HDMI05-CL02F3 ,5-line signal conditioning and ESD protection for HDMI interfacesPin configuration (bump side)Complies with the standards:3 2 1■ IEC 61000-4-2 Level 4– ± 15 kV (air ..
HDMIULC6-2P6 ,Ultra Low capacitance 2 lines ESD protectionApplicationslevel■ HDMI ports at 1.65 Gb/s and up to 3.2 Gb/s■ ESD protection of V when applicable. ..
HDMIULC6-4F3 ,4-line, ultralarge bandwhith ESD protectionApplications GND ED 2- D 2-OUT_ IN_F■ Mobile phones■ HDMI ports at 1.65 Gb/s and up to 3.2 Gb/s■ US ..
HDMIULC6-4F3 ,4-line, ultralarge bandwhith ESD protectionPin configuration (bump side)■ Very low leakage current 70 nA213■ 0.4 mm pitch Flip-Chip package (w ..
HDMIULC6-4SC6 ,Ultra large bandwidth ESD protectionFeatures BUS■ High efficiency due to low residual voltage ■ 4 line 15 kV ESD protectionwhen confron ..
HDMP-0421 ,HDMP-0421 · 1.0625-1.25 GBd Single Port Bypass Circuit wirh CDR for Fibre Channel/Storage and GbE ApplicationsFeatures Description• Supports ANSI X3T11 The HDMP-0421 is a Single Port1.0625 Gbps FC-AL Loop Bypa ..
HLMP-P502-F0021 ,HLMP-P502-F0021 · Subminiature LED Lampsapplicationsthat is necessary for use inLead Configurationsbacklighting
HLMP-P505-G0011 ,HLMP-P505-G0011 · Subminiature LED LampsAgilent HLMP-PxxxSubminiature LED LampsData Sheet
HLMP-P505-G0031 ,HLMP-P505-G0031 · Subminiature LED Lampsapplications• Subminiature dome packageHLMP-Pxxx Series, HLMP-Qxxx Series– diffused dome for wide v ..
HLMP-Q102-N0011 ,HLMP-Q102-N0011 · Subminiature High Performance TS AlGaAs Red LED LampsFeatures• Subminiature flat top packageHLMP-P106/P156Ideal for backlighting and lightHLMP-Q102/Q152 ..
HLMP-Q105-P0031 ,HLMP-Q105-P0031 · Subminiature LED Lampsapplications• Subminiature dome packageHLMP-Pxxx Series, HLMP-Qxxx Series– diffused dome for wide v ..
HLMPQ106AYR ,AlGaAs Red Clear Solid State LED Lamp Subminiature T-1 3/4 (1.9 mm)SOLID STATE LED LAMPSSUBMINIATURE T-1 3/4 (1.9mm)AlGaAs RED HLMP-Q106A ClearPACKAGE DIMENSIONSAllnG ..
HDMI05-CL02F3
5-line signal conditioning and ESD protection for HDMI interfaces
April 2010 Doc ID 15516 Rev 2 1/9
HDMI05-CL02F35-line IP AD™, HDMI™ control line ESD protection
Features Low line capacitance: 12 pF max. High efficiency in ESD protection Lead-free package Very thin package High reliability offered by monolithic integration High reduction of parasitic elements through
integration and wafer level packaging
Complies with the standards: IEC 61000-4-2 Level 4 ± 15 kV (air discharge) ± 8 kV (contact discharge) IEC 61000-4-2 Level 1 ± 2 kV (air discharge) ± 2 kV (contact discharge)
ApplicationWhere ESD protection for HDMI control lines
(CEC, HPD, SCL and SDA) is required: Mobile phones and communication systems Portable multimedia players Camcorder, digital still cameras
DescriptionThe HDMI05-CL02F3 chip is a low capacitance
ESD protection for HDMI control pins. It also
integrates pull-up resistor for I²C bus and pull-
down resistor for hot plug detect and pull-up
resistor for CEC line.
The ESD protection circuitry prevents damage to
the protected device when subjected to ESD
surges up to 15 kV.
Figure 1. Pin configuration (bump side)
Figure 2. Schematic
TM: IPAD is a trademark of STMicroelectronics. HDMI, the HDMI logo and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI
Licensing LLC.
Characteristics HDMI05-CL02F32/9 Doc ID 15516 Rev 2
1 Characteristics
Figure 3. Electrical characteristics (definitions)
Table 1. Absolute maximum ratings (Tamb = 25 °C)
Table 2. Electrical characteristics (Tamb = 25 °C) This is the line capacitance seen by the data signals in the application conditions
HDMI05-CL02F3 CharacteristicsDoc ID 15516 Rev 2 3/9
Figure 4. S21(dB) versus frequency Figure 5. Analog crosstalk measurements
Figure 6. ESD response to IEC 61000-4-2
(+8 kV contact discharge)
on CEC line
Figure 7. ESD response to IEC 61000-4-2
(-8 kV contact discharge)
on CEC line
Figure 8. ESD response to IEC 61000-4-2
(+8 kV contact discharge)
on SCL line
Figure 9. ESD response to IEC 61000-4-2
(-8 kV contact discharge)
on SCL line
Characteristics HDMI05-CL02F34/9 Doc ID 15516 Rev 2
Figure 10. ESD response to IEC 61000-4-2
(+8 kV contact discharge)
on SDA line
Figure 11. ESD response to IEC 61000-4-2
(-8 kV contact discharge)
on SDA line
Figure 12. ESD response to IEC 61000-4-2
(+8 kV contact discharge)
on HPD line
Figure 13. ESD response to IEC 61000-4-2
(-8 kV contact discharge)
on HPD line
Figure 14. ESD response to IEC 61000-4-2
(+8 kV contact discharge)
on 5 V line
Figure 15. ESD response to IEC 61000-4-2
(-8 kV contact discharge)
on 5 V line
HDMI05-CL02F3 Typical application schematicDoc ID 15516 Rev 2 5/9
Typical application schematic
Figure 16. Implementation with HDMI
