TLP715 ,Photocoupler (photo-IC output)TLP715 TOSHIBA PHOTOCOUPLER GaAℓAs IRED & PHOTO-IC TLP715 Isolated Bus Drivers Unit in mm4.58±0 ..
TLP716 ,PhotocouplersPin Configuration (top view) 5 1:Anode 1 6 VCC 3:Cathode GND SHIELD 4 2 4:GND 5 0.1uF bypass capaci ..
TLP718 ,Photocoupler (photo-IC output)TLP718 TOSHIBA PHOTOCOUPLER GaAℓAs IRED & PHOTO-IC TLP718 Isolated Bus Drivers Unit in mm4.58±0 ..
TLP719 ,PhotocouplersTLP719 TOSHIBA PHOTOCOUPLER GaAlAs IRED + PHOTO- IC Preliminary TLP719 DIGITAL LOGIC GROUND ISOL ..
TLP719 ,PhotocouplersPIN CONFIGURATION (Top view) • Isolation voltage : 5000 Vrms (Min.) • Common mode Transient Immun ..
TLP719F ,Photocoupler (photo-IC output)Pin Configuration (top view) Clearance 8.0 mm (min) Insulation Thickness 0.4 mm (min) 1: ANODE 16 ..
TMS320C6711GFN-150 , FLOATING-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6712DZDP150 ,Floating-Point Digital Signal Processors 272-BGA FeaturesClockGeneratorModule-- HardwareSupportforIEEED ADedicatedGeneral-PurposeInput/OutputSingle- ..
TMS320C6713BGDP225 ,Floating-Point Digital Signal Processor SPRS294B − OCTOBER 2005 − REVISED JUNE 2006 Highest ..
TMS320C6713BGDP300 ,Floating-Point Digital Signal Processorelectrical characteristics over recommended ranges ofmemory map summary . . . . . . . . . . . . . . ..
TMS320C6713BGDP-300 ,Floating-Point Digital Signal ProcessorFeatures2− Native Instructions for IEEE 754 Two Inter-Integrated Circuit Bus (I C Bus)− Single ..
TMS320C6713BGDPA200 , FLOATING-POINT DIGITAL SIGNAL PROCESSORS
TLP715
Photocoupler (photo-IC output)
TLP715
Unit in mm
Weight:0.26 g (typ.)
4.58±0.25
4.0
+0.25 −
0.20
9.7±0.3
6.8±0.25
0.4±0.1
1.27±0.2 1.25±0.25
7.62±0.25
3.65
+0.15
0.25
0.25±
1 2 3
6 5 4
11-5J1
TOSHIBA 11-5J1
0.05
+0.10 TOSHIBA PHOTOCOUPLER GaAℓAs IRED & PHOTO-IC
TLP715 Isolated Bus Drivers
High Speed Line Receivers
Microprocessor System Interfaces
The Toshiba TLP715 consists of a GaAℓAs light-emitting diode and an
integrated high-gain, high-speed photodetector. This unit is a 6-pin SDIP . The
TLP715 is 50% smaller than the 8-PIN DIP and meets the reinforced insulation
class requirements of international safety standards. Therefore the mounting
area can be reduced in equipment requiring safety standard certification.
The detector has a totem pole output stage to provide both source and sink
driving. The detector IC has an internal shield that provides a guaranteed
common-mode transient immunity of 10 kV / μs.
The TLP715 is buffer logic type. For inverter logic type, the TLP718 is in
line-up. Buffer logic output (totem pole output) Guaranteed performance over temperature : −40 to 100°C Power supply voltage : 4.5 to 20 V Input current: IFLH = 3mA (Max) Switching time ( tpLH / tpHL) : 250 ns (Max) Common-mode transient immunity : ±10 kV / μs (Min) Isolation voltage : 5000 Vrms (Min)
z UL recognized UL1577, File No.E67349
z c-UL recognized CSA Component Acceptance Service No. 5A, File No.E67349
z Option (D4)
TÜV recognized / VDE under application : DIN EN60747-5-5
Maximum Operating Insulation Voltage : 890 VPK
Highest Permissible Over Voltage : 8000 VPK
(Note) : When a EN60747-5-5 approved type is needed,
Please designate “Option(D4)” Construction Mechanical Rating
Truth Table
Pin Configuration (Top View) 0.1 μF bypass capacitor must be
connected between pins 6 and 4. (Note 5)
Schematic VCC
GND
ICC SHIELD
1+
IF
Tr1
Tr2 4
1:ANODE
2:N.C.
3:CATHODE
4:GND
5:Vo (Output)
6:Vcc
