TLC59116IPWR ,16-Bit Fast-Mode Plus (FM+) I2C-Bus Constant-Current LED Sink Driver 28-TSSOP -40 to 85Features• 16 LED Drivers (Each Output Programmable at • Supports Hot InsertionOff, On, Programmable ..
TLC5911PZP ,LED Driver W/Shift Registers, Data Latch, On-Chip PLL For Gray Scale Generation & Constant Currentblock diagramXOEBCENADCLK DOUT(9−0)DCLKDPOLXENABLE ControlXDPOUTDIN(9−0), 1 x 10 bit B.C.16 x 10 bi ..
TLC5916IPW ,8-Bit Constant-Current LED Sink Driver 16-TSSOP -40 to 125Block Diagram... 143 Description....... 19.3 Feature Description.... 144 Revision History........ 2 ..
TLC5916IPW ,8-Bit Constant-Current LED Sink Driver 16-TSSOP -40 to 125Maximum Ratings(1)over operating free-air temperature range (unless otherwise noted)MIN MAX UNITV S ..
TLC5916IPW ,8-Bit Constant-Current LED Sink Driver 16-TSSOP -40 to 125Features 3 DescriptionThe TLC591x Constant-Current LED Sink Drivers are1• Eight Constant-Current Ou ..
TLC5916IPWG4 ,8-Bit Constant-Current LED Sink Driver 16-TSSOP -40 to 125Features....... 1• Added Abstract section.. 1• Changed resistor value in Single Implementation diag ..
TMP47C670N , CMOS 4-BIT MICROCONTROLLER
TMP47C858F , CMOS 4-BIT MICROCONTROLLER
TMP47C860N , CMOS 4-BIT MICROCONTROLLER
TMP47C860N , CMOS 4-BIT MICROCONTROLLER
TMP47C870N , CMOS 4-BIT MICROCONTROLLER
TMP47C870N , CMOS 4-BIT MICROCONTROLLER
TLC59116IPWR
16-Bit Fast-Mode Plus (FM+) I2C Bus Constant-Current LED Sink Driver
OUT14
OUT1
OUT15
OUT0
TLC59116 OUT13A0-A3
R-EXT
VDD
RESET
SDA
SCL
RESET
SDA
SCL
MCU
+5V SHDN
GND
OUT
SENSE
+3.3V
+3.3V
Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
TLC59116SLDS157E –FEBRUARY 2008–REVISED DECEMBER 2014
TLC59116 16-Channel FM+I2 C-Bus Constant-Current LED Sink Driver Features 16 LED Drivers (Each Output Programmableat • Supports Hot Insertion
Off, On, Programmable LED Brightness,or • Low Standby Current
Programmable Group Dimming and Blinking • 3.3-Vor 5-V Supply VoltageMixed With Individual LED Brightness) • 5.5-V Tolerant Inputs• 16 Constant-Current Output Channels • Offeredin 28-Pin Thin Shrink Small-Outline• 256-Step (8-Bit) Linear Programmable Brightness Package (TSSOP) (PW) and 32-Pin QuadPer LED Output Varying From Fully Off (Default) Flatpack No Lead (QFN)to Maximum Brightness Usinga 97-kHz PWM • –40°Cto85°C OperationSignal 256-Step Group Brightness Control Allows
2 ApplicationsGeneral Dimming [Usinga 190-Hz PWM Signal • GamingFrom Fully Offto Maximum Brightness (Default)] Small Signage• 256-Step Group Blinking With Frequency Industrial EquipmentProgrammable From 24 Hzto 10.73s and Duty
Cycle From 0%to 99.6%
3 Description• Four Hardware Address Pins Allow 14 TLC59116 The TLC59116is anI2C bus controlled 16-channelDevicesto Be Connectedto SameI2C Bus LED driver thatis optimized for red/green/blue/amber• Four Software-ProgrammableI2C Bus Addresses (RGBA) color mixing and backlight application. Each(One LED Group Call Address and Three LED LED output has its own 8-bit resolution (256 steps)Sub Call Addresses) Allow Groupsof Devicesto fixed-frequency individual PWM controller thatBe Addressedat Same Timein Any Combination operates at 97 kHz, witha duty cycle that is
adjustable from 0%to 99.6%.• Software Reset Feature (SWRST Call) Allows
Deviceto Be Reset ThroughI2C Bus
Device Information(1)• Upto14 Possible Hardware-Adjustable IndividualI2C Bus Addresses Per Device, So That EachDevice Can Be Programmed• Open-Load and Overtemperature Detection Mode
(1) Forall available packages, see the orderable addendumatto Detect Individual LED Errors
the endofthe datasheet.• Output State Change Programmable on
Acknowledgeor Stop Commandto Update
TLC59116 Typical ApplicationOutputs Byte-by-ByteorAllat Same Time (Default Changeon Stop) Output Current Adjusted Throughan External
Resistor Constant Output Current Range:5 mAto 120 mA Voltage: 17V Requires No External Capabilityon Buses
