ST62T52CM6 ,8-BIT MICROCONTROLLER ( MCU ) WITH OTP, ROM, FASTROM, EPROM, A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER AND EEPROMapplications. All ST62xx devices are OTP devices offer all the advantages of user pro-based on a bu ..
ST62T52CM6 ,8-BIT MICROCONTROLLER ( MCU ) WITH OTP, ROM, FASTROM, EPROM, A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER AND EEPROMGENERAL DESCRIPTION1.1 INTRODUCTIONThe ST62T52C and ST62T62C devices is low cost fined in the progr ..
ST62T53B , 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, EEPROM AND SPI
ST62T55CB6 ,8-BIT MICROCONTROLLER ( MCU ) WITH OTP, ROM, FASTROM, EPROM, A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER, EEPROM AND SPI
ST62T55CB6 ,8-BIT MICROCONTROLLER ( MCU ) WITH OTP, ROM, FASTROM, EPROM, A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER, EEPROM AND SPI
ST62T55CB6 ,8-BIT MICROCONTROLLER ( MCU ) WITH OTP, ROM, FASTROM, EPROM, A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER, EEPROM AND SPI
STP5NB90 ,NABSOLUTE MAXIMUM RATINGSSymbol Parameter Value UnitSTP5NB90 STP5NB90FPV Drain-source Voltage (V =0) ..
STP5NC50 ,N-CHANNEL 500VELECTRICAL CHARACTERISTICS (TCASE = 25 °C UNLESS OTHERWISE SPECIFIED)OFFSymbol Parameter Test Condi ..
STP5NC50FP ,N-CHANNEL 500VSTP5NC50 - STP5NC50FPSTB5NC50 - STB5NC50-12 2N-CHANNEL 500V - 1.3Ω - 5.5A TO-220/FP/D PAK/I PAKPowe ..
STP5NC70Z ,N-CHANNEL 700V 1.8 OHM 4.6A TO-220/TO-220FP/I2PAK ZENER-PROTECTED POWERMESH III MOSFETELECTRICAL CHARACTERISTICS (TCASE = 25 °C UNLESS OTHERWISE SPECIFIED)OFFSymbol Parameter Test Condi ..
STP5NC70ZFP ,N-CHANNEL 700V 1.8 OHM 4.6A TO-220/TO-220FP/I2PAK ZENER-PROTECTED POWERMESH III MOSFETABSOLUTE MAXIMUM RATINGSSymbol Parameter Value UnitSTP(B)5NC70Z(-1) STP5NC70ZFPV Drain-source Volta ..
STP5NC90Z ,N-CHANNEL 900V 2.1 OHM 4.6A TO-220 TO-220FP I2PAK D2PAK ZENER-PROTECTED POWERMESH III MOSFETABSOLUTE MAXIMUM RATINGSSymbol Parameter Value UnitSTP(B)5NC90Z(-1) STP5NC90ZFPV Drain-source Volta ..
ST62E62CF1-ST62P52CM3-ST62T52CM3-ST62T52CM6-ST62T62CB6-ST62T62CM6
8-BIT MICROCONTROLLER ( MCU ) WITH OTP, ROM, FASTROM, EPROM, A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER AND EEPROM
Rev. 3.0
ST62T52C
ST62T62C/E62C8-BIT OTP/EPROM MCUs WITH A/D CONVERTER,
SAFE RESET , AUTO-RELOAD TIMER AND EEPROM 3.0 to 6.0V Supply Operating Range 8 MHz Maximum Clock Frequency -40 to +125°C Operating Temperature Range Run, Wait and Stop Modes 5 Interrupt Vectors Look-up Table capability in Program Memory Data Storage in Program Memory:
User selectable size Data RAM: 128 bytes Data EEPROM: 64 bytes (none on ST62T52C) User Programmable Options 9 I/O pins, fully programmable as: Input with pull-up resistor Input without pull-up resistor Input with interrupt generation Open-drain or push-pull output Analog Input 5 I/O lines can sink up to 30mA to drive LEDs or
TRIACs directly 8-bit Timer/Counter with 7-bit programmable
prescaler 8-bit Auto-reload Timer with 7-bit programmable
prescaler (AR Timer) Digital Watchdog Oscillator Safe Guard Low Voltage Detector for Safe Reset 8-bit A/D Converter with 4 analog inputs On-chip Clock oscillator can be driven by Quartz
Crystal Ceramic resonator or RC network User configurable Power-on Reset One external Non-Maskable Interrupt ST626x-EMU2 Emulation and Development
System (connects to an MS-DOS PC via a
parallel port)
DEVICE SUMMARY
Page
Page
Page
