OPA692IDBVR ,Wideband, Fixed Gain Buffer Amplifier with DisableELECTRICAL CHARACTERISTICS: V = ±5V (Cont.)SBoldface limits are tested at +25°C.G = +2 (–IN grounde ..
OPA692IDG4 ,Wideband, Fixed Gain Buffer Amplifier with Disable 8-SOIC FEATURES DESCRIPTIONThe OPA692 provides an easy to use, broadband fixed gain* FLEXIBLE SUPPLY RANGE ..
OPA693 ,Ultra-Wideband, Fixed Gain Video Buffer Amplifier with Disablefeatures makes the OPA693 an ideal RGB linedriver or single-supply undersampling Analog-to-Digital ..
OPA693ID ,Ultra-Wideband, Fixed Gain Video Buffer Amplifier with DisableMAXIMUM RATINGSELECTROSTATICPower Supply ....... ±6.5VDCDISCHARGE SENSITIVITY(2)Internal Power Diss ..
OPA693IDBVR ,Ultra-Wideband, Fixed Gain Video Buffer Amplifier with DisableFEATURESThe OPA693 provides an easy to use, broadband, fixed gain* VERY HIGH BANDWIDTH (G = +2): 70 ..
OPA693IDG4 ,Ultra-Wideband, Fixed Gain Video Buffer Amplifier with Disable 8-SOIC -40 to 85ELECTRICAL CHARACTERISTICS: V = ±5VSBoldface limits are tested at 25°C.G = +2 (–IN grounded) and R ..
P8255A-5 , PROGRAMMABLE PERIPHEAL INTERFACE
P8255A-5 , PROGRAMMABLE PERIPHEAL INTERFACE
P8255A-5 , PROGRAMMABLE PERIPHEAL INTERFACE
P8255A-5 , PROGRAMMABLE PERIPHEAL INTERFACE
P8279 , PROGRAMMABLE KEYBOARD / DISPLAY INTERFACE
P8279 , PROGRAMMABLE KEYBOARD / DISPLAY INTERFACE
OPA692ID-OPA692IDBVR-OPA692IDG4
Wideband, Fixed Gain Buffer Amplifier with Disable
www.ti.com
OPA692SBOS236E – MARCH 2002 – REVISED DECEMBER 2008
DESCRIPTIONThe OPA692 provides an easy to use, broadband fixed gain
video buffer amplifier. Depending on the external connec-
tions, the internal resistor network may be used to provide
either a fixed gain of +2 video buffer or a gain of +1 or –1
voltage buffer. Operating on a very low 5.1mA supply cur-
rent, the OPA692 offers a slew rate and output power
normally associated with a much higher supply current. A
new output stage architecture delivers high output current
with minimal headroom and crossover distortion. This gives
exceptional single-supply operation. Using a single +5V
supply, the OPA692 can deliver a 1V to 4V output swing with
over 120mA drive current and > 200MHz bandwidth. This
combination of features makes the OPA692 an ideal RGB
line driver or single-supply Analog-to-Digital Converter (ADC)
input driver.
The low 5.1mA supply current for the OPA692 is precisely
trimmed at +25°C. This trim, along with low drift over tem-
perature, ensures a lower maximum supply current than
competing products that report only a room temperature
nominal supply current. System power may be further re-
duced by using the optional disable control pin. Leaving this
disable pin open, or holding it HIGH, gives normal operation.
If pulled LOW, the OPA692 supply current drops to less than
150μA while the I/O pins go into a high-impedance state.
FEATURES FLEXIBLE SUPPLY RANGE:
+5V to +12V Single Supply±2.5V to ±6V Dual Supplies
INTERNALLY FIXED GAIN: +2 or ±1 HIGH BANDWIDTH (G = +2): 225MHz LOW SUPPLY CURRENT: 5.1mA LOW DISABLED CURRENT: 150μA HIGH OUTPUT CURRENT: 190mA OUTPUT VOLTAGE SWING: ±4.0V SOT23-6 AVAILABLE
Wideband, Fixed Gain
Video BUFFER AMPLIFIER With DisablePlease be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
APPLICATIONS BROADBAND VIDEO LINE DRIVERS MULTIPLE LINE VIDEO DA PORTABLE INSTRUMENTS ADC BUFFERS ACTIVE FILTERS
OPA692 RELATED PRODUCTS Video
Out
75Ω
75Ω
RG-59
75Ω
75Ω
RG-59
75Ω
75Ω
RG-59
75Ω
75Ω
RG-59
75Ω
OPA692SO-8
G = +25V
Video
225MHz, 4-Output Component Video DA
