TMS320LF2402APGS ,16-Bit Fixed-Point DSP with FlashBlock Diagram of the 2407A PLL-Based Clock Module . . . . . . . . . . . . . . . . . . . . . . 57DSP ..
TMS320LF2403APAGA ,16-Bit Fixed-Point DSP with FlashTMS320LF2407A,TMS320LF2406A,TMS320LF2403A,TMS320LF2402ATMS320LC2406A,TMS320LC2404A,TMS320LC240 ..
TMS320LF2403APAGS ,16-Bit Fixed-Point DSP with FlashTMS320LF2407A,TMS320LF2406A,TMS320LF2403A,TMS320LF2402ATMS320LC2406A,TMS320LC2404A,TMS320LC240 ..
TMS320LF2406APZA ,16-bit fixed point DSP with FlashTMS320LF2407A,TMS320LF2406A,TMS320LF2403A,TMS320LF2402ATMS320LC2406A,TMS320LC2404A,TMS320LC240 ..
TMS320LF2406APZAR ,16-bit fixed point DSP with Flashelectrical characteristics table77 Added Figure 23Changed parameter td(WRN) in switching characteri ..
TMS320LF2406PZA ,DSP CONTROLLERS
TPS54673PWPRG4 ,Low Input Voltage 6A Synchronous Buck Converter with Disabled Sinking During Start Upmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
TPS54680 ,Low Input Voltage 6A Continuous Tracking Synchronous Buck Converter for SequencingMAXIMUM RATINGS(1)over operating free-air temperature range unless otherwise notedTPS54680 UNITVIN, ..
TPS54680PWP ,Low Input Voltage 6A Synchronous Buck Converter for SequencingELECTRICAL CHARACTERISTICS over operating free-air temperature range unless otherwise notedPARAME ..
TPS54680PWPR ,Low Input Voltage 6A Synchronous Buck Converter for Sequencingmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
TPS54680PWPR ,Low Input Voltage 6A Synchronous Buck Converter for Sequencingfeatures are a true, high performance, voltage Power Good and Enableerror amplifier that enables m ..
TPS54680QPWPREP , Enhanced Product 3V to 6V Input Tracking Synchronous Buck Pwm Switcher 28-HTSSOP -40 to 125 SGLS212A –OCTOBER 2003–REVISED OCTOBER 2012THERMAL INFORMATIONTPS54680(1)THERMAL METRIC PWP UNITS2 ..
TMS320LF2402APGA-TMS320LF2402APGS
16-Bit Fixed-Point DSP with Flash
− Code-Compatible With F243/F241/C242− Instruction Set and Module CompatibleWith F240 Flash (LF) and ROM (LC) Device Options− LF240xA: LF2407A, LF2406A,LF2403A, LF2402A− LC240xA: LC2406A, LC2404A, LC2403A, LC2402A On-Chip Memory − Up to 32K Words x 16 Bits of FlashEEPROM (4 Sectors) or ROM − Programmable “Code-Security” Featurefor the On-Chip Flash/ROM− Up to 2.5K Words x 16 Bits ofData/Program RAM − 544 Words of Dual-Access RAM − Up to 2K Words of Single-Access RAM Boot ROM (LF240xA Devices)− SCI/SPI Bootloader Up to Two Event-Manager (EV) Modules(EVA and EVB), Each Includes: − Two 16-Bit General-Purpose Timers− Eight 16-Bit Pulse-Width Modulation(PWM) Channels Which Enable:− Three-Phase Inverter Control − Center- or Edge-Alignment of PWMChannels − Emergency PWM Channel ShutdownWith External PDPINTx Pin − Programmable Deadband (Deadtime)Prevents Shoot-Through Faults − Three Capture Units for Time-Stampingof External Events − Input Qualifier for Select Pins − On-Chip Position Encoder InterfaceCircuitry − Synchronized A-to-D Conversion− Designed for AC Induction, BLDC, Switched Reluctance, and Stepper MotorControl − Applicable for Multiple Motor and/or− 8 or 16 Multiplexed Input Channels− 500-ns MIN Conversion Time − Selectable Twin 8-State SequencersTriggered by Two Event Managers Controller Area Network (CAN) 2.0B Module(LF2407A, 2406A, 2403A) Serial Communications Interface (SCI) 16-Bit Serial Peripheral Interface (SPI)(LF2407A, 2406A, LC2404A, 2403A) Phase-Locked-Loop (PLL)-Based ClockGeneration Up to 40 Individually Programmable, Multiplexed General-Purpose Input/Output(GPIO) Pins Up to Five External Interrupts (Power DriveProtection, Reset, Two Maskable Interrupts) Power Management: − Three Power-Down Modes − Ability to Power Down Each PeripheralIndependently Real-Time JTAG-Compliant Scan-BasedEmulation, IEEE Standard 1149.1† (JTAG) Development Tools Include: − Texas Instruments (TI) ANSI C Compiler,Assembler/Linker, and Code ComposerStudio Debugger− Evaluation Modules − Scan-Based Self-Emulation (XDS510)− Broad Third-Party Digital Motor ControlSupport Package Options − 144-Pin LQFP PGE (LF2407A) − 100-Pin LQFP PZ (2406A, LC2404A)− 64-Pin TQFP PAG (LF2403A, LC2403A,LC2402A) − 64-Pin QFP PG (2402A) Extended Temperature Options (A and S)− A: − 40°C to 85°C− S: − 40°C to 125°CPlease be aware that an important notice concerning availability, standard warranty, and use in critical applications ofTexas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Code Composer Studio and XDS510 are trademarks of Texas Instruments.
Other trademarks are the property of their respective owners.
