THS3111ID ,Single, Low Noise, High Voltage Current-Feedback Amplifierfeatures a power-down pin (PD) that• High Output Current Drive: 260 mAputs the amplifier in low-pow ..
THS3112 ,Dual, Low-Noise, High Output Current, 175-MHz Amplifierfeatures a low-power shutdown mode,• Low-Power Shutdown (THS3115)consuming only 300-mA shutdown qui ..
THS3112ID ,Dual, Low-Noise, High Output Current, 110-MHz AmplifierELECTRICAL CHARACTERISTICSOver operating free-air temperature range, T = +25°C, V = ±15 V, R = 750Ω ..
THS3115ID ,Dual, Low-Noise, High Output Current, 110-MHz Amplifier with ShutdownMaximum Ratings may cause permanent damage to the device. These are stress ratingsonly, and functio ..
THS3115IPWPRG4 ,Dual, Low-Noise, High Output Current, 110-MHz Amplifier with Shutdown 14-HTSSOP -40 to 85ELECTRICAL CHARACTERISTICSOver operating free-air temperature range, T = +25°C, V = ±15 V, R = 750Ω ..
THS3120CDGNR ,Single, Low Noise, High Output Drive, 475mA Current-Feedback Amplifier with Power-downThis integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated cir ..
TLC5615ID ,10-Bit, 12.5 us DAC, Serial Input, Low PowerSLAS142E–OCTOBER 1996–REVISED JUNE 2007ABSOLUTE
TLC5615IDG4 ,10-bit, single-channel, low-power DAC with 12.5us settling time and power-on reset 8-SOIC -40 to 85MAXIMUM RATINGS(1)over operating free-air temperature range (unless otherwise noted)UNITSupply volt ..
TLC5615IDR ,10-Bit, 12.5 us DAC, Serial Input, Low PowerBLOCK DIAGRAM_+DAC+REFIN2 OUT_(Voltage Output)AGNDR RPower-ONReset10-Bit DAC RegisterControlLogicC ..
TLC5615IDR ,10-Bit, 12.5 us DAC, Serial Input, Low PowerELECTRICAL CHARACTERISTICSover recommended operating free-air temperature range, V = 5V ± 5%, V = 2 ..
TLC5615IDRG4 ,10-bit, single-channel, low-power DAC with 12.5us settling time and power-on reset 8-SOIC -40 to 85MAXIMUM RATINGS(1)over operating free-air temperature range (unless otherwise noted)UNITSupply volt ..
TLC5615IP ,10-Bit, 12.5 us DAC, Serial Input, Low PowerSLAS142E–OCTOBER 1996–REVISED JUNE 2007This integrated circuit can be damaged by ESD. Texas Instrum ..
THS3111ID
Single, Low Noise, High Voltage Current-Feedback Amplifier
75 W
75 W
75 W
n Lines
VO(1)
VO(n)
1 kW
DIFFERENTIAL GAIN
NUMBER OF LOADS
VIDEO DISTRIBUTION AMPLIFIER APPLICATIONNTSC
Gain = 2,
RF = 1 kW,
VS = ±15 V,
40 IRE − NTSC and PAL,
Worst Case ±100 IRE Ramp
0.4 12 3 4 5
Number of 150 W LoadsPAL
NTSC
Gain = 2,
RF = 1 kW,
VS = ±15 V,
40 IRE − NTSC and PAL,
Worst Case ±100 IRE Ramp
DIFFERENTIAL PHASE
NUMBER OF LOADS
1 kW
THS3110
THS3111
www.ti.com........................................................................................................................................ SLOS422E –SEPTEMBER 2003–REVISED OCTOBER 2009
LOW-NOISE, HIGH-VOLTAGE, CURRENT-FEEDBACK
OPERATIONAL AMPLIFIERS
Checkfor Samples: THS3110 THS3111
1FEATURES DESCRIPTION
23• Low Noise The THS3110 and THS3111 are low-noise,
high-voltage, current-feedback amplifiers designedto
– 2-pA/√Hz Noninverting Current Noiseoperate overa wide supply rangeof±5Vto ±15V for
– 10-pA/√Hz Inverting Current Noise today's high performance applications.
– 3-nV/√Hz Voltage NoiseThe THS3110 featuresa power-down pin (PD) that
• High Output Current Drive: 260 mA puts the amplifierin low-power standby mode, and
• High Slew Rate: 1300 V/μs lowers the quiescent current from 4.8 mAto 270 μA.
(RL= 100Ω, VO=8 VPP) These amplifiers provide well-regulated ac
• Wide Bandwidth:90 MHz(G=2,RL= 100Ω) performance characteristics. The unity-gain
bandwidth of 100 MHz allows for good distortion
• Wide Supply Range:±5Vto ±15Vcharacteristics below 10 MHz. Coupled with
• Power-Down Feature: (THS3110 Only) 1300-V/μs slew rate, the THS3110 and THS3111
amplifiers allow for high output voltage swings
APPLICATIONS frequencies.
• Video Distribution The THS3110 and THS3111 are offered
• Power FET Driver SOIC-8 (D) and the MSOP-8 (DGN) packages
• Pin Driver PowerPAD™.
Capacitive Load Driver space
space
