SLE66CX322P ,Chipcard Security Controllercharacteristics.Terms of delivery and rights to technical change reserved.We hereby disclaim any an ..
SLF10145T-100M2R5-H , For Power Line SMD
SLF10145T-100M2R5-H , For Power Line SMD
SLF10145T-101M1R0-PF , Inductors for Power Circuits Wound Ferrite SLFseries
SLF10145T-102MR29-PF , Inductors for Power Circuits Wound Ferrite SLFseries
SLF10145T-102MR29-PF , Inductors for Power Circuits Wound Ferrite SLFseries
SMDA05.TB , Unidirectional TVS Array for Protection of Four Lines
SMDA05.TB , Unidirectional TVS Array for Protection of Four Lines
SMDA05-6 ,TVSarray SeriesMAXIMUM RATINGSCASE 751Rating Symbol Value Unit PLASTICPeak Power Dissipation P 400 WpkMARKING DIAG ..
SMDA05-6.TBT , Unidirectional TVS Array for Protection of Six Lines
SMDA05C ,TVSarray SeriesMAXIMUM RATINGS MARKING DIAGRAM8Rating Symbol Value UnitXXXPeak Power Dissipation P 300 WpkAYWW8 x ..
SMDA05C.TB , Bidirectional TVS Array for Protection of Four Lines
SLE66CX322P
Chipcard Security Controller
Edition 2001
Published by Infineon Technologies AG, CC Applications Group
St.-Martin-Strasse 53, D-81541 München© Infineon Technologies AG 2001
All Rights Reserved.
Attention please!The information herein is given to describe certain components and shall not be considered as warranted
characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding
circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
InformationFor further information on technology, delivery terms and conditions and prices please contact your nearest InfineonTechnologies Office in Germany or our Infineon Technologies Representatives world-wide (see address list).
WarningsDue to technical requirements components may contain dangerous substances. For information on the types inquestion please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express writtenapproval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure ofthat life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices
or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protecthuman life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.
16-Bit Security Controller with MMU in 0.22µm CMOS Technologie
136 Kbytes ROM, 4352 bytes RAM, 32 Kbytes EEPROM
Features· 16-bit microcomputer in 0.22 µm CMOS
technology· Instruction set opcode compatible with
standard SAB 8051 processor· Enhanced 16-bit arithmetic· Additional powerful instructions optimizedfor chip card applications· Dedicated, non-standard architecture with
execution time 6 times faster (18 timesby PLLmax) than standard SAB 8051processor at external same clock·
134 Kbyte User ROM for applicationprograms· Additional 2 Kbyte reserved ROM forResource Management System (RMS+light) with intelligent EEPROM write/erase
routines·
32 Kbytes Slim-EEPROM·
4 Kbytes XRAM, 256 Bytes IRAM·
Memory Management and Protection
Unit (MMU)· CRC Module· Interrupt Module· Two 16-bit Autoreload Timer·
PLL· Power saving sleep mode·
External clock frequency 1 to 7.5 MHz
for internal clock £ 10 MHz·
UART for handling serial interface inaccordance with ISO/IEC 7816 part 3
supporting transmission protocols T=1and T=0I/O routines realized in software executable· Supply voltage range: 2.7 V to 5.5 V· Current consumption< 10mA @ 5.5 V
< 6 mA @ 3.3 V· Temperature range: -25 to +85°C· ESD protection larger than 6 kV
Slim-EEPROM· Reading, erasing and writing byte by byte· Flexible page mode for 1 to 64 byteswrite/erase operation· 32 bytes security area (OTP)· Fast personalization mode· Erase + Write time < 4.5 ms·
Minimum of 500.000 write/erase cycles at
25°C· Data retention for a minimum of 10 years· EEPROM programming voltage generated on
chip
Memory Management and Protection UnitAddressable memory up to 1 Mbyte· Separation OS (system) and application
(user)· System routines called by traps· OS can restrict access to peripherals in
application mode· Code execution from XRAM possible
Security Features
Operation state monitoring mechanismLow and high voltage sensors· Frequency sensors and filters· Glitch Sensor
Memory Security· 16 bytes security PROM, hardware protected· Unique chip identification number for each
chip· MED - memory encryption/decryption devicefor XRAM, ROM and EEPROM· True Random Number Generator with
Firmware test function· Security optimised layout and layout
scrambling
TestmodeIrreversible Lock - Out of testmode
Anti SnoopingHW-countermeasures against SPA/DPA-,
Timing- and DFA-attacks (differential fault
analysis – DFA)· CRC – Module· Non standard dedicated Smart Card CPU
– Core
SupportHW-& SW-Tools (Emulator, ROM Monitor,
Card Emulator, Simulator, Softmasking)· Application notes
Supported StandardsISO/IEC 7816· EMV 2000· GSM 11.1x· ETS I TS 102 221
Document ReferencesConfidential Data Book SLE 66CxxxP· Qualification reportchip-layout (die size, orientation,...)
of package, etc.· Qualification report module
Development Tools OverviewDevelopment Kit SDK CC
CE66PRM66P
Hitex or ET66P KSC
Package
Ordering Information
TypePackage1VoltageRangeFrequency Range
(ext. Clockfrequency)SLE 66C322P M5
2.7 V - 5.5 V– 25°C to + 70°C
Production sites:Dresden SLE66CxxxPUMC Taiwan SLE66CxxxPU
Pin Configuration
Figure 1: Pin Configuration
Pin Definitions and FunctionsFunctionOperating voltageReset input
