TPPM0115D ,Switch Mode Synchronous Buck Controllermaximum ratings over operating free-air temperature (unless otherwise noted)Unregulated input volta ..
TPPM0115DR ,Switch Mode Synchronous Buck Controllermaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
TPPM0125DBV ,150-mA Low Dropout Regulator with POK 5-SOT-23 0 to 70
TPPM0301DR ,Single-Output 400mA, 3.3V Low-Dropout (LDO) Regulator with Selectable 3.3V or Dual 5V Input TPPM0301 400-mA LOW-DROPOUT REGULATORWITH AUXILIARY POWER MANAGEMENTSLVS315 – SEPTEMBER 2000D PACK ..
TPPM0301DRG4 ,Single Output LDO, 400mA, Fixed(3.3V), Selectable 3.3V or Dual 5V Input, Reverse Current Blocking 8-SOIC 0 to 70maximum ratings over operating free-air temperature (unless otherwise noted)Supply voltage, 5-V mai ..
TPPM0302DGN ,Single-Output 400mA, 3.3V Low-Dropout (LDO) Regulator with Selectable 3.3V or Dual 5V Input & POKmaximum ratings over operating free-air temperature (unless otherwise noted)Supply voltage, 5-V mai ..
TS4851EIJT ,Mono 1W Speaker and Stereo 160mW Headset BTL Drivers with Digital Volume Control
TS4855EIJT , LOUDSPEAKER & HEADSET DRIVER WITH VOLUME CONTROL
TS4861IST ,STEREO HEADPHONE AMPLIFIER WITH STANDBY ACTIVE LOW
TS4861IST ,STEREO HEADPHONE AMPLIFIER WITH STANDBY ACTIVE LOW
TS486-1IST ,STEREO HEADPHONE AMPLIFIER WITH STANDBY ACTIVE LOW
TS486IDT ,100MW STEREO HEADPHONE AMPLIFIER WITH STANDBY MODE
TPPM0115-TPPM0115D-TPPM0115DR
Switch Mode Synchronous Buck Controller
1 V to 2.5 V ±2% Power Good Function (PWRGD) Input Voltage, 12 V ±5% Drive High Load Current With External
Components
applications PC Motherboard, Voltage Regulation for
System Power DDR Memory Supply (VDDQ or VTT) RDRAM Memory Supply (VDDQ) General Purpose Synchronous Switch
Mode Controller
descriptionThe TPPM0115 is a synchronous buck controller capable of driving two external power FETs 180° out of phase.
The device requires a minimum of external standard filter components and switching FETs to regulate the
desired output voltage. This is achieved with an internal switching frequency of 200 kHz (typical).
The TPPM0115 switch mode controller and associated circuitry provide efficient voltage regulation of greater
than 85%. The output voltage is set by two external resistors. During power up, when the output voltage reaches
90% of the desired value, the power good (PWRGD) output is transitioned high after a short delay of 1 ms to
5 ms. During power down, when the output voltage falls below 90% of the set value, the PWRGD output is pulled
low without any delay.
In the event the set output is in an over-voltage condition due to a system fault, the drive to the lower FET turns
on to correct the fault. There is a dead time between switching one FET ON while the other FET is switching
OFF to prevent cross conduction.
The TPPM0115 is capable of driving high static load currents with minimal ripple on the output (<2%). The phase
sense input is used to sense the flow of current through the inductor during flyback to minimize ripple on the
output.
To optimize output filter capacitance, the voltage mode control is based on a fixed ON time during the start of
the cycle and hysteretic control during load transients. This allows the device to respond and maintain the set
regulation voltage.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
NC − No internal connection
PHASE
DRVH
