![](/IMAGES/ls12.gif)
TDF1779A ,DUAL 2-A SOURCE DRIVERTDF1779ADUAL 2-A SOURCE DRIVER. OUTPUT CURRENT UP TO 2.5 A. WIDE RANGE OF SUPPLY VOLTAGE : + 8 VTO ..
TDF5140AP ,Brushless DC motor drive circuitGENERAL DESCRIPTION• Thermal protectionThe TDF5140A is a bipolar integrated circuit used to drive• ..
TDF5140AP/C1 ,TDF5140A; Brushless DC motor drive circuit
TDF8712T ,8-bit digital-to-analog converters
TDK5100 ,ASK/FSK Transmitter 868/433 MHzcharacteristics.Terms of delivery and rights to change design reserved.Due to technical requirement ..
TDK5101F ,315 MHz ASK/FSK Transmitter in 10-pin Packagecharacteristics.Terms of delivery and rights to change design reserved.Due to technical requirement ..
TK65015MTL ,STEP-UP VOLTAGE CONVERTER WITH VOLTAGE MONITOR
TK65A10N1 ,Power MOSFET (N-ch single 60V<VDSS≤150V)Absolute Maximum Ratings (Note) (T = 25 = 25 = 25 = 25 unless otherwise specified) unless other ..
TK65E10N1 ,Power MOSFET (N-ch single 60V<VDSS≤150V)Absolute Maximum Ratings (Note) (T = 25 = 25 = 25 unless otherwise specified) unless otherwise s ..
TK65S04K3L ,Power MOSFET (N-ch single 30V<VDSS≤60V)Absolute Maximum Ratings (Note) (T = 25 = 25 = 25 = 25 unless otherwise specified) unless other ..
TK6A45DA ,Power MOSFET (N-ch 250V<VDSS≤500V)Absolute Maximum Ratings (Note) (T = 25 = 25 = 25 = 25 unless otherwise specified) unless other ..
TK6A50D ,Power MOSFET (N-ch 500V<VDSS≤700V)Absolute Maximum Ratings (Ta = 25°C) Ф0.2 M A 2.54 2.54 Characteristics Symbol Rating Unit 1 2 3 ..
TDF1779A
DUAL 2-A SOURCE DRIVER
TDF1779AApril 1993
DUAL 2-A SOURCE DRIVER OUTPUT CURRENT UP TO 2.5 A. WIDE RANGE OF SUPPLY VOLTAGE : + 8 V
TO + 26 V. CAN WITHSTAND OVERVOLTAGES OF AS
HIGH AS 60 V BETWEEN VCC AND GROUND. OUTPUT VOLTAGE CAN SWING TO LOWER
THAN GROUND. "SENSE" AND "ALARM" OUTPUTS ARE OPEN
COLLECTOR OUTPUTS
DESCRIPTIONThe TDF1779A is a dual source driver delivering
hihg output currents and the capability to drive highly
inductive loads (Electrovalves, contractors, re-
lays...).
This device is essentially blow-out proof, each out-
put is protected against short-circuits. If internal dis-
sipation becomes too high, drivers will shut down to
prevent excessive heating. An "ALARM" output is
provided to indicate the action of the thermal protec-
tion. To reactivate the power outputs, the reset input
must be forced to low state.
"SENSE" information of both power outputs are
ORed together and then processed internally.
A "STROBE" input is also provided to offer the pos-
sibility of disabling the power outputs.
PIN CONNECTION1/9
BLOCK DIAGRAM
MAXIMUM RATINGS
THERMAL CHARACTERISTICS
TDF1779A2/9
ELECTRICAL OPERATING CHARACTERISTICS(VCC = + 24V, –40o C < Tj < + 85o C, unless otherwise specified)
TDF1779A3/9
AVAILABLE OUTPUT CURRENT OUTPUT SATURATION VOLTAGE
AVAILABLE ALARM OR SENSE OUTPUT
CURRENTS
POWER SUPPLY CURRENT
TDF1779A4/9
TDF1779A5/9
TYPICAL APPLICATION WITH TDF1779A TWO LOADS 12 V - 2 A
MAIN FEATURES This application is protected against for short circuit and overload.
The load disconnection is detected when inputs E1 and E2 are low and the sense output is high.
When thermal protection is actived the pin 9 is low. Inputs are TTL compatible.
Sense output, Alarm output are open collector.
TDF1779A6/9