OPA2690IDR ,Dual Wideband, Voltage Feedback Operational Amplifier with Disable SBOS238G –JUNE 2002–REVISED MARCH 2010
OPA2690IDRG4 ,Dual Wideband, Voltage Feedback Operational Amplifier with Disable 8-SOIC -40 to 85This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated cir ..
OPA2691 ,Dual Wideband Current Feedback Operational Amplifier,with Disablefeatures makes theSINGLES DUALS TRIPLESOPA2691 an ideal RGB line driver or single-supply Analog-to- ..
OPA2691 ,Dual Wideband Current Feedback Operational Amplifier,with Disable SBOS224D – DECEMBER 2001 – REVISED JULY 2008Dual Wideband, Current-FeedbackOPERATIONAL AMPLIFIER W ..
OPA2691 ,Dual Wideband Current Feedback Operational Amplifier,with DisableMAXIMUM RATINGS PIN CONFIGURATIONSPower Supply ....... ±6.5VDC Top View SO-8(2)Internal Power Dissi ..
OPA2691I-14D ,Dual Wideband Current Feedback Operational Amplifier,with DisableMaximum Ratings”may cause permanent damage to the device. Exposure to absolute maximumconditions fo ..
P6SMB120CA , SURFACE MOUNT BI-DIRECTIONAL GLASS PASSIVATED JUNCTION SILICON TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS
P6SMB120CA , SURFACE MOUNT BI-DIRECTIONAL GLASS PASSIVATED JUNCTION SILICON TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS
P6SMB12A ,UNI-DIRECTIONAL GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS, 6.8 THRU 200 VOLTSMAXIMUM RATINGSRating Symbol Value UnitPeak Power Dissipation (Note 1.) @ T = 25°C, Pulse Width = 1 ..
P6SMB12AT3G , 600 Watt Peak Power Zener Transient Voltage Suppressors
P6SMB12CA ,BI-DIRECTIONAL GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS, 6.8 THRU 200 VOLTS2P6SMB11CAT3 Series100PULSE WIDTH (t) IS DEFINED ASPNONREPETITIVETHAT POINT WHERE THE PEAKt ≤ 10 μs ..
P6SMB12CA ,BI-DIRECTIONAL GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR 600 WATTS, 6.8 THRU 200 VOLTSELECTRICAL CHARACTERISTICS (Devices listed in bold, italic are ON Semiconductor Preferred devices.) ..
OPA2690-OPA2690I-14D-OPA2690I-14DR-OPA2690I-14DRG4-OPA2690ID-OPA2690IDG4-OPA2690IDR-OPA2690IDRG4
Dual Wideband, Voltage Feedback Operational Amplifier with Disable
+5V
0.1Fm
+5V
+2.5V
2kW100W
100pF
2kW
-100 10 20
3rd-Harmonic
OPA2690
www.ti.com SBOS238G –JUNE 2002–REVISED MARCH 2010
Dual, Wideband, Voltage-Feedback
OPERATIONAL AMPLIFIER with Disable
Checkfor Samples: OPA2690
1FEATURES DESCRIPTION FLEXIBLE SUPPLY RANGE: The OPA2690 representsa major step forwardin
+5Vto +12V Single Supply unity-gain stable, voltage-feedback op amps.A new
±2.5Vto ±6V Dual Supply internal architecture provides slew rate and full-power
bandwidth previously found only in wideband,
• WIDEBAND +5V OPERATION: 220MHz(G=2) current-feedback op amps. A new output stage
• HIGH OUTPUT CURRENT: 190mA architecture delivers high currents witha minimal
• OUTPUT VOLTAGE SWING: ±4.0V headroom requirement. These give exceptional
single-supply operation. Usinga single +5V supply,
• HIGH SLEW RATE: 1800V/ms the OPA2690 can delivera 1Vto 4V output swing
• LOW SUPPLY CURRENT: 5.5mA/ch with over 120mA drive current and 150MHz
• LOW DISABLE CURRENT: 100mA/ch bandwidth. This combinationof features makes the
OPA2690 an ideal RGB line driveror single-supply
APPLICATIONS Analog-to-Digital Converter (ADC) input driver.
VIDEO LINE DRIVING The low 5.5mA/ch supply currentof the OPA2690is
• xDSL LINE DRIVER/RECEIVER precisely trimmedat +25°C. This trim, along with low
temperature drift, provides lower maximum supply
• HIGH-SPEED IMAGING CHANNELScurrent than competing products. System power may
• ADC BUFFERS be reduced further using the optional disable control
• PORTABLE INSTRUMENTS pin. Leaving this disable pin open,or holdingit HIGH,
• TRANSIMPEDANCE AMPLIFIERS will operate the OPA2690I-14D normally.If pulled
ACTIVE FILTERS LOW, the OPA2690I-14D supply current dropsto less
than 200mA/ch while the output goes to a
Single-Supply Differential ADC Driver high-impedance state.
OPA2690 RELATED PRODUCTS
