TVP5151PBSR ,Ultralow-Power NTSC/PAL/SECAM Video Decoder 32-TQFP 0 to 70 SLES241E–SEPTEMBER 2009–REVISED OCTOBER 20111.4 Related Products• TVP5150AM1• TVP5154A• TVP5146M2• ..
TVP5151ZQCR ,Ultralow-Power NTSC/PAL/SECAM Video Decoder 48-BGA MICROSTAR JUNIOR 0 to 70Features1• Accepts NTSC (J, M, 4.43), PAL (B, D, G, H, I,• Standard Programmable Video Output Forma ..
TVP5154 ,4 Channel Low Power PAL/NTSC/SECAM Video Decoder With Independent Scalers 128-HTQFP 0 to 70
TVP5154AIPNP ,4 Channel Low Power PAL/NTSC/SECAM Video Decoder with Independent Scalers 128-HTQFP -40 to 85Block Diagram ...... 98.1 Overview ........ 793.3 Adaptive Comb Filtering . 108.2 Horizontal Scalin ..
TVP5154APNP ,4 Channel Low Power PAL/NTSC/SECAM Video Decoder with Independent Scalers 128-HTQFP 0 to 70Features for Each Channel: Line-Locked Clock (Separate for Each Channel)and Sampling– Accept NTSC ( ..
TVP5154APNPR ,4 Channel Low Power PAL/NTSC/SECAM Video Decoder with Independent Scalers 128-HTQFP 0 to 70Maximum Ratings ...... 823.7 Timing Processor ........ 119.2 Recommended Operating Conditions ..... ..
UC3845DX ,SMPS ControllerFeatures Description• Low Start up Current The UC3842/UC3843/UC3844/UC3845 are fixed• Maximum Duty ..
UC3845DX ,SMPS ControllerBlock Diagram* NORMALLY 8DIP/8SOP PIN NO.* ( ) IS 14SOP PINNO.* TOGGLE FLIP FLOP USED ONLY IN UC384 ..
UC3845DX ,SMPS ControllerUC3842/UC3843/UC3844/UC3845SMPS Controller
UC3845N ,SMPS ControllerUC3842/UC3843/UC3844/UC3845SMPS Controller
UC3845NG4 ,Current-Mode PWM Controller 8-PDIP 0 to 70Electrical Characteristics....... 712.4 Trademarks..... 357.6 Typical Characteristics. 912.5 Electr ..
UC3845NG4 ,Current-Mode PWM Controller 8-PDIP 0 to 70Block Diagrams. 11Information..... 368.3 Feature Description.... 124 Revision HistoryChanges from R ..
TVP5151IPBSR-TVP5151PBSR-TVP5151ZQCR
Ultralow-Power NTSC/PAL/SECAM Video Decoder 48-BGA MICROSTAR JUNIOR 0 to 70
TVP5151
www.ti.com SLES241E–SEPTEMBER 2009–REVISED OCTOBER 2011
Ultralow-Power NTSC/PAL/SECAM Video Decoder
Checkfor Samples: TVP5151 Introduction
1.1 Features Accepts NTSC(J,M, 4.43), PAL (B,D,G,H,I, •
Standard Programmable Video Output FormatsN, Nc), and SECAM (B,D,G,K, K1,L) Video –
ITU-R BT.656, 8-Bit 4:2:2 With Embedded Supports ITU-R BT.601 Standard Sampling Syncs High-Speed 9-Bit Analog-to-Digital Converter –
8-Bit 4:2:2 With Discrete Syncs
(ADC) •
Macrovision™ Copy Protection Detection Two Composite Inputsor One S-Video Input •
Advanced Programmable Video Output Fully Differential CMOS Analog Preprocessing Formats
Channels With Clamping and Automatic Gain –
2× Oversampled Raw Vertical BlankingControl (AGC) for Best Signal-to-Noise (S/N) Interval (VBI) Data During Active VideoPerformance –
Sliced VBI Data During Horizontal Blanking•
Ultralow Power Consumption or Active Video 48-Terminal PBGA Package (ZQC)or •
VBI Modes Supported32-Terminal TQFP Package (PBS) –
Teletext (NABTS, WST) Power-Down Mode:<1
mW –
Closed-Caption Decode With FIFO and•
Brightness, Saturation, Hue, and Sharpness Extended Data Services (XDS)Control ThroughI2C –
Wide Screen Signaling, Video Program•
Complementary 4-Line (3-H Delay) Adaptive System, CGMS-A, Vertical Interval TimeComb Filters for Both Cross-Luminance and CodeCross-Chrominance Noise Reduction –
Gemstar 1x/2x Electronic Program Guide•
Patented Architecture for Lockingto Weak, Compatible ModeNoisy,or Unstable Signals –
Custom Configuration Mode That Allows•
Single 27.000-MHz Crystal for All Standards Userto Program Slice Engine for Unique VBI Internal Phase-Locked Loop (PLL) for Data Signals
Line-Locked Clock and Sampling •
Power-On Reset Subcarrier Genlock Output for Synchronizing •
Industrial Temperature RangeColor Subcarrierof External Encoder (TVP5151I): –40°C
to 85°C Variable Digital I/O Supply Voltage Range fromis an ultralow-power NTSC/PAL/SECAM video decoder. Availableina space-saving TQFP decoder converts NTSC, PAL, BT.656 format. also available. The optimized allows for ultralow power consumption. decoder consumes conditions and consumes less power-down
considerably lifein portable applications. The decoder just one all decoder canbe programmed usinganI2C serial interface. baseband analog video into digital YCbCr 4:2:2 component are supported. The TVP5151 decoder analog-to-digital Samplingis ITU-R BT.601 MHz, 27.000-MHzis line locked. The output formats can be 8-bit 4:2:2or 8-bit ITU-R BT.656
