SN65MLVD205D ,MULTIPOINT-LVDS LINE DRIVERS AND RECEIVERSfeatures to address multipointapplications. Driver output current has been increased to support dou ..
SN65MLVD206DG4 ,Half-Duplex M-LVDS Transceiver 8-SOIC -40 to 85ELECTRICAL CHARACTERISTICSover recommended operating conditions (unless otherwise noted)(1) (2)PARA ..
SN65MLVD206DR ,Half-Duplex M-LVDS TransceiverFEATURES APPLICATIONS• Low-Power High-Speed Short-Reach• Low-Voltage Differential 30-Ω to 55-Ω Line ..
SN65MLVD207D ,Full-Duplex M-LVDS Transceivermaximum ratings may cause permanent damage to the device. These are stress ratingsonly, and functio ..
SN65MLVD207DG4 ,Full-Duplex M-LVDS Transceiver 14-SOIC -40 to 85FEATURES APPLICATIONS• Low-Power High-Speed Short-Reach• Low-Voltage Differential 30-Ω to 55-Ω Line ..
SN65MLVD207DR ,Full-Duplex M-LVDS TransceiverELECTRICAL CHARACTERISTICSover recommended operating conditions (unless otherwise noted)(1) (2)PARA ..
SN74HCT245PWLE ,Octal Bus Transceivers With 3-State OutputsFeatures... 18.4 Device Functional Modes...... 92 Applications..... 19 Application and Implementati ..
SN74HCT245PWR ,Octal Bus Transceivers With 3-State OutputsMaximum Ratings(1)over operating free-air temperature range (unless otherwise noted)MIN MAX UNITV S ..
SN74HCT257D ,Quadruple 2-Line To 1-Line Data Selectors/Multiplexers With 3-State Outputs SCLS072D ..
SN74HCT257DR ,Quadruple 2-Line To 1-Line Data Selectors/Multiplexers With 3-State Outputsmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SN74HCT273DBLE ,Octal D-Type Flip-Flops With Clearlogic diagram, each flip-flop (positive logic)CCDTGTGQCCCCTGCLK(I)TGCC CCR2POST OFFICE BOX 655303 • ..
SN74HCT273DBR ,Octal D-Type Flip-Flops With Clearlogic diagram (positive logic)1D 2D 3D 4D 5D 6D 7D 8D3 4 7 8 13 14 17 1811CLK1D 1D 1D 1D 1D 1D 1D 1 ..
SN65MLVD205D
Full-Duplex M-LVDS Transceiver
– Receiver: 30 mW Typical Meets or Exceeds Current Revision of
M-LVDS Standard TIA/EIA–899 for
Multipoint Data Interchange Controlled Driver Output Voltage Transition
Times for Improved Signal Quality –1-V to 3.4-V Common-Mode Voltage Range
Allows Data Transfer With up to 2 V of
Ground Noise Type-1 Receivers Incorporate 25 mV of
Hysteresis
for Drivers and 5 ns for Receivers Power-Up/Down Glitch-Free Driver Driver Handles Operation Into a
Continuous Short Circuit Without Damage Bus Pins High Impedance When Disabled
or VCC ≤ 1.5 V 200-Mbps Devices Available
(SN65MLVD201, 203, 206, and 207) VCC
GND
SN65MLVD200D (Marked as MF200)
SN65MLVD204D (Marked as MF204)
(TOP VIEW)
logic diagram (positive logic)
SN65MLVD202D (Marked as MLVD202)
SN65MLVD205D (Marked as MLVD205)
(TOP VIEW)GND
GNDCC
VCC
NC – No internal connection
Y
SN65MLVD202, SN65MLVD205SN65MLVD200, SN65MLVD204Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
†The signaling rate of a line is the number of voltage transitions that are made per second expressed in bps (bits per second) units.
