THS1009IDA ,10-Bit, 8 MSPS ADC Dual Ch., Parallel DSP/uP, Channel Autoscan, Low PowerFEATURESTHS1009 consists of two analog inputs, which are Simultaneous Sampling of Two Single-Ended ..
THS1030CPW ,10-Bit, 30 MSPS ADC Single Ch., Pin Comp. w/TLC876, Out of Range Indicator, PowerDownmaximum ratings over operating free-air temperature (unless otherwise noted)Supply voltage range: A ..
THS1030CPW ,10-Bit, 30 MSPS ADC Single Ch., Pin Comp. w/TLC876, Out of Range Indicator, PowerDownmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
THS1030CPWRG4 ,10-Bit, 30 MSPS ADC Single Ch., Pin Comp. w/TLC876, Out of Range Indicator, PowerDown 28-TSSOP 0 to 70maximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
THS1030IDW ,10-Bit, 30 MSPS ADC Single Ch., Pin Comp. w/TLC876, Out of Range Indicator, PowerDownmaximum ratings over operating free-air temperature (unless otherwise noted)Supply voltage range: A ..
THS1030IPW ,10-Bit, 30 MSPS ADC Single Ch., Pin Comp. w/TLC876, Out of Range Indicator, PowerDown SLAS243E − NOVEMBER 1999 − REVISED ..
TLC549ID ,8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch.features include versatile control logic, an on-chip sample-and-hold circuit thatcan operate automa ..
TLC549IDR ,8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch. TLC548C, TLC548I, TLC549C, TLC549I 8-BIT ANALOG-TO-DIGITAL CONVERTERSWITH SERIAL CONTROLSLAS067C – ..
TLC549IDRG4 ,8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch. 8-SOIC TLC548C, TLC548I, TLC549C, TLC549I 8-BIT ANALOG-TO-DIGITAL CONVERTERSWITH SERIAL CONTROLSLAS067C – ..
TLC549IP ,8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch.block diagram1REF+3 8-BitREF–Analog-to8DigitalSample2Converter 8andOutputANALOG IN8-to-1 Data(Switc ..
TLC549IPS ,8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch. TLC548C, TLC548I, TLC549C, TLC549I 8-BIT ANALOG-TO-DIGITAL CONVERTERSWITH SERIAL CONTROLSLAS067C – ..
TLC549IPSR ,8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch.features include versatile control logic, an on-chip sample-and-hold circuit thatcan operate automa ..
THS1009IDA
10-Bit, 8 MSPS ADC Dual Ch., Parallel DSP/uP, Channel Autoscan, Low Power
�������
SLAS287A – AUGUST 2000 – REVISED DECEMBER 2002
������� � ������ ������ � ����� ������������ ��������
����������������� ���������
FEATURES Simultaneous Sampling of Two Single-Ended
Signals or One Differential Signals or
Combination of Both Signal-to-Noise and Distortion Ratio: 59 dB
at fI = 2 MHz Differential Nonlinearity Error: ±1 LSB Integral Nonlinearity Error: ±1 LSB Auto-Scan Mode for Two Inputs 3-V or 5-V Digital Interface Compatible Low Power: 216 mW Max at 5 V Power Down: 1 mW Max 5-V Analog Single Supply Operation Internal Voltage References ...
50 PPM/°C
and ±5% Accuracy Glueless DSP Interface Parallel μC/DSP Interface
APPLICATIONS Radar Applications Communications Control Applications High-Speed DSP Front-End Automotive Applications
DESCRIPTIONThe THS1009 is a CMOS, low-power, 10-bit, 8 MSPS
analog-to-digital converter (ADC). The speed,
resolution, bandwidth, and single-supply operation are
suited for applications in radar, imaging, high-speed
acquisition, and communications. A multistage
pipelined architecture with output error correction logic
provides for no missing codes over the full operating
temperature range. Internal control registers allow for
programming the ADC into the desired mode. The
THS1009 consists of two analog inputs, which are
sampled simultaneously. These inputs can be selected
individually and configured to single-ended or
differential inputs. Internal reference voltages for the
ADC (1.5 V and 3.5 V) are provided. An external
reference can also be chosen to suit the dc accuracy
and temperature drift requirements of the application.
The THS1009C is characterized for operation from 0°C
to 70°C, and the THS1009I is characterized for
operation from –40°C to 85°C.DD
BGND
RA0
RA1
CONV_CLK
SYNC
RESET
AINP
AINM
REFIN
REFOUT
REFP
REFM
AGNDDD
CS0
CS1
WR (R/W)DD
DGND
DA PACKAGE
(TOP VIEW)
ORDERING INFORMATION
www.ti.com
