TLV2231IDBVR ,Single LinCMOS(TM) Rail-To-Rail uPower Operational Amplifier TLV2231, TLV2231Y Advanced LinCMOS RAIL-TO-RAILLOW-POWER SINGLE OPERATIONAL AMPLIFIERSSLOS158D – ..
TLV2231IDBVT ,Single LinCMOS(TM) Rail-To-Rail uPower Operational Amplifiermaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
TLV2241ID ,Single Micropower, 2.5-V, RRIO, Single Supply Amplifierelectrical characteristics specified at 2.7 V, 5 V and 12 V. The 2.5-V operation makes it compatibl ..
TLV2241IDBVR ,Single Micropower, 2.5-V, RRIO, Single Supply Amplifiermaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
TLV2241IDBVRG4 ,Single Micropower, 2.5-V, RRIO, Single Supply AmplifierTLV2241, TLV2242, TLV2244FAMILY OF 1-m A/Ch RAIL-TO-RAIL INPUT/OUTPUTOPERATIONAL AMPLIFIERSSLOS329C ..
TLV2241IDBVTG4 ,Single Micropower, 2.5-V, RRIO, Single Supply Amplifier 5-SOT-23 -40 to 125electrical characteristics specified at 2.7 V, 5 V and 12 V. The 2.5-V operation makes it compatibl ..
TMS320VC5510AGGWA1 ,Digital Signal Processor
TMS320VC5510AGGWA2 ,Digital Signal Processor
TMS320VC5510AZGW2 ,Digital Signal Processor
TMS320VC5510GGW1 ,Digital Signal Processor
TMS32C6203BGNZA250 ,Fixed-Point Digital Signal ProcessorFeaturesCompatible (Motorola)− Byte-Addressable (8-, 16-, 32-Bit Data)− 8-Bit Overflow Protectio ..
TMS32C6414DGLZ6E3 ,Fixed-Point Digital Signal ProcessorTMS320C6414, TMS320C6415, TMS320C6416FIXED-POINT DIGITAL SIGNAL PROCESSORSSPRS146N − FEBRUARY 2001 ..
TLV2231-TLV2231CDBVR-TLV2231CDBVT-TLV2231IDBVR-TLV2231IDBVT
Single LinCMOS(TM) Rail-To-Rail uPower Operational Amplifier
5-V Operation Common-Mode Input Voltage Range
Includes Negative Rail High Gain Bandwidth ...2 MHz at
VDD = 5 V With 600-Ω Load High Slew Rate... 1.6 V/μs at VDD = 5 V Wide Supply Voltage Range
2.7 V to 10 V Macromodel Included
descriptionThe TLV2231 is a single low-voltage operational amplifier available in the SOT-23 package. It offers 2 MHz of
bandwidth and 1.6 V/μs of slew rate for applications requiring good ac performance. The device exhibits
rail-to-rail output performance for increased dynamic range in single or split supply applications. The TLV2231
is fully characterized at 3 V and 5 V and is optimized for low-voltage applications.
The TLV2231, exhibiting high input impedance and low noise, is excellent for small-signal conditioning of
high-impedance sources, such as piezoelectric transducers. Because of the micropower dissipation levels
combined with 3-V operation, these devices work well in hand-held monitoring and remote-sensing
applications. In addition, the rail-to-rail output feature with single- or split-supplies makes this family a great
choice when interfacing with analog-to-digital converters (ADCs). The device can also drive 600-Ω loads for
telecom applications.
With a total area of 5.6mm2 , the SOT-23 package only requires one-third the board space of the standard 8-pin
SOIC package. This ultra-small package allows designers to place single amplifiers very close to the signal
source, minimizing noise pick-up from long PCB traces. TI has also taken special care to provide a pinout that
is optimized for board layout (see Figure 1). Both inputs are separated by GND to prevent coupling or leakage
paths. The OUT and IN– terminals are on the same end of the board for providing negative feedback. Finally,
gain setting resistors and the decoupling capacitor are easily placed around the package.
GND
Figure 1. Typical Surface Mount Layout for a Fixed-Gain Noninverting AmplifierPlease be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
IN–
VDD–/GND
OUT
