TPS60205DGS ,Regulated 3.3-V Low Ripple Charge Pump with Power Good Indicatorfeatures10-pin MSOP With Only Four External Regulated 3.3-V Output Voltage With up toCapacitors Re ..
TPS60212DGS ,Regulated 3.3-V 50-mA Low-Ripple Charge Pump with Ultra Low Operating Currentblock diagramsTPS60210 and TPS60212 with low-battery detectorCharge Pump 10°INOscillator180°C1+C1C1 ..
TPS60212DGSRG4 ,Regulated 3.3-V 50-mA Low-Ripple Charge Pump with Ultra Low Operating Current 10-VSSOP -40 to 85features(TPS60210EVM-167) Regulated 3.3-V Output Voltage From a1.8-V to 3.6-V Input Voltage Rangea ..
TPS60230RGTR ,5-Channel, Current-regulated 125-mA Charge Pump for White LED Backlight in 3x3 QFNSLVS516A–MAY 2004–REVISED JUNE 2004WHITE LED CHARGE PUMP CURRENT SOURCEWITH PWM BRIGHTNESS CONTROL
TPS60230RGTT ,5-Channel, Current-regulated 125-mA Charge Pump for White LED Backlight in 3x3 QFNMAXIMUM RATINGS(1)over operating free-air temperature range (unless otherwise noted)UNITV Supply vo ..
TPS60230RGTT ,5-Channel, Current-regulated 125-mA Charge Pump for White LED Backlight in 3x3 QFNmaximum ratings" may cause permanent damage to the device. These are stress ratingsonly, and functi ..
TSM102IPWR ,Dual Opamp, Dual Comparator with Voltage Reference 16-TSSOP -40 to 85FEATURES APPLICATIONS• Switch-Mode Power Supplies• OPERATIONAL AMPLIFIERS• Battery Chargers– Low Su ..
TSM103AI ,DUALOPERATIONAL AMPLIFIER AND VOLTAGE REFERENCETSM103/A DUAL OPERATIONAL AMPLIFIER ANDVOLTAGE REFERENCEOPERATIONAL AMPLIFIER.LOW INPUT OFFSET VOL ..
TSM103AID ,DUAL OP-AMP AND VOLTAGE REFERENCEapplications likeInverting Input 1 Output 22 7power supply management or data acquisition- +6 Inver ..
TSM103AIDT ,DUAL OP-AMP AND VOLTAGE REFERENCETSM103/ADUAL OPERATIONAL AMPLIFIER ANDVOLTAGE REFERENCENOT FOR NEW DESIGN - REPLACED BY TSM103W O ..
TSM103ID ,DUAL OP-AMP AND VOLTAGE REFERENCEABSOLUTE MAXIMUM RATINGS Symbol Parameter Value UnitV Supply Voltage 36 VCCVDifferential Input ..
TSM103IDT ,DUAL OP-AMP AND VOLTAGE REFERENCEABSOLUTE MAXIMUM RATINGS Symbol Parameter Value UnitV Supply Voltage 36 VCCVDifferential Input ..
TPS60205DGS
Regulated 3.3-V Low Ripple Charge Pump with Power Good Indicator
Less Than 5-mV(PP) Output Voltage RippleAchieved With Push-Pull Topology Integrated Low-Battery and Power-Good
Detector Switching Frequency Can Be Synchronized
to External Clock Signal Extends Battery Usage With up to 90%
Efficiency and 35-µA Quiescent Supply
Current Easy-to-Design, Low Cost, Low EMI Power
Supply Since No Inductors Are Used 0.05-µA Shutdown Current, Battery is
Isolated From Load in Shutdown Mode
applications Replaces DC/DC Converters With Inductors
in Battery Powered Applications Like:
− Two Battery Cells to 3.3-V Conversion
− MP3 Portable Audio Players
− Battery-Powered Microprocessor
Systems
− Backup-Battery Boost Converters
− PDA’s, Organizers, and Cordless Phones
− Handheld Instrumentation
− Glucose Meters and Other Medical
Instruments ·
descriptionThe TPS6020x step-up, regulated charge pumps generate a 3.3-V ±4% output voltage from a 1.8-V to 3.6-V
input voltage. The devices are typically powered by two Alkaline, NiCd, or NiMH battery cells and operate down
to a minimum supply voltage of 1.6 V. Continuous output current is a minimum of 100 mA from a 2-V input. Only
four external capacitors are needed to build a complete low-ripple dc/dc converter. The push-pull operating
mode of two single-ended charge pumps assures the low output voltage ripple, as current is continuously
transferred to the output.
Figure 1. Typical Application Circuit
With Low-Battery Warning
OUTPUT
INPUT
1.6 V to 3.6 V
OFF/ON
TPS60204
TPS60204
PEAK OUTPUT CURRENT
INPUT VOLTAGE
1001.6 2.0 2.4 2.8
3.2 3.6
VI − Input Voltage − V
− Peak Output Current − mA1 µFPlease be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.