OPA2613IDRG4 ,Dual Wideband, High-Output Current, Operational Amplifier with Current Limit 8-SOIC -40 to 85ELECTRICAL CHARACTERISTICS: V = ±6V (continued)SBoldface limits are tested at +25°C.R = 402Ω , R = ..
OPA2614 ,Dual, High Gain Bandwidth, High Output Current, Operational Amplifier with Current LimitThermal Characteristics recommends that all integrated circuits be handled with appropriateprecauti ..
OPA2614ID ,Dual, High Gain Bandwidth, High Output Current, Operational Amplifier with Current LimitELECTRICAL CHARACTERISTICS: V = ±6V (continued)SBoldface limits are tested at +25°C.R = 453Ω , R = ..
OPA2614ID ,Dual, High Gain Bandwidth, High Output Current, Operational Amplifier with Current LimitFEATURES SINGLES DUALS TRIPLESUnity-Gain Stable OPA2613 DESCRIPTIONHigh Slew Rate VFB OPA690 OPA ..
OPA2614IDRG4 ,Dual, High Gain Bandwidth, High Output Current, Operational Amplifier with Current Limit 8-SOIC -40 to 85ELECTRICAL CHARACTERISTICS: V = ±6V SBoldface limits are tested at +25°C.R = 453Ω , R = 100Ω , an ..
OPA2652 ,Dual, 700MHz, Voltage-Feedback OPERATIONAL AMPLIFIEROPA2652 * * * OPA2652SBOS125A–JUNE 2000–REVISED MAY 2006TMDual, 70 ..
P6KE6.8ARLG , 600 Watt Peak Power Surmetic-40 Transient Voltage Suppressors
P6KE6.8CA ,600w Transient Voltage SuppressorMAXIMUM RATINGSDevice Package ShippingRating Symbol Value UnitP6KExxxCA Axial Lead 1000 Units/BoxPe ..
P6KE6.8CA ,600w Transient Voltage Suppressor
P6KE6.8CA ,600w Transient Voltage Suppressor
P6KE6.8CA ,600w Transient Voltage Suppressor3P6KE6.8CA Series100°NONREPETITIVEPULSE WAVEFORMSHOWN IN FIGURE 3101008060140200.100 25 50 75 100 1 ..
P6KE62A ,600 WATT PEAK POWER TRANSIENT VOLTAGE SUPPRESSORSELECTRICAL CHARACTERISTICS (T = 25°C unlessA Iotherwise noted, V = 3.5 V Max. @ I (Note 6.) = 50 A) ..
OPA2613-OPA2613ID-OPA2613IDRG4
Dual Wideband, High-Output Current, Operational Amplifier with Current Limit
FEATURES�
LOW INPUT NOISE VOL TAGE: 1.8nV/√Hz HIGH UNITY-GAIN BANDWIDTH: 230MHz HIGH GAIN BANDWIDTH PRODUCT: 125MHz HIGH OUTPUT CURRENT : 350mA LOW INPUT OFFSET VOLTAGE: ±0.2mV FLEXIBLE SUPPLY RANGE:
Single +5V to +12V Operation
Dual ±2.5V to ±6V Operation LOW SUPPLY CURRENT: 6.0mA/ch
DESCRIPTIONThe OPA2613 offers very low 1.8nV√Hz input noise in a
wideband, unity-gain stable, voltage-feedback
architecture. Intended for xDSL driver applications, the
OPA2613 also supports this low input noise with
exceptionally low harmonic distortion, particularly in
differential configurations. Adequate output current is
provided to drive the potentially heavy load of a
twisted-pair line. Harmonic distortion for a 2VPP differential
output operating from +5V to +12V supplies is ≤ −95dBc
through 1MHz input frequencies. Operating on a low
6.0mA/ch supply current, the OPA2613 can satisfy most
xDSL driver requirements over a wide range of possible
supply voltagefrom a single +5V condition, to ±5V, on up
to a single +12V design.
General-purpose applications on a single +5V supply will
benefit from the high input and output voltage swing
available on this reduced supply voltage. Low-cost
precision integrators for PLLs will also benefit from the low
voltage noise and offset voltage. Baseband I/Q receiver
channels can achieve almost perfect channel match with
noise and distortion to support signals through 5MHz with
> 14-bit dynamic range.
APPLICATIONS xDSL DIFFERENTIAL LINE DRIVERS 16-BIT ADC DRIVER LOW NOISE PLL INTEGRATORS TRANSIMPEDANCE AMPLIFIERS PRECISION BASEBAND I/Q AMPLIFIERS ACTIVE FILTERS TS613 IMPROVED REPLACEMENT
OPA2613 RELATED PRODUCTS
xDSL Driver
OPA2613
xDSL Receiver500Ω
1kΩ
n:1
A2613SBOS249H − JUNE 2003 − REVISED AUGUST 2008
Dual, Wideband, High Output Current,
Operational Amplifier with Current Limit
