TPIC2810 ,8-Bit LED Driver with I2C Interfacemaximum ratings over the recommended operating case temperature range (unlessotherwise noted)†Logic ..
TPIC2810D ,8-Bit LED Driver with I2C Interface SLIS109A − DECEMBER 2001 − REVISED SEPTEMBER 2002D PACKAGE ..
TPIC2810DG4 ,8-Bit LED Driver with I2C Interface 16-SOIC SLIS109A − DECEMBER 2001 − REVISED SEPTEMBER 2002D PACKAGE ..
TPIC2810DRG4 ,8-Bit LED Driver with I2C Interface 16-SOIC maximum ratings over the recommended operating case temperature range (unlessotherwise noted)†Logic ..
TPIC43T01 , THREE-PHASE BRUSHLESS MOTOR RPM CONTROLLERS
TPIC43T01DA , THREE-PHASE BRUSHLESS MOTOR RPM CONTROLLERS
TS3DV520ERHUR ,5-Channel Differential 10:20 Mux Switch for DVI/HDMI Applications 56-WQFN -40 to 85This device provides low and flat ON-state resistance (r ) and excellent ON-state resistance match. ..
TS3DV520ERHURG4 ,5-Channel Differential 10:20 Mux Switch for DVI/HDMI Applications 56-WQFN -40 to 85FEATURES• Compatible With HDMI v1.2a (Type A) DVI 1.0 • Rail-to-Rail Switching on Data I/O PortsHig ..
TS3DV520ERUAR ,5-Channel Differential 10:20 Mux Switch for DVI/HDMI Applications 42-WQFN RHU PACKAGE RUA PACKAGE(TOP VIEW) (TOP VIEW)42 41 40 39V 1 38 1BGND 1 48 0B1 CC 1A 2 47 1B0 1A 2 37 ..
TS3DV520RHUR ,5-Channel Differential 10:20 Mux Switch for DVI/HDMI Applications 56-WQFN -40 to 85FEATURESTQFN PACKAGE• Compatible With HDMI v1.2a (Type A) DVI 1.0(TOP VIEW)High-Speed Digital Inter ..
TS3L100DBQR ,Quad SPDT Wide Bandwidth LAN Switch with Low On-State Resistancemaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
TS3L100DR ,Quad SPDT Wide Bandwidth LAN Switch with Low On-State Resistancelogic diagram (positive logic)4 2YA IA03IA17 5YB IB06IB19 11YC IC010IC11214YDID013ID11SControlLogic ..
TPIC2810-TPIC2810D-TPIC2810DG4-TPIC2810DRG4
8-Bit LED Driver with I2C Interface
Drain Output ESD Protection... 3000 V Output Clamp Voltage ...40 V
descriptionThe TPIC2810 device is a monolithic, medium-
voltage, low-current, 8-bit shift register design to
drive low-side switched resistive loads such as
LEDs. The device is not recommended for
switching inductive loads.
This device contains an 8-bit, serial-in, parallel-out shift register that feeds an 8-bit D-type storage register. Data
transfers through the shift register via an I2C bus interface. Data is transferred into the data shift register only
after the group ID and device address have been verified. The subaddress directs the I2C bus interface to read
or write data to the device or transfer data to the output. When output enable (G) is held high, all drain outputs
are off. When G is held low, data from the output storage register is transparent to the output buffers. When data
in the output buffers is low, the DMOS transistor outputs are off. When data is high, the DMOS transistor outputs
have sink-current capability.
The TPIC2810 device has an internal power-up clear to initialize all registers to an off state when power is
applied to the device. It also has a thermal sensor to monitor the die temperature and shut the drain outputs
off, if an over current condition occurs.
Outputs are low-side, open-drain DMOS transistors with output ratings of 40 V and 100 mA continuous
sink-current capability. Each output provides a 210-mA maximum current limit at TC = 25°C. The current limit
decreases as the junction temperature increases for additional device protection. The device also provides up
to 3000 V of ESD protection on output terminals and 2000 V of ESD protection on input terminals when tested
using the human-body model.
The TPIC2810 device is characterized for operation over the operating case temperature range of −40°C to
125°C.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
DRAIN1
DRAIN2
DRAIN3
DRAIN6
DRAIN5
DRAIN4