NCP5425DBR2 ,Dual Synchronous Buck Controller35 V/12 VVin RTND4n/aR11D1 & 2C110BAV99LT11.0 FC195 V/12 VC1610 F/ R23C5 C2 C1 C22C17 C18 C616 Vn ..
NCP5425DBR2G , Dual Synchronous Buck Controller
NCP5426SN13T1 ,LDO Regulator/Vibration Motor DriverELECTRICAL CHARACTERISTICS (T = 25°C, for min/max values T is the operating junction temperature t ..
NCP5426SN13T1 ,LDO Regulator/Vibration Motor DriverFeatures• Wide Operating Voltage Range to 12 V• Internally Set Output VoltagesPIN CONNECTIONS AND• ..
NCP5426SN13T1G , LDO Regulator/Vibration Motor Driver
NCP5426SN13T2 ,LDO Regulator/Vibration Motor Driver2NCP542620 1.4V = 3.5 Vin16V = 2.5 Ve 1.212 V = 1.3 VoutC = 1.0 Fout1.0840.800.6−4−80.4V = 3.5 Vin ..
NJM360 , HIGH SPEED DIFFRENTIAL COMPARATOR
NJM360D , HIGH SPEED DIFFRENTIAL COMPARATOR
NJM3717FM2 , STEPPER MOTOR DRIVER
NJM3770AFM2 , STEPPER MOTOR DRIVER
NJM3771D2 , DUAL STEPPER MOTOR DRIVER
NJM3771FM2 , DUAL STEPPER MOTOR DRIVER
NCP5425DBR2
Dual Synchronous Buck Controller
NCP5425DEMO/D
NCP5425 Demonstration
Board Note
Single Input to Dual Output
Buck Regulator
5.0 V to 1.5 V/15 A and 1.8 V/15 A
DescriptionThe NCP5425 demonstration board is a 4.0″ by 4.0″,
two−layer printed circuit board with an actual circuit area of
2.5″ by 2.3″. This demonstration circuit can be used to
evaluate the performance and functionality of NCP5425,
configured to generate a 1.5 V and 1.8 V output from a
single input voltage (5.0 V). Each output is capable of
delivering 15 A. Both the controller VCC and the switching
FET input power are powered by the single 5.0 V power
supply.
The NCP5425 controller contains all the circuitry
required for a Dual Output Buck Regulator, including
undervoltage lockout, soft−start, adaptive FET
non−overlap, cycle−by−cycle overcurrent protection and a
low noise disable mode.
Features Dual Synchronous Buck Topology Out−Of−Phase Synchronization between Channels Cycle−by−Cycle Overcurrent Protection Undervoltage Lockout Low Noise Disable Mode
