NBSG16BA ,2.5 V/3.3 V SiGe Differential Receiver/Driver with RSECL OutputsEVALUATION BOARD MANUALDESCRIPTIONThis document describes the NBSG16/16VS evaluation What measureme ..
NBSG16VSMNG , 2.5V/3.3V SiGe Differential Receiver/Driver with Variable Output Swing
NBSG53AMNG , 2.5V/3.3V SiGe Selectable Differential Clock and Data D Flip−Flop/Clock Divider with Reset and OLS
NBSG72AMNG ,2.5V/3.3VSiGe Differential 2 X 2 Crosspoint Switch with Output Level Selecta part of the GigaComm family of high performance SiliconGermanium products. The device is housed ..
NBSG86ABA ,2.5 V/3.3 V SiGe Differential Smart Gate with Output Level SelectEVALUATION BOARD MANUALDESCRIPTIONThis document describes the NBSG86A evaluation board What measure ..
NBSG86AMNG , 2.5V/3.3V SiGe Differential Smart Gate with Output Level Select
NJM2116 , ULTRA WIDE BAND & HIGH SLEWRATE HEX OPERATIONAL AMPLIFIER
NJM2118 , MONAURAL MICROPHONE AMPLIFIER
NJM2118M , MONAURAL MICROPHONE AMPLIFIER
NJM2118V , MONAURAL MICROPHONE AMPLIFIER
NJM2119 , DUAL SINGLE-SUPPLY OPERATIONAL AMPLIFIER
NJM2120L , SWITCHING OPERATIONAL AMPLIFIER
NBSG16BA
2.5 V/3.3 V SiGe Differential Receiver/Driver with RSECL Outputs
NBSG16BAEVB,
NBSG16VSBAEVB
Evaluation Board Manual
for NBSG16 and NBSG16VS
DESCRIPTIONThis document describes the NBSG16/16VS evaluation
board and the appropriate lab test setups. It should be used
in conjunction with the NBSG16/16VS data sheets which
contain full technical details on the device specifications and
operation. The same PCB is used to evaluate both devices.
The evaluation board is designed to facilitate a quick
evaluation of the NBSG16/16VS GigaComm� Differential
Receiver/Driver. The NBSG16 is designed to function as a
high speed receiver/driver device with a reduced output
swing capability suitable for use in high speed signal
amplification and backplane interface applications. The
Reduced Swing ECL (RSECL) output ensures minimal
noise and fast switching edges. The NBSG16VS has the
option to vary the output amplitude swing (additional
VCTRL modulation pin, labeled VS on evaluation board).
The evaluation board is implemented in two layers for
higher performance. For standard lab setup and test, a split
(dual) power supply is required enabling the 50 ohm
impedance in the scope to be used as termination of the ECL
signals (VTT = VCC – 2.0 V , in split power supply setup, VTT
is the system ground).
What measurements can you expect to make?With this evaluation board, the following measurements
could be performed in single-ended
of operation: Jitter Output Skew Gain/Return Loss Eye Pattern Generation Frequency Performance Output Rise and Fall Time VIHCMR (Input High Common Mode Range) Single-
VCC - VEE = 3.3 V using this board setup.
