ML4823CQ ,High Frequency Power Supply ControllerMay 1997ML4823High Frequency Power Supply Controller
ML4823IP ,High frequency power supply controllerMay 1997ML4823High Frequency Power Supply Controller
ML4823IS ,High Frequency Power Supply Controllerfeatures not found on the 3823. These
ML4824CP1 ,Power Factor Correction (PFC) and PWM Controller ComboGeneral Description• Internally synchronized PFC and PWM in one IC The ML4824 is a controller for p ..
ML4824CP-1 ,Power Factor Correction and PWM Controller ComboFEATURESThe ML4824 is a controller for power factor corrected, Internally synchronized PFC and PWM ..
ML4824CP2 ,Power Factor Correction (PFC) and PWM Controller ComboBlock Diagram16 1 13IEAO POWER FACTOR CORRECTOR VVEAOCCVCCZOVPVV REFVEAFB 13.5V7.5V+IEA143.5kΩ15 –R ..
MMBF0202PLT1G ,Power MOSFET 300 mAmps, 20 VoltsELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)ACharacteristic Symbol Min Typ Max Unit ..
MMBF102 ,N-Channel RF Amplfiier
MMBF102 ,N-Channel RF Amplfiier
MMBF170 ,N-Channel Enhancement Mode Field Effect TransistorFeaturesYEfficient high density cell design approachingTheseN-channelenhancementmodefieldeffecttran ..
MMBF170LT1 ,TMOS FET TransistorELECTRICAL CHARACTERISTICS (T = 25°C unless otherwise noted)CCharacteristic Symbol Min Max UnitOFF ..
MMBF170LT1G ,Power MOSFET 500 mAmps, 60 VoltsMAXIMUM RATINGSR = 5 Rating Symbol Value UnitDS(on)Drain−Source Voltage V 60 VdcDSSN−ChannelDrain− ..
ML4823CQ
High Frequency Power Supply Controller
May 1997
ML4823
High Frequency Power Supply Controller
FEATURES Practical operation at switching frequencies to 1.0MHz High current (2A peak) totem pole output Wide bandwidth error amplifier Fully latched logic with double pulse suppression Pulse-by-pulse current limiting Soft start and max. duty cycle control Under voltage lockout with hysteresis 5.1V trimmed bandgap reference Low start-up current (1.1mA) Pin compatible improved replacement for UC3823 Fast shut down path from current limit to output Soft start latch ensures full soft start cycle Outputs pull low for undervoltage lockout
GENERAL DESCRIPTION
The ML4823 High Frequency PWM Controller is an IC
controller optimized for use in Switch Mode Power
Supply designs running at frequencies to 1MHz.
Propagation delays are minimal through the comparatorsand logic for reliable high frequency operation while slew
rate and bandwidth are maximized on the error amplifier.
This controller is designed for single-ended applications
using voltage or current mode and provides for input
voltage feed forward.
A 1V threshold current limit comparator provides cycle-
by-cycle current limit and exceeding a 1.4V threshold
initiates a soft-start cycle. The soft start pin doubles as a
maximum duty cycle clamp. All logic is fully latched toprovide jitter-free operation and prevent multiple pulsing.
An under-voltage lockout circuit with 800mV of hysteresis
assures low startup current and drives the outputs low
during fault conditions.
This controller is an improved second source for the
UC3823 controller; however, the ML4823 includes
features not found on the 3823. These features are set in
italics.
BLOCK DIAGRAM (Pin Configuration Shown for 16-Pin Version)
