TL026 ,Differential High-Frequency Amplifier With AGCmaximum ratings may cause permanent damage to the device. This is a stress rating only, andfunction ..
TL026CD ,Differential High-Frequency Amplifier With AGCTL026C DIFFERENTIAL HIGH-FREQUENCY AMPLIFIER WITH AGC SLFS007A – JUNE 1985 – REVISED JULY 1990D OR ..
TL026CP ,Differential High-Frequency Amplifier With AGCmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
TL026CPSR ,Differential High-Frequency Amplifier With AGCelectrical characteristics at 25°C operating free-air temperature, V = ±6 V, V = 0, REF OUT pinCC+ ..
TL032ACDR ,Enhanced-JFET Low-Power Low-Offset Dual Operational Amplifier
TL032AIDR ,Enhanced-JFET Low-Power Low-Offset Dual Operational Amplifier
TLS1233N ,Video Preamplifier Systemmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage, V ..
TLS1255N ,Video Preamplifier System 28-PDIP
TLS251 , TLG251, TLY251, TLO251, TLS251
TLS336T ,LED DISPLAY
TLS337T ,LED DISPLAY
TLS346T ,LED DISPLAY
TL026-TL026CD-TL026CP-TL026CPSR
Differential High-Frequency Amplifier With AGC
Wide AGC Range... 50 dB Typ 3-dB Bandwidth... 50 MHz Other Characteristics Similar to NE592 anduA733
descriptionThis device is a monolithic two-stage high-
frequency amplifier with differential inputs and
outputs.
Internal feedback provides wide bandwidth, low phase distortion, and excellent gain stability. Variable gain
based on signal summation provides large AGC control over a wide bandwidth with low harmonic distortion.
Emitter-follower outputs enable the device to drive capacitive loads. All stages are current-source biased to
obtain high common-mode and supply-voltage rejection ratios. The gain may be electronically attenuated by
applying a control voltage to the AGC pin. No external compensation components are required.
This device is particularly useful in TV and radio IF and RF AGC circuits, as well as magnetic-tape and disk-file
systems where AGC is needed. Other applications include video and pulse amplifiers where a large AGC range,
wide bandwidth, low phase shift, and excellent gain stability are required.
The TL026C is characterized for operation from 0°C to 70°C.
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†Supply voltage, VCC+ (see Note 1) 8 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Supply voltage, VCC– (see Note 1) – 8 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Differential input voltage ±5 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Common-mode input voltage ±6 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output current ±10 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous total dissipation See Dissipation Rating Table. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating free-air temperature range 0°C to 70°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range – 65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature range 1,6 mm (1/16 inch) from case for 10 seconds 260°C. . . . . . . . . . . . . . . . . . . . . . . . . .
†Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. This is a stress rating only, and
functional operation of the device at these or any other conditions beyond those indicated in the recommended operating conditions section of
this specification is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: All voltages are with respect to the midpoint of VCC+ and VCC– except differential input and output voltages.
DISSIPATION RATING TABLECC
OUT–CC
OUT+
symbol
AGC
IN +
IN –
REF OUT
OUT+
OUT–
