TPS2816DBVR ,Inverting High Speed MOSFET Driver with Active Pullup and Internal Regulator SLVS160C – ..
TPS2817DBV ,Non-inverting High Speed MOSFET Driver with Active Pullup and Internal Regulator SLVS160C – ..
TPS2817DBVR ,Non-inverting High Speed MOSFET Driver with Active Pullup and Internal Regulatormaximum ratings over operating temperature range (unless otherwise noted)Supply voltage range, V . ..
TPS2817DBVR ,Non-inverting High Speed MOSFET Driver with Active Pullup and Internal Regulator SLVS160C – ..
TPS2818DBVRG4 ,Inverting High Speed MOSFET Driver with Internal Regulator SLVS160C – ..
TPS2819DBVR ,Non-inverting High-Speed MOSFET Driver with Internal Regulator SLVS160C – ..
TS90115CT , 250mA CMOS Low Dropout Voltage Regulator
TS9011KCX , 250mA CMOS Low Dropout Voltage Regulator
TS9011PCT , 250mA Low Quiescent Current CMOS LDO
TS9011SCT , 250mA CMOS Low Dropout Voltage Regulator
TS9013KCW , 500mA CMOS Low Dropout Voltage Regulator
TS902AID ,INPUT/OUTPUT RAIL TO RAIL DUAL CMOS OP-AMPS (WITH STANDBY POSITION)ABSOLUTE MAXIMUM RATINGS Symbol Parameter Value Unit1)V18 VCC Supply voltage 2)V±18 Vid Differ ..
TPS2816DBVR
Inverting High Speed MOSFET Driver with Active Pullup and Internal Regulator
2-A Peak Output Current 4-V to 14-V Driver Supply Voltage Range;Internal Regulator Extends Range to 40 V
(TPS2816, TPS2817, TPS2818, TPS2819) 5-pin SOT-23 Package –40°C to 125°C Ambient-Temperature
Operating Range Highly Resistant to Latch-ups
descriptionThe TPS28xx single-channel high-speed MOS-
FET drivers are capable of delivering peak
currents of up to 2 A into highly capacitive loads.
High switching speeds (tr and tf = 14 ns typ) are
obtained with the use of BiCMOS outputs. Typical
threshold switching voltages are 2/3 and 1/3 ofCC . The design inherently minimizes shoot-
through current.
A regulator is provided on TPS2816 through TPS2819 devices to allow operation with supply inputs between
14 V and 40 V. The regulator output can be used to power other circuits, provided power dissipation does not
exceed package limitations. If the regulator is not required, VDD (the regulator input) should be connected toCC . The TPS2816 and TPS2817 input circuits include an active pullup circuit to eliminate the need for an
external resistor when using open-collector PWM controllers. The TPS2818 and TPS2819 are identical to the
TPS2816 and TPS2817, except that the active pullup circuit is omitted. The TPS2828 and TPS2829 are
identical to the TPS2818 and TPS2819, except that the internal voltage regulator is omitted, allowing quiescent
current to drop to less than 15 μA when the inputs are high or low.
The TPS28xx series devices are available in 5-pin SOT-23 (DBV) packages and operate over an ambient
temperature range of –40�C to 125�C.
AVAILABLE OPTIONSThe DBV package is available taped and reeled only.
OUT
GND
VCCNC
OUT
DBV PACKAGE
(TOP VIEW)
GND
TPS2828, TPS2829NC – No internal connection
