MUN2112T3 ,Bias Resistor Transistor PNPELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)ACharacteristic Symbol Min Typ Max Unit ..
MUN2113 ,Bias Resistor TransistorELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)ACharacteristic Symbol Min Typ Max Unit ..
MUN2113T1 ,Bias Resistor TransistorMAXIMUM RATINGS (T = 25°C unless otherwise noted)AMARKING DIAGRAMRating Symbol Value UnitCollector− ..
MUN2113T1 ,Bias Resistor TransistorTHERMAL CHARACTERISTICSThermal Resistance — Junction–to–Ambient (surface mounted) R 625 °C/WθJAOper ..
MUN2113T1G ,Bias Resistor TransistorELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)ACharacteristic Symbol Min Typ Max Unit ..
MUN2114T1 ,PNP SILICON BIAS RESISTOR TRANSISTORhttp://onsemi.com3MUN2111T1 Series
NBSG11MNG , 2.5V/3.3V SiGe 1:2 Differential Clock Driver with RSECL Outputs
NBSG11MNG , 2.5V/3.3V SiGe 1:2 Differential Clock Driver with RSECL Outputs
NBSG14MNG , 2.5V/3.3V SiGe Differential 1:4 Clock/Data Driver with RSECL Outputs
NBSG16BA ,2.5 V/3.3 V SiGe Differential Receiver/Driver with RSECL OutputsEVALUATION BOARD MANUALDESCRIPTIONThis document describes the NBSG16/16VS evaluation What measureme ..
NBSG16VSMNG , 2.5V/3.3V SiGe Differential Receiver/Driver with Variable Output Swing
NBSG53AMNG , 2.5V/3.3V SiGe Selectable Differential Clock and Data D Flip−Flop/Clock Divider with Reset and OLS
MUN2112T3
Bias Resistor Transistor PNP
PIN3
COLLECTOR
(OUTPUT)
PIN1
EMITTER
(GROUND)
PIN2
BASE
(INPUT) -
PNP Silicon Surface Mount Transistor with
Monolithic Bias Resistor NetworkThis new series of digital transistors is designed to replace a single device and its
external resistor bias network. The BRT (Bias Resistor Transistor) contains a single
transistor with a monolithic bias network consisting of two resistors; a series base
resistor and a base–emitter resistor. The BRT eliminates these individual components
by integrating them into a single device. The use of a BRT can reduce both system
cost and board space. The device is housed in the SC–59 package which is designed
for low power surface mount applications. Simplifies Circuit Design Reduces Board Space Reduces Component Count The SC–59 package can be soldered using wave or reflow.
The modified gull–winged leads absorb thermal stress during
soldering eliminating the possibility of damage to the die. Available in 8 mm embossed tape and reel
Use the Device Number to order the 7 inch/3000 unit reel.
MAXIMUM RATINGS (TA = 25°C unless otherwise noted)
THERMAL CHARACTERISTICS
DEVICE MARKING AND RESISTOR VALUES Device mounted on a FR–4 glass epoxy printed circuit board using the minimum recommended footprint. New devices. Updated curves to follow in subsequent data sheets.
Thermal Clad is a trademark of the Bergquist Company
Order this document
by MUN2111T1/D-
SEMICONDUCTOR TECHNICAL DATA
