MTB20N20E ,TMOS POWER FET 20 AMPERES 200 VOLTSELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
MTB23P06 ,TMOS POWER FET 23 AMPERES 60 VOLTSELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
MTB29N15ET4 ,Power MOSFET 29 Amps, 150 Volts3R , DRAIN-TO-SOURCE RESISTANCE R , DRAIN-TO-SOURCE RESISTANCE (OHMS) I , DRAIN CURRENT (AMPS)DS(on ..
MTB2N40E ,TMOS POWER FET 2.0 AMPERES 400 VOLTSELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
MTB30P06 ,TMOS POWER FET 30 AMPERES 60 VOLTSELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)JCharacteristic Symbol Min Typ Max Unit ..
MTB30P06V ,Power MOSFET 30 Amps, 60 Voltselectrical characteristics apply to operation atallows code to be written before hardware design is ..
N82HS195BN , PHILIPS COMPONENTS-SIGNETICS
N82HS195BN , PHILIPS COMPONENTS-SIGNETICS
N82S23N ,256-bit TTL bipolar PROM 32 x 8
N8344AH , SDLC Communications Controller
N83C196KB , COMMERCIAL/EXPRESS CHMOS MICROCONTROLLER
N83C198 , COMMERCIAL/EXPRESS CHMOS MICROCONTROLLER
MTB20N20E
TMOS POWER FET 20 AMPERES 200 VOLTS
-- - " ! --
N–Channel Enhancement–Mode Silicon GateThe D2PAK package has the capability of housing a larger die
than any existing surface mount package which allows it to be used
in applications that require the use of surface mount components
with higher power and lower RDS(on) capabilities. This advanced
TMOS E–FET is designed to withstand high energy in the
avalanche and commutation modes. The new energy efficient
design also offers a drain–to–source diode with a fast recovery
time. Designed for low voltage, high speed switching applications in
power supplies, converters and PWM motor controls, these
devices are particularly well suited for bridge circuits where diode
speed and commutating safe operating areas are critical and offer
additional safety margin against unexpected voltage transients. Avalanche Energy Specified Source–to–Drain Diode Recovery Time Comparable to a
Discrete Fast Recovery Diode Diode is Characterized for Use in Bridge Circuits IDSS and VDS(on) Specified at Elevated Temperature Short Heatsink Tab Manufactured — Not Sheared Specially Designed Leadframe for Maximum Power Dissipation Available in 24 mm 13–inch/800 Unit Tape & Reel, Add T4
Suffix to Part Number
MAXIMUM RATINGS (TC = 25°C unless otherwise noted)
Designer’s Data for “Worst Case” Conditions — The Designer’s Data Sheet permits the design of most circuits entirely from the information presented. SOA Limitcurves — representing boundaries on device characteristics — are given to facilitate “worst case” design.
E–FET and Designer’s are trademarks of Motorola, Inc. TMOS is a registered trademark of Motorola, Inc.
Thermal Clad is a trademark of the Bergquist Company.
