TLC1550IDW ,10-Bit, 164 kSPS ADC Parallel Out, Direct I/F to DSP/uProcessor, 10 Ch. SLAS043G − MAY 1991 ..
TLC1550IFNR , 10-BIT ANALOG-TO-DIGITAL CONVERTERS WITH PARALLEL OUTPUTS
TLC1551IFN ,10-Bit, 164 kSPS ADC Parallel Out, Direct I/F to DSP/uProcessor, 10 Ch. SLAS043G − MAY 1991 ..
TLC1551INW , 10-BIT ANALOG-TO-DIGITAL CONVERTERS WITH PARALLEL OUTPUTS
TLC2201AID ,Advanced LinCMOS(TM) Low-Noise Precision Operational Amplifier
TLC2201AIDRG4 , Advanced LinCMOSE LOW-NOISE PRECISION OPERATIONAL AMPLIFIERS
TMG16CQ60 , TRIAC(Through Hole/Non-isolated)
TMG25C60L , TRIAC(Through Hole/Non-isolated)
TMG25CQ60J , Full wave AC control applications.
TMG3C60D , TRIAC(Surface Mount Device/Non-isolated)
TMG3CQ60D , TRIAC(Surface Mount Device/Non-isolated)
TMG40C60L , designed for full wave AC control applications
TLC1550IDW
10-Bit, 164 kSPS ADC Parallel Out, Direct I/F to DSP/uProcessor, 10 Ch.
Interface Either External or Internal Clock Can Be
Used Conversion Time ...6 µs Total Unadjusted Error... ±1 LSB Max
CMOS Technology
descriptionThe TLC1550x and TLC1551 are data acquisition
analog-to-digital converters (ADCs) using a 10-bit,
switched-capacitor, successive-approximation net-
work. A high-speed, 3-state parallel port directly
interfaces to a digital signal processor (DSP) or
microprocessor (µP) system data bus. D0 through
D9 are the digital output terminals with D0 being
the least significant bit (LSB). Separate power
terminals for the analog and digital portions
minimize noise pickup in the supply leads.
Additionally, the digital power is divided into two
parts to separate the lower current logic from the
higher current bus drivers. An external clock can be
applied to CLKIN to override the internal system
clock if desired.
The TLC1550I and TLC1551I are characterized for
operation from − 40°C to 85°C. The TLC1550M is
characterized over the full military range of −55°C
to 125°C.
AVAILABLE OPTIONSThis device contains circuits to protect its inputs and outputs against damage due to high static voltages or electrostatic fields. These
circuits have been qualified to protect this device against electrostatic discharges (ESD) of up to 2 kV according to MIL-STD-883C,
Method 3015; however, it is advised that precautions be taken to avoid application of any voltage higher than maximum-rated
voltages to these high-impedance circuits. During storage or handling, the device leads should be shorted together or the device
should be placed in conductive foam. In a circuit, unused inputs should always be connected to an appropriated logic voltage level,
preferably either VCC or ground.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
