SN74CBTLV3384 ,Low-Voltage 10-Bit FET Bus Switchlogic diagram (positive logic)3 21A1 SW 1B111 101A5 1B5SW11OE14 152A1 SW 2B123222A5 SW 2B5132OEsimp ..
SN74CBTLV3384 ,Low-Voltage 10-Bit FET Bus SwitchSN74CBTLV3384LOW-VOLTAGE 10-BIT FET BUS SWITCHSCDS059G − MARCH 1998 − REVISED JUNE 2004DBQ, DGV, DW ..
SN74CBTLV3384DBQR ,Low-Voltage 10-Bit FET Bus Switchmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
SN74CBTLV3384DGVR ,Low-Voltage 10-Bit FET Bus SwitchSN74CBTLV3384LOW-VOLTAGE 10-BIT FET BUS SWITCHSCDS059G − MARCH 1998 − REVISED JUNE 2004DBQ, DGV, DW ..
SN74CBTLV3384PW ,Low-Voltage 10-Bit FET Bus Switch/sc/package.FUNCTION TABLE(each 5-bit bus switch)INPUTS INPUTS/OUTPUTS1OE 2OE 1B1−1B5 2B1−2B5L L 1A ..
SN74CBTLV3384PWR ,Low-Voltage 10-Bit FET Bus Switchmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SN74TVC16222ADL ,22-Bit Voltage Clamp SCDS087G − APRIL 1999 − REVISED APRIL 2005DGG, DGV, OR DL PACKAGE Membe ..
SN74TVC16222ADLR ,22-Bit Voltage Clampmaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
SN74TVC16222DLR , 22-BIT VOLTAGE CLAMP
SN74TVC3010DGVR ,10-Bit Voltage Clampelectrical characteristics; therefore, any one of them canbe used as the reference transistor. Sinc ..
SN74TVC3010DGVRG4 ,10-Bit Voltage Clamp 24-TVSOP -40 to 85maximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
SN74TVC3010PW ,10-Bit Voltage Clampmaximum ratings over operating free-air temperature range (unless otherwise noted)Input voltage ran ..
SN74CBTLV3384-SN74CBTLV3384DBQR-SN74CBTLV3384DGVR-SN74CBTLV3384PW-SN74CBTLV3384PWR
Low-Voltage 10-Bit FET Bus Switch
SN74CBTLV3384
LOW-VOLTAGE 10-BIT FET BUS SWITCH
SCDS059G − MARCH 1998 − REVISED JUNE 2004
5-Ω Switch Connection Between Two Ports Rail-to-Rail Switching on Data I/O Ports Ioff Supports Partial-Power-Down Mode
Operation Latch-Up Performance Exceeds 250 mA Per
JESD 17 ESD Protection Exceeds JESD 22
− 2000-V Human-Body Model (A114-A)
− 200-V Machine Model (A115-A)
description/ordering informationThe SN74CBTLV3384 provides ten bits of
high-speed bus switching. The low on-state
resistance of the switch allows connections to be
made with minimal propagation delay.
The device is organized as dual 5-bit bus switches
with separate output-enable (OE) inputs. It can be
used as two 5-bit bus switches or one 10-bit bus switch. When OE is low, the associated 5-bit bus switch is on,
and A port is connected to B port. When OE is high, the switch is open, and the high-impedance state exists
between the two ports.
This device is fully specified for partial-power-down applications using Ioff. The Ioff feature ensures that
damaging current will not backflow through the device when it is powered down. The device has isolation during
power off.
To ensure the high-impedance state during power up or power down, OE shall be tied to VCC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
ORDERING INFORMATION Package drawings, standard packing quantities, thermal data, symbolization, and PCB design
guidelines are available at www.ti.com/sc/package.
FUNCTION TABLE
(each 5-bit bus switch)
DBQ, DGV, DW, OR PW PACKAGE
(TOP VIEW)1OE
1B1
1A1
1A2
1B2
1B3
1A3
1A4
1B4
1B5
1A5
GND
VCC
2B5
2A5
2A4
2B4
2B3
2A3
2A2
2B2
2B1
2A1
2OE
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
