SN65LVDM051QDRG4Q1 ,Automotive Catalog High-Speed Differential Line Drivers and Receivers 16-SOIC -40 to 125 SGLS128A − JULY 2002 − ..
SN65LVDM051QDRQ1 ,Dual LVDS Transmitter/Receivermaximum ratings” may cause permanent damage to the device. These are stress ratings only, andfuncti ..
SN65LVDM1677DGG ,16-Channel LVDM TransceiverSLLS430D–NOVEMBER 2000–REVISED JUNE 2007These devices have limited built-in ESD protection. The lea ..
SN65LVDM1677DGGR ,16-Channel LVDM TransceiverFEATURESSN65LVDM1676DGG ( Marked as LVDM1676)• Sixteen Low-Voltage Differential Transceivers.SN65LV ..
SN65LVDM176D ,Half-Duplex LVDM TransceiverSLLS320D–DECEMBER 1998–REVISED JULY 2000DISSIPATION RATING TABLET ≤ 25°C DERATING FACTOR T = 85°CA ..
SN65LVDM176DGKR ,Half-Duplex LVDM TransceiverSLLS320D–DECEMBER 1998–REVISED JULY 2000These devices have limited built-in ESD protection. The lea ..
SN74HC595ANSR , 8-BIT SHIFT REGISTERS WITH 3-STATE OUTPUT REGISTERS
SN74HC595ANSR , 8-BIT SHIFT REGISTERS WITH 3-STATE OUTPUT REGISTERS
SN74HC595D ,8-Bit Shift Registers With 3-State Output RegistersLogic Diagram (Positive Logic)13OE12RCLK10SRCLR11SRCLK14SER 1D 3R15C1 C3 QAR 3S2S2R 3R1C2 C3 QBR 3S ..
SN74HC595DBRG4 ,8-Bit Shift Registers With 3-State Output Registers 16-SSOP -40 to 85Features 3 DescriptionThe SNx4HC595 devices contain an 8-bit, serial-in,1• 8-Bit Serial-In, Paralle ..
SN74HC595DG4 ,8-Bit Shift Registers With 3-State Output Registers 16-SOIC -40 to 85Maximum Ratings.. 512.1 Layout Guidelines.... 167.2 ESD Ratings........ 512.2 Layout Example....... ..
SN74HC595DR ,8-Bit Shift Registers With 3-State Output RegistersSample & Support &Product Tools &TechnicalCommunityBuyFolder Documents SoftwareSN54HC595,SN74HC595S ..
SN65LVDM051QDRG4Q1-SN65LVDM051QDRQ1
Dual LVDS Transmitter/Receiver
and Receivers Signaling Rates up to 500 Mbps Bus-Terminal ESD Exceeds 12 kV Operates From a Single 3.3 V Supply Low-Voltage Differential Signaling With
Typical Output Voltages of 340 mV With a
50-Ω Load Valid Output With as Little as 50-mV Input
Voltage Difference Propagation Delay Times
− Driver: 1.7 ns Typ
− Receiver: 3.7 ns Typ Power Dissipation at 200 MHz
− Driver: 50 mW Typical
− Receiver: 60 mW Typical LVTTL Input Levels Are 5 V Tolerant Driver Is High Impedance When Disabled or
With VCC < 1.5 V Receiver Has Open-Circuit Fail Safe descriptionThe SN65LVDM050, and SN65LVDM051 are differential line drivers and receivers that use low-voltage
differential signaling (LVDS) to achieve signaling rates as high as 500 Mbps (per TIA/EIA-644 definition). These
circuits are similar to TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts, except that the output
current of the drivers is doubled. This modification provides a minimum differential output voltage magnitude
of 247 mV across a 50-Ω load simulating two transmission lines in parallel. This allows having data buses with
more than one driver or with two line termination resistors. The receivers detect a voltage difference of 50 mV
with up to 1 V of ground potential difference between a transmitter and receiver.
The intended application of these devices and signaling techniques is point-to-point and multipoint, baseband
data transmission over a controlled impedance media of approximately 100 Ω of characteristic impedance. The
transmission media may be printed-circuit board traces, backplanes, or cables.
GND
1DE
GND
VCC
2DE
SN65LVDM051QDQ1 (Marked as LVDM051Q)
(TOP VIEW) 1A 1Y
1DE3 2Y
2DE5Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
