74ACT16541DLR ,16-Bit Buffers/Drivers With 3-State Outputsmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
74ACT16543DGGR ,16-Bit Registered Transceivers With 3-State Outputs 54ACT16543, 74ACT16543 16-BIT REGISTERED TRANSCEIVERSWITH 3-STATE OUTPUTSSCAS126B – MARCH 1990 – R ..
74ACT16543DL ,16-Bit Registered Transceivers With 3-State Outputs 54ACT16543, 74ACT16543 16-BIT REGISTERED TRANSCEIVERSWITH 3-STATE OUTPUTSSCAS126B – MARCH 1990 – R ..
74ACT16623DL ,16-Bit Bus Transceivers With 3-State Outputs 54ACT16623, 74ACT16623 16-BIT BUS TRANSCEIVERSWITH 3-STATE OUTPUTSSCAS152A – JANUARY 1991 – REVISE ..
74ACT16623DLR ,16-Bit Bus Transceivers With 3-State Outputsmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
74ACT16640DLR ,16-Bit Bus Transceivers With 3-State Outputs 48-SSOP -40 to 85
74HC174D ,Hex D-type flip-flop with reset; positive-edge triggerLogic diagram74HC_HCT174 All information provided in this document is subject to legal disclaimers. ..
74HC174N ,Hex D-type flip-flop with reset; positive-edge triggerPin configuration DIP16 Fig 5.
74HC174PW ,Hex D-type flip-flop with reset; positive-edge triggerINTEGRATED CIRCUITSDATA SHEETFor a complete data sheet, please also download:• The IC06 74HC/HCT/HC ..
74HC175D ,Quad D-type flip-flop with reset; positive-edge triggerINTEGRATED CIRCUITSDATA SHEETFor a complete data sheet, please also download:• The IC06 74HC/HCT/HC ..
74HC175DB ,Quad D-type flip-flop with reset; positive-edge triggerGENERAL DESCRIPTIONcorresponding output (Q ) of the flip-flop.nThe 74HC/HCT175 are high-speed Si-ga ..
74HC175N ,Quad D-type flip-flop with reset; positive-edge triggerFeatures and benefits Input levels: For 74HC175: CMOS level For 74HCT175: TTL level Four edge-t ..
74ACT16541DL-74ACT16541DLR
16-Bit Buffers/Drivers With 3-State Outputs
Distributed VCC and GND Pin ConfigurationMinimizes High-Speed Switching Noise EPIC (Enhanced-Performance Implanted
CMOS) 1-m m Process 500-mA Typical Latch-Up Immunity at
125°C Package Options Include Plastic 300-mil
Shrink Small-Outline (DL) Packages Using
25-mil Center-to-Center Pin Spacings and
380-mil Fine-Pitch Ceramic Flat (WD)
Packages Using 25-mil Center-to-Center
Pin Spacings
descriptionThe ’ACT16541 are noninverting 16-bit buffers
composed of two 8-bit sections with separate
output-enable signals. For either 8-bit buffer
section, the two output-enable (1OE1 and 1OE2
or 2OE1 and 2OE2) inputs must both be low for
the corresponding Y outputs to be active. If either
output-enable input is high, the outputs of that
8-bit buffer section are in the high-impedance
state.
The 74ACT16541 is packaged in TI’s shrink small-outline package, which provides twice the I/O pin count and
functionality of standard small-outline packages in the same printed-circuit-board area.
The 54ACT16541 is characterized for operation over the full military temperature range of –55°C to 125°C. The
74ACT16541 is characterized for operation from –40°C to 85°C.
FUNCTION TABLE
(each 8-bit section)1Y2
GND
1Y3
1Y4CC
1Y5
1Y6
GND
1Y7
1Y8
2Y1
2Y2
GND
2Y3
2Y4
VCC
2Y5
2Y6
GND
2Y7
2Y8
2OE1
1A2
GND
1A3
1A4CC
1A5
1A6
GND
1A7
1A8
2A1
2A2
GND
2A3
2A4
VCC
2A5
2A6
GND
2A7
2A8
2OE2
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
