TPS2300IPWR ,3-13V Dual HotSwap IC w/ Independent Channel Circuit Breaking & Power Good Report, Act-Low EnablePWRGD1, PWRGD2 – PWRGD1 and PWRGD2 signal the presence of undervoltage conditions on VSENSE1and VSE ..
TPS2300IPWRG4 ,3-13V Dual HotSwap IC w/ Independent Channel Circuit Breaking & Power Good Report, Act-Low Enable 20-TSSOP -40 to 85Features of these devices, such asVO2+overcurrent protection (OCP), inrush current control,V2output ..
TPS2301IPW ,3-13V Dual HotSwap IC w/ Independent Channel Circuit Breaking & Power Good Report, Act-High Enable SLVS265H –FEBRUARY 2000–REVISED JULY 2013Table 2. Terminal Functions (continued)TERMINALI/O DESCRI ..
TPS2310IPW ,3-13V Dual HotSwap IC w/ Inter-dependent Channel Circuit Breaking & Pwr Good Report, Act-Low Enable SLVS275H –FEBRUARY 2000–REVISED JULY 2013Table 2. Terminal Functions (continued)TERMINALI/O DESCRI ..
TPS2311IPW ,3-13V Dual HotSwap IC w/ Inter-dependent Channel Circuit Breaking & Pwr Good Report, Act-High Enable SLVS275H –FEBRUARY 2000–REVISED JULY 2013Table 2. Terminal Functions (continued)TERMINALI/O DESCRI ..
TPS2320IDRG4 ,3-13V Dual Hot-Swap IC w/ Independent Channel Circuit Breaking, Act-Low Enable SLVS276F –MARCH 2000–REVISED JULY 2013DETAILED DESCRIPTIONDISCH1, DISCH2 – DISCH1 and DISCH2 shoul ..
TS81102G0CTP ,DMUX 8-/10-bit 2 GHz 1:4/8Applications: – Stand-alone Delay Adjust Cell for ADCs Sampling Instant Alignment Differential Dat ..
TS81102G0VTP ,DMUX 8-/10-bit 2 GHz 1:4/8Features• Programmable DMUX Ratio:– 1:4: Data Rate Max = 1 Gsps– PD (8b/10b) < 4.3/4.7 W (ECL 50Ω o ..
TS8121ALF , 10/100 BASE PULSE TRANSFORMER
TS8121ALF , 10/100 BASE PULSE TRANSFORMER
TS8121ALF , 10/100 BASE PULSE TRANSFORMER
TS8121ALF , 10/100 BASE PULSE TRANSFORMER
TPS2300IPW-TPS2300IPWG4-TPS2300IPWR-TPS2300IPWRG4
3-13V Dual HotSwap IC w/ Independent Channel Circuit Breaking & Power Good Report, Act-Low Enable
GATE1
GATE2
DGND
TIMER
VREG
VSENSE2
VSENSE1
AGND
ISENSE2
ISENSE1
DISCH1
DISCH2
ENABLE
PWRGD1
FAULT
ISET1
ISET2
PWRGD2
IN2
IN1
PW PACKAGE
(TOP VIEW)
typical applicationNOTE: Terminal 18 is active high on TPS2301.
VREG
IN1 ISET1 ISENSE1 GATE1 DISCH1
VSENSE1
PWRGD1
TIMER
VSENSE2DISCH2GATE2ISENSE2ISET2IN2
DGND
AGND
3 V − 5.5 V
3 V − 13 V
PWRGD2
TPS2300
ENABLE
FAULT
TPS2300
TPS2301
www.ti.com SLVS265H –FEBRUARY 2000–REVISED
DUAL HOT-SWAP POWER CONTROLLERS WITH INDEPENDENT CIRCUIT BREAKER
POWER-GOOD REPORTING
Checkfor Samples: TPS2300, TPS2301
1FEATURES Dual-Channel High-Side MOSFET Drivers IN1:3Vto13V; IN2:3Vto 5.5V Output dV/dt Control Limits Inrush Current Circuit-Breaker With Programmable
Overcurrent Threshold and Transient Timer Power-Good Reporting With Transient Filter CMOS- and TTL-Compatible Enable Input Low, 5-μA Standby Supply Current (Max) Availablein 20-Pin TSSOP Package 40°Cto 85°C Ambient Temperature Range Electrostatic Discharge Protection
APPLICATIONS Hot-Swap/Plug/Dock Power Management Hot-Plug PCI, Device Bay Electronic Circuit Breaker
DESCRIPTIONThe TPS2300 and TPS2301 are dual-channel hot-
swap controllers that use external N-channel
MOSFETs as high-side switches in power
applications. Features of these devices, such as
overcurrent protection (OCP), inrush current control,
output-power status reporting, and the ability to
discriminate between load transients and faults, are hot-swap applications. incorporate undervoltage lockout (UVLO) and power-good (PG) reporting and the statusof the output voltage rails during operation. Each enoughto fully enhance the N-channel rise times the MOSFETs, reducing power functionality combines the abilityto sense overcurrent allows designs such as DSPs, that may currents during fora programmable period.
