SN54HCT540J ,Octal Buffers And Line Drivers With 3-State Outputs SN54HCT540, SN74HCT540 OCTAL BUFFERS AND LINE DRIVERSWITH 3-STATE OUTPUTSSCLS008C – MARCH 1984 – R ..
SN54HCT541J ,Octal Buffers And Line Drivers With 3-State Outputs SCLS306C − JANUARY 1996 − REVI ..
SN54HCT574J , OCTAL EDGE-TRIGGERED D-TYPE FLIP-FLOPS WITH 3-STATE OUTPUTS
SN54L98J , 4-BIT DATA SELECTORS/STORAGE REGISTERS
SN54L99J , 4-BIT RIGHT-SHIFT LEFT-SHIFT REGISTERS
SN54LS00J ,QUAD 2-INPUT NAND GATEFeatures 3 DescriptionThe SNx4xx00 devices contain four independent,1• Package Options Include:2-in ..
SN74F541DWR ,Octal Buffers/Drivers With 3-State Outputs SN54F541, SN74F541 OCTAL BUFFERS/DRIVERS WITH 3-STATE OUTPUTSSDFS021A – D3126, JANUARY 1989 – REVI ..
SN74F541N ,Octal Buffers/Drivers With 3-State Outputsmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SN74F541N ,Octal Buffers/Drivers With 3-State Outputsmaximum ratings over operating free-air temperature range (unless otherwise noted)Supply voltage ra ..
SN74F541NSR ,Octal Buffers/Drivers With 3-State Outputsfeatures inputs and outputs onA8 Y7opposite sides of the package to facilitate 10 11GND Y8printed-c ..
SN74F541NSR ,Octal Buffers/Drivers With 3-State Outputslogic diagram (positive logic)1OE11 &OE11919 EN OE2OE22 182 18 A1 Y11A1 Y13 17A2 Y24 16A3 Y35 15A4 ..
SN74F543DBR ,Octal Registered Transceiver With 3-State Outputs SN74F543 OCTAL REGISTERED TRANSCEIVER WITH 3-STATE OUTPUTS SDFS025B – D2942, MARCH 1987 – REVISED ..
SN54HCT540J
Octal Buffers And Line Drivers With 3-State Outputs
Low Input Current of 1 μA Max Inputs Are TTL-Voltage Compatible High-Current 3-State Outputs InterfaceDirectly With System Bus or Can Drive Up
To 15 LSTTL Loads Data Flow-Through Pinout (All Inputs on
Opposite Side From Outputs)
description/ordering informationThese octal buffers and line drivers are designed to have the performance of the ’HCT240 devices and a pinout
with inputs and outputs on opposite sides of the package. This arrangement greatly facilitates printed circuit
board layout.
The 3-state control gate is a 2-input NOR. If either output-enable (OE1 or OE2) input is high, all eight outputs
are in the high-impedance state. The ’HCT540 devices provide inverted data at the outputs.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup
resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
ORDERING INFORMATION†Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are
available at www.ti.com/sc/package.
FUNCTION TABLE
(each buffer/driver)Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
GND
