OPA2822U/2K5 ,SpeedPlus Dual Wideband, Low-Noise Operational AmplifierThermal CharacteristicsDifferential Input Voltage ... ±1.2VElectrostatic discharge can cause damage ..
OPA2827 ,Brown Corporation - Low-Noise, High-Precision, JFET-Input, OPERATIONAL AMPLIFIER
OPA2830 ,Low-Power / Single-Supply / Wideband Operational AmplifierFEATURES DESCRIPTION2• HIGH BANDWIDTH:The OPA2830 is a dual, low-power, single-supply,230MHz (G = + ..
OPA2830 ,Low-Power / Single-Supply / Wideband Operational AmplifierELECTRICAL CHARACTERISTICS: V = ±5VSBoldface limits are tested at +25C.At T = +25°C, G = +2V/V, R = ..
OPA2830ID ,Dual, Low-Power, Single-Supply Wideband Operational Amplifier 8-SOIC -40 to 85This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated cir ..
OPA2830IDG4 ,Dual, Low-Power, Single-Supply Wideband Operational Amplifier 8-SOIC -40 to 85ELECTRICAL CHARACTERISTICS: V = ±5VSBoldface limits are tested at +25C.At T = +25°C, G = +2V/V, R = ..
P6SMB33AT3 ,High Power Transient SuppressorMAXIMUM RATINGSRating Symbol Value UnitPeak Power Dissipation (Note 1.) @ T = 25°C, Pulse Width = 1 ..
P6SMB33AT3G , 600 Watt Peak Power Zener Transient Voltage Suppressors
P6SMB33CA ,BI-DIRECTIONAL GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS, 6.8 THRU 200 VOLTS3PEAK PULSE DERATING IN % OFP , PEAK POWER (kW)PPEAK POWER OR CURRENT @ = 25 T ° CAVALUE (%)P6SMB1 ..
P6SMB33CA ,BI-DIRECTIONAL GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS, 6.8 THRU 200 VOLTSELECTRICAL CHARACTERISTICSI(T = 25°C unless otherwise noted)AIPPSymbol ParameterI Maximum Reverse P ..
P6SMB350A , Surface mount unidirectional and bidirectional Transient Voltage Suppressor Diodes
P6SMB350A , Surface mount unidirectional and bidirectional Transient Voltage Suppressor Diodes
OPA2822E/250-OPA2822E/2K5-OPA2822U-OPA2822U/2K5
SpeedPlus Dual Wideband, Low-Noise Operational Amplifier
OPA2822SBOS188E – MARCH 2001 – REVISED AUGUST 2008
DESCRIPTIONThe OPA2822 offers very low 2.0nV/√Hz input noise in a
wideband, unity-gain stable, voltage-feedback architecture.
Intended for xDSL receiver applications, the OPA2822 also
supports this low input noise with exceptionally low harmonic
distortion, particularly in differential configurations. Adequate
output current is provided to drive the potentially heavy load
of a passive filter between this amplifier and the codec.
Harmonic distortion for a 2VPP differential output operating
from +5V to +12V supplies is ≤ –100dBc through 1MHz input
frequencies. Operating on a low 4.8mA/ch supply current,
the OPA2822 can satisfy all xDSL receiver requirements
over a wide range of possible supply voltages—from a single
+5V condition, to ±5V, up to a single +12V design.
General-purpose applications on a single +5V supply will
benefit from the high input and output voltage swing available
on this reduced supply voltage. Low-cost precision integra-
tors for PLLs will also benefit from the low voltage noise and
offset voltage. Baseband I/Q receiver channels can achieve
almost perfect channel match with noise and distortion to
support signals through 5MHz with > 14-bit dynamic range.
FEATURES LOW INPUT NOISE VOLTAGE: 2.0nV/√Hz HIGH UNITY GAIN BANDWIDTH: 500MHz HIGH GAIN BANDWIDTH PRODUCT: 240MHz HIGH OUTPUT CURRENT: 90mA SINGLE +5V TO +12V OPERATION LOW SUPPLY CURRENT: 4.8mA/ch
Dual, Wideband, Low-Noise
Operational Amplifier
APPLICATIONS xDSL DIFFERENTIAL LINE RECEIVERS HIGH DYNAMIC RANGE ADC DRIVERS LOW NOISE PLL INTEGRATORS TRANSIMPEDANCE AMPLIFIERS PRECISION BASEBAND I/Q AMPLIFIERS ACTIVE FILTERS
OPA2822 RELATED PRODUCTSPlease be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
www.ti.com
