGE LARGE OUTPUT VOLTAGE SWING 0V TO
(VCC - 1.5V) INTERNAL ESD PROTECTION:
1500V HBM in pin to pin mode
200V MM
DESCRIPTION

This circuit consists of two independent, high gain,
internally frequency compensated which were de-
signed specifically for automotive and industrial
control system. It operates from a single power
supply over a wide range of voltages. The low
power supply drain is independent of the magni-
tude of the power supply voltage.
Application areas include transducer amplifiers,
dc gain blocks and all the conventional op-amp
circuits which now can be more easily implement-
ed in single power supply systems. For example,
these circuits can be directly supplied with off the
standard +5V which is used in logic systems and
will easily provide the required interface electron-
ics without requiring any additional power supply.
In the linear mode the input common-mode volt-
age range includes ground and the output voltage
can also swing to ground, even though operated
from only a single power supply voltage.

ORDER CODE

D = Small outline package (SO) - Also available in Tape & Reel (DT)
LM2904WH

LOW POWER DUAL OPERATIONAL AMPLIFIERS
September 2003
LM2904WH
2/7
SCHEMATIC DIAGRAM (1/2 LM2904WH)
PAD LOCATIONS
LM2904WH
3/7
ABSOLUTE MAXIMUM RATINGS
OPERATING CONDITIONS
ELECTRICAL CHARACTERISTICS
CC+ = 5V, Vcc- = Ground, VO = 1.4V, Tamb = 25°C (unless otherwise specified) Short-circuits from the output to Vcc can cause excessive heating if Vcc+ > 15V. The maximum output current is approximately 40mA,
independent of the magnitude of Vcc. Destructive dissipation can result from simultaneous short-circuits on all amplifiers. PD is calculated with TAMB=+25°C, TJunction=+150°C and RTH J-A=175°C/W for SO8 package This input current only exists when the voltage values applied on the inputs is beyond the supply voltage lines limits. This is not destructive if the
current is limited to 5mA as mentioned and normal output will set up again for input voltage higher than -0.3V
LM2904WH
4/7
VO = 1.4V, RS = 0Ω, 5V < VCC + < 30V, 0V < Vic < VCC + - 1.5V The direction of the input current is out of the IC. This current is essentially constant, independent of the state of the output, so no loading chargechange exists on the input lines The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the
common-mode voltage range is VCC+ –1.5V, but either or both inputs can go to +32V without damage. Due to the proximity of external components insure that coupling is not originating via stray capacitance between these external parts. This typicallycan be detected as this type of capacitance increases at higher frequencies.
LM2904WH
5/7

LM2904WH
6/7
ic,good price


TEL:86-533-2716050      FAX:86-533-2716790
   

©2020 IC PHOENIX CO.,LIMITED