SSM6P36TU ,Small-signal MOSFET 2 in 1Electrical Characteristics (Ta = 25°C) (Q1, Q2 Common) Characteristics Symbol Test Conditions Min T ..
SSM6P40TU ,Small-signal MOSFET 2 in 1Absolute Maximum Ratings (Ta = 25 °C) (Q1,Q2 Common) Characteristics Symbol Rating Unit Drain-sourc ..
SSM6P41FE ,Small-signal MOSFET 2 in 1Electrical Characteristics (Ta = 25°C) (Q1, Q2 Common) Characteristics Symbol Test Conditions Min. ..
SSM6P54TU ,Small-signal MOSFET 2 in 1Absolute Maximum Ratings (Ta = 25°C) 43Characteristics Symbol Rating Unit Drain-Source voltage V -2 ..
SSM70T03GJ , N-channel Enhancement-mode Power MOSFET
SSM9926GEO , N-CHANNEL ENHANCEMENT-MODE POWER MOSFETS
STC128 , NPN Silicon Transistor
STC12C5404 , STC12C5410AD
STC12C5406AD , STC12C5410AD
STC13003 , NPN POWER TRANSISTORS
STC13007 , NPN POWER TRANSISTORS
STC2073F , NPN Silicon Transistor
SSM6P36TU
Small-signal MOSFET 2 in 1
SSM6P36TU
TOSHIBA Field Effect Transistor Silicon P Channel MOS Type
SSM6P36TU Power Management Switches
• 1.5-V drive Low ON-resistance: Ron = 3.60 Ω (max) (@VGS = -1.5 V)
: Ron = 2.70 Ω (max) (@VGS = -1.8 V)
: Ron = 1.60 Ω (max) (@VGS = -2.8 V)
: Ron = 1.31 Ω (max) (@VGS = -4.5 V)
Absolute Maximum Ratings (Ta = 25 °C) Note: Using continuously under heavy loads (e.g. the application of
high temperature/current/voltage and the significant change in
temperature, etc.) may cause this product to decrease in the
reliability significantly even if the operating conditions (i.e.
operating temperature/current/voltage, etc.) are within the
absolute maximum ratings.
Please design the appropriate reliability upon reviewing the
Toshiba Semiconductor Reliability Handbook (“Handling
Precautions”/“Derating Concept and Methods”) and individual
reliability data (i.e. reliability test report and estimated failure rate, etc).
Note1: Total rating Mounted on an FR4 board (25.4 mm × 25.4 mm × 1.6 mm, Cu Pad: 645 mm2)
Marking Equivalent Circuit (top view)
Handling Precaution When handling individual devices (which are not yet mounted on a circuit board), ensure that the environment is
protected against static electricity. Operators should wear anti-static clothing, and containers and other objects that come
into direct contact with devices should be made of anti-static materials.
Usage Considerations Let Vth be the voltage applied between gate and source that causes the drain current (ID) to below −1 mA for the
SSM6P36TU). Then, for normal switching operation, VGS(on) must be higher than Vth, and VGS(off) must be lower than
Vth. This relationship can be expressed as: VGS(off) < Vth < VGS(on).
Unit: mm
Weight: 7.0 mg (typ.)
6 5 4
1 2 3 4 3
