NX5DV330DS ,Quad 1-of-2 video multiplexer/demultiplexerFeaturesn 5 Ω switch connection between two portsn TTL-compatible input levelsn Minimal propagation ..
NX5DV715HF ,Dual supply 1-of-2 VGA switchApplications Notebook Computers Docking stations Digital projectors Computer monitors Servers ..
NX6035SA , Crystal Units For Mobile Communications
NX6410GH , LASER DIODE 1 490 nm InGaAsP MQW-DFB LASER DIODE FOR 2.5 Gb/s FTTH PON APPLICATION
NX7002AK ,60 V, single N-channel Trench MOSFETApplications• Relay driverHigh-speed line driver•• Low-side loadswitchSwitching circuits•4. Quick r ..
NX7002AKS ,60 V, dual N-channel Trench MOSFETApplications Relay driver Low-side load switch High-speed line driver Switching circuits1.4 Qui ..
P0080SAMCL , gas plasma arresters-package dimensions/specifications
P0080SAMCL , gas plasma arresters-package dimensions/specifications
P0080SB , DO-214AA Package Symbolization
P0080SB , DO-214AA Package Symbolization
P0080SB , DO-214AA Package Symbolization
P0080SBL , gas plasma arresters-package dimensions/specifications
NX5DV330DS
Quad 1-of-2 video multiplexer/demultiplexer
General descriptionThe NX5DV330 is a quad 1-of-2 high-speed TTL-compatible video
multiplexer/demultiplexer. The low ON resistance of the switch allows inputs to be
connected to outputs without adding propagation delay or generating additional ground
bounce noise
It has a digital select input (S), four independent inputs/outputs (nY0, nY1), a common
input/output (nZ) and an active LOW enable input (E). When pin E is HIGH, the switch is
turned off.
Schmitt-trigger actionat the enable input (E) and select input (S) makes the circuit tolerant
to slower input rise and fall times across the entire VCC range from 4.0 V to 5.5 V.
The NX5DV330 is characterized for operation from −40 °Cto+85 °C.
Features5 Ω switch connection between two ports TTL-compatible input levels Minimal propagation delay through the switch ESD protection: HBM JESD22-A114E Class 2A exceeds 2000V MM JESD22-A115-A exceeds 200V CDM JESD22-C101C exceeds 1000V Latch-up testing is done to JEDEC standard JESD78 which exceeds 100 mA
NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer
Rev. 03 — 5 August 2009 Product data sheet
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer Ordering information[1] Also known as QSOP16.
Functional diagram
Table 1. Ordering informationNX5DV330D −40 °Cto+85°C SO16 plastic small outline package; 16 leads;
body width 3.9 mm
SOT109-1
NX5DV330DS −40 °Cto+85°C SSOP16[1] plastic shrink small outline package; 16 leads;
body width 3.9 mm; lead pitch 0.635 mm
SOT519-1
NX5DV330PW −40 °Cto+85°C TSSOP16 plastic thin shrink small outline package; 16 leads;
body width 4.4 mm
SOT403-1
NX5DV330BQ −40 °Cto+85°C DHVQFN16 plastic dual in-line compatible thermal enhanced very
thin quad flat package; no leads; 16 terminals;
body 2.5× 3.5× 0.85 mm
SOT763-1
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer Pinning information
5.1 Pinning
5.2 Pin description
Table 2. Pin description 1 select control input
1Y0, 1Y1, 2Y0, 2Y1, 3Y1, 3Y0, 4Y1, 4Y0 2, 3, 5, 6, 10, 11, 13, 14 independent input or output
1Z, 2Z, 3Z, 4Z 4, 7, 9, 12 independent input or output
GND 8 ground (0V) 15 enable input (active LOW)
VCC 16 positive supply voltage
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer Functional description Limiting values[1] The input and output negative voltage ratings may be exceeded if the input and output clamp current ratings are observed.
[2] For SO16 package: Ptot derates linearly with 8 mW/K above 70°C.
[3] For SSOP16 (QSOP16) and TSSOP16 packages: Ptot derates linearly with 5.5 mW/K above 60°C.
[4] For DHVQFN16 packages: above 60 °C derate linearly with 4.5 mW/K.
Recommended operating conditions
Table 3. Function selection= HIGH voltage level; L= LOW voltage level; X= Don’t care. L Y0 to Z or Z to Y0 H Y1 to Z or Z to Y1 X switch off
Table 4. Limiting valuesIn accordance with the Absolute Maximum Rating System (IEC 60134).
VCC supply voltage −0.5 +7.0 V input voltage [1] −0.5 +7.0 V
ISW switch current continuous current
through each switch 128 mA
IIK input clamping current VI <0V - −50 mA
Tstg storage temperature −65 +150 °C
Ptot total power dissipation [2][3][4]- 500 mW
Table 5. Operating conditionsAll unused control inputs of the device must be held at VCC or GND to ensure proper device operation.
VCC supply voltage 4.0 5.0 5.5 V
VIH HIGH-level input voltage 2.0 - - V
VIL LOW-level input voltage - - 0.8 V hysteresis voltage pin S,E - 45 - mV
Tamb ambient temperature operating in free-air −40 +25 +85 °C
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer Static characteristics[1] All typical values are measured at VCC =5V; Tamb =25°C.
[2] This is the increase in supply current for each input that is at the specified TTL voltage level rather than VCC or GND.
[3] Measured by the voltage drop between the Z and the Y terminals at the indicated current through the switch. ON-state resistance is
determined by the lowest voltage of the two (Z or Y) terminals.
10. Dynamic characteristics
Table 6. Static characteristicsTamb= −40°Cto +85 °C.
VIK input clamping voltage VCC= 4.5 V; II= −18 mA - - −1.2 V input leakage current pin S, E; VCC= 5.5 V; VI= GND or 5.5V - - ±1 μA
IS(OFF) OFF-state leakage current VCC= 5.5 V; VI= GND; VO=0Vto 5.5 V - - ±1 μA
IOFF power-off leakage current VCC= 0 V; VI =VO=0Vto 5.5 V - - ±1 μA
ICC supply current VCC= 5.5 V; IO=0 mA; VI =VCCor GND - - 3 μA
ΔICC additional supply current pin S, E; VCC= 5.5V; one input at 3.4V,
other inputs at VCC or GND
[2]- - 2.5 mA input capacitance pin S, E; VI=5 V or 0V - 3.5 - pF
Cio(off) off-state input/output
capacitance
Z port; VCC =5V; VO =5V or 0V; E=VCC - 6.0 - pF
Y port; VCC =5V; VO=5 V or 0V; E=VCC - 4.0 - pF
Cio(on) on-state input/output
capacitance
Z port; VCC =5V; VO =5V or 0V;E= GND - 14 - pF
RON ON resistance VCC= 4.5V [3]= 1.0 V; II =13mA - 3 7 Ω= 2.0 V; II =26mA - 7 10 Ω
Table 7. Dynamic characteristicsTamb= −40°Cto +85 °C; for test circuit see Figure7.
ton turn-on time S to nZ; see Figure6
VCC= 4.5 V to 5.5V - 4.0 6.0 ns
toff turn-off time S to nZ; see Figure6
VCC= 4.5 V to 5.5V - 2.3 6.0 ns
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer
11. Waveforms
Table 8. Measurement points4.5 V to 5.5 V GND to 3.0 V 1.5 V 0.9VOH
Table 9. Test dataGND to 3.0 V ≤ 10 MHz ≤ 2.5 ns GND to 3.0 V 3.0 V to GND 75Ω 20pF
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer
12. Additional dynamic characteristics[1] All unused analog input pins (nZ) and outputs pins (nYn) are connected through 10 Ω and 50 Ω pull-down resistors, respectively.
13. Test circuits
Table 10. Additional dynamic characteristicsAt recommended operating conditions; voltages are referenced to GND (ground=0 V); VI = GND or VCC (unless otherwise
specified); Tamb = 25 °C; VCC= 4.5 V to 5.5V.
Gdif differential gain fi= 3.58 MHz;RL= 150Ω - 0.64 - %
ϕdif differential phase fi= 3.58 MHz;RL= 150Ω - 0.1 - deg
f(−3dB) −3 dB frequency response RL= 150 Ω; see Figure8 300 - - MHz
αiso isolation (OFF-state) fi=10 MHz; RL= 150 Ω; see Figure9 - −60 - dB
Xtalk crosstalk between switches; see Figure 10;=10 MHz;RL= 150 Ω;Ri = 10Ω
[1] - −63 - dB
NXP Semiconductors NX5DV330
Quad 1-of-2 video multiplexer/demultiplexer
