PMB5699 ,SMARTi U SingleApplications– No IF-SAW filter UTRA FDD standard– Easiest frequency concept Power class 3 Lowest cu ..
PMB5699 ,SMARTi U Singleapplications according 3GPP Temperature range -25 to 85°C(FDD, 2100 MHz) requirements. P-VQFN-40 l ..
PMB8825 ,Dual-Band Power Amplifier for WLAN SystemsBlock DiagramV VCC5 CC6 BREFst nd1 Driver 2 DriverOutputStage StageStageRF RF Frequency BandsInters ..
PMB8870 , single chip baseband IC
PMB8876 ,S-GOLD2-Multimedia Engine with Advanced EDGE Modem FunctionalityFeature flexibility through upgrade options with multimedia chips GTT/TTYvia standardized interfac ..
PMBD2838 ,High-speed double diodes
PSOT03 , STANDARD CAPACITANCE TVS ARRAY
PSOT03C , STANDARD CAPACITANCE TVS ARRAY
PSOT03LC , 500 WATT ULTRA LOW CAPACITANCE TVS ARRAY
PSOT03LC-LF-T7 , ULTRA LOW CAPACITANCE TVS ARRAY
PSOT03-LF-T7 , STANDARD CAPACITANCE TVS ARRAY
PSOT05C , STANDARD CAPACITANCE TVS ARRAY
PMB5699
SMARTi U Single
MARTi U–First Single-Chip UMTS/W-CDMA RF-Transceiver
Infineon has designed the first single-chip UMTS/ W-CDMA RF-transceiver
IC SMARTi U to be used in mobile applications according 3GPP
GeneralSupply voltage: 2.7 - 3.0 V3-Wire bus programmableLow external component count
How to reach us:
http://www.infineon.com
Published by
Infineon Technologies AG,
St.-Martin-Strasse 53,
D-81669 München
© Infineon Technologies AG 2004.
All Rights Reserved.
Attention please!
The information herein is given to describe certain components
and shall not be considered as a guarantee of characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not
limited to warranties of non-infringement, regarding circuits,
descriptions and charts stated herein.
Information
For further information on technology, delivery terms
Warnings
Due to technical requirements components may contain dangerous
substances. For information on the types in question please contact
your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-
support devices or systems with the express written approval of
Infineon Technologies, if a failure of such components can reason-
ably be expected to cause the failure of that life-support device or
system, or to affect the safety or effectiveness of that device or sys-
tem. Life support devices or systems are intended to be implanted
Block Diagram SMARTi U
This datasheet has been downloaded from:
www.ic-phoenix.com
Datasheets for electronic components.
